Queclink GL100 User manual

GL100 Quick Start
Page 1 : Basic
Find “GL100 Manager Tool Ver2.00.exe”
in develop suit and run it to configure
the running parameters of GL100.
Please refer to Page 2 for detail.
Better place the GL100
under the open sky, and let
the surface which has
indication Led to the sky.
Turn On GL100
Find “PL2303_Prolific_DriverInstaller_v10518.zip”
in develop suit and install the drive for PL2303. If
you have already installed it please go to Step 6.
Check The Appearance Check Parts List
Install SIM Card
To mini USB
To computer
Here is GPS Antenna
The USB Data_Cable is
not in the delivery list.
Please contact your
vendor for it.
Power Key
Connect GL100 to computer by USB
Data_Cable.
Before the first time using GL100,
please full charge the battery
Power Key
Function Key
Triple-Color
LED2
SIM Card Interface
Mini USB Interface
Triple-Color
LED1

Page 2 : PC Manager Tool Quick Start
After these steps. GL100 will have some
basic tracking functions like scheduled
timing report and Geo-Fence. For other
advanced functions of GL100 please
refer to “GL100 @Track Air Interface
Protocol” or visit our website
Queclink Wireless Solutions
Website : http://www.queclink.com
Email : [email protected]
Run manager tool. Select correct Com port and
input default password “gl100”. Then press OK.
If you want to test the GL100 by SMS then set “Report
Mode” to “Force on SMS” and input the phone
number which you want to receive the SMS from
GL100. After that you can go to Step 6.
Otherwise please go to Step 3
Set “Report Mode” to “TCP Short Connection”. input
the IP address and port number of the backend
server. Please make sure the IP address can be
accessed by internet and the data sends to this
address can be received.
Please contact your SIM card provider and get the
APN information for GPRS. Input it to the “GPRS
Setting”
Press the “Send” button and update the
parameters of GL100. Then the GL100 can
report information to your backend server or
SMS receiver.
Note: This command can also be sent to
GL100 by SMS.
Command has been accepted when you see the
success window.
Set the parameters of scheduled fixed timing
report so that the GL100 will report it’s position
to backend server period periodically. Press
“Send” button to update the parameters.
Follow screen shot shows how to configure the
The following screen shot shows how to create a
Geo-Fence rule. Press “Send” button to update the
parameters.