QualGear QG-AM-017 User manual

3
Choose the appropriate screws (M-A/ M-B/ M-C/ M-D/ M-E), washers (M-F/ M-G/ M-H),
and spacers (M-I) if necessary, according to the type of your TV mount. Attach the
Apple TV Wall Mount to the TV Wall Mount using a Phillips screwdriver.

IMPORTANT! Please read the entire installation manual and check that all parts are
included before you start installation and assembly.
1 2
Hardware Package
Two Installation Options
ST3.5x25mm Screw (x4)
W-A
Φ6x28mm
Concrete Anchor (x4)
W-B
M3x14mm (x1)
M-A
M4x14mm (x1)
M-B
M5x14mm (x1)
M-C
M6x14mm (x1)
M-D
3mm
Small Spacer (x3)
M-I
D8 Washer (x1)
M-H
D5 Washer (x1)
M-G
D3 Washer (x1)
M-F
M8x20mm (x1)
M-E
Mount to a wall surface
Apple TV
See Step 1a or 1b
Attach to a TV wall mount
See Step 2
1 2
Mounting to a Wooden Stud Wall
1a
Mounting to a Concrete or a Brick Wall
1b
NOTE For concrete or brick wall mounting,
see Step 1b. To attach to a TV
wall mount, see Step 2.
Using an edge-to-edge stud finder, find
the edges of the stud.
Using a level, mark the centerline of
the stud.
3
Using the wall mount as a template,
mark four holes for drilling on the
centerline of the stud.
Using a power drill and 5/64" drill bit, drill pilot holes of
5/64" (2mm) diameter and at least 1" (25 mm) depth.
ø 2mm
25mm
25mm
(1")
(1")
(ø 5/64")
4
Using a Phillips screwdriver, mount the wall mount
and fasten with the provided screws (W-A).
W-A
Using a power drill and 1/4" drill bit, drill pilot holes of
1/4" (6mm) diameter and at least 1.1" (28 mm) depth.
4
Place concrete anchors (W-B) in each hole. Tap each anchor
flush with the wall using a hammer. Mount the wall mount
and fasten screws (W-A) using a Phillips screwdriver.
ø 6mm
28mm
(1.1")
(ø 1/4")
28mm
(1.1")
3
W-A
W-B
1
Use the wall mount as a template, place it against the
wall where you want to install the TV.
2
Level the wall mount and mark four holes for drilling.
Wall Mount
5
Stud Finder
Wall Mount