Queclink GV320 User manual

GV320 Quick Start
Page 1 : Basic Operation
Find
Close the case
Find “PL2303_Prolific_DriverInstaller_v10518.zip”
in develop suit and install the drive for PL2303. If
you have already installed it please go to Step 6.
Open the case
Check Parts List
Install SIM Card
To mini USB To
The USB Data_Cable_M is
not in the delivery list.
Please contact your vendor
for it.
Connect GV320 to computer by
USB Data_Cable_M.
“Queclink GV320 Manager Tool
triangular-pry-opener
Install the battery Switch ON Battery
Before the first time using GV320,
please full charge the battery.
Queclink
Confidential

Page 2 : PC Manager Tool Quick Start
After these steps. GV320 will have some
basic tracking functions like scheduled
timing report and Geo-Fence. For other
advanced functions of GV320 please
refer to “GV320 @Tracker Air Interface
Protocol” or visit our website.
Run manager tool. Select correct Com port and
input default password “gv320”. Then press OK.
If you want to test the GV320 by SMS then set “Report
Mode” to “SMS” and input the phone number which
you want to receive the SMS from GV320. After that
you can go to Step 6.
Otherwise please go to Step 3
Set “Report Mode” to “TCP Short Connection”. input
the IP address and port number of the backend
server. Please make sure the IP address can be
accessed by internet and the data sends to this
address can be received.
Please contact your SIM card provider and get the
APN information for GPRS. Input it in GTBSI
setting.
Press the “Send” button and update the
parameters of GV320. Then the GV320 can
report information to your backend server or
SMS receiver.
Note: These commands can also be sent to
GV320 by SMS.
Command has been accepted when you see the
success window.
Set the parameters of scheduled fixed timing
report so that the GV320 will report it’s position
to backend server period periodically. Press
“Send” button to update the parameters.
Follow screen shot shows how to configure the
GV320 to report it’s position every 3 minutes.
The following screen shot shows how to create a
Geo-Fence rule. Press “Send” button to update the
parameters.
Queclink
Confidential