Quest Engineering Q100 User manual
Canopy Set Up Instructions
Canopy Parts List
1. 12x12 Instant Up Canopy Top (1)
2. 12x12 Instant Up Canopy Frame (1)
3. 12x12 Instant Up Carry Bag (1)
4. Canopy Stakes (4)
Q100 12x12 Instant Up Canopy
Instruction Manual
1. Remove all parts from the canopy bag. 2. Place the canopy frame in the upright
standing position. Open the frame
partially using the legs.
3. Open the canopy frame using the sides
of the canopy as indicated. The canopy
locations are marked “Open Here”.
5. Secure the canopy top to the canopy
frame on all four corners using the hook
and loop strips.
1. 2. 3.
4. 5. 6.
6. Open the canopy frame until all four
corners lock into place. You should hear a
click when the canopy frame has opened
and the corner has locked.
7. Turn all four sides down to cover the
side of the frame. On the inside of the
canopy, secure all four sides and ceiling
to the canopy frame using the inside
hook and loop strips.
7. 8.
8. Extend all four legs to the desired
preset height. This should be completed
by extending two legs on the same side at
the same time. Once extended to the
appropriate height, the canopy legs will
lock into place.
9. To secure the canopy to the ground, place
one canopy stake in each of the four
pre-drilled holes at the base of the canopy.
The short side of the stake should be touching
the ground. Set up for your Quest 10x10
Instant Up Canopy is now complete.
4. Place the canopy top on the opened
frame.
9.
Canopy Take Down Instructions
Q100 12x12 Instant Up Canopy
Instruction Manual
2. Lower the canopy by pressing the
release button on each leg.
5. Once all four locks are released, unstrap
the canopy top from the canopy frame.
Remove and fold the canopy top. If the top
is wet, allow time to dry before folding.
4. Once lowered, pull the release pins
located at the top of each corner. This will
allow the canopy frame to collapse.
Slightly bring the canopy frame in
creating slack in the canopy top.
1. 2. 3.
4. 5. 6.
6. With the canopy top removed, slowly
begin to close the canopy frame. This
should be done by pressing on the
trusses. Once the canopy frame is nearly
closed, nish closing the frame using the
legs.
7. Place the canopy frame in the carry
bag.
7.
8. Place the canopy top and canopy stakes
inside carry bag and zip the carry bag
closed. Take down for your Quest 10x10
Instant Up Canopy is now complete.
8.
3. Inside the canopy, unstrap all four sides
and ceiling of the canopy top from the
canopy frame.
1. Remove canopy stakes from the ground,
clean off, and place in canopy stake bag.
General Canopy Safety & Guidelines
Water
Your Quest canopy has been treated with a water resistant coating to help keep you dry. This coating is also resistant to Ultraviolet
light, helping to protect you from the sun.
The water resistant coating is intended for use only in light rain conditions. Water collected in the fabric can cause the structure to
collapse causing serious injury or death.
Excessive exposure to the sun can cause deterioration of the fabrics water resistant coating. To prevent this, the canopy should not
be exposed to sunlight for long periods at a time.
Fire
The fabric cover is re retardant and meets the standards of the Industrial Fabric Association International. However, continuous
contact with a ame can cause a re. Do not build res under the canopy.
Fumes
Items creating hazardous fumes should be kept away from the canopy. Use of any product producing fumes in close proximity to
your canopy can result in destruction of the canopy and injury and/or death.
Wind
Quest canopies are made for use in no to light wind. Use of this product in moderate to excessive wind can result in damage to the
canopy and injury and/or death. This product should not be used in conditions with uncertain wind patterns or conditions that
could result in excessive wind.
Storage
To insure maximum use of your Quest canopy, care should be taken when setting up, taking down, and storing the canopy. The
canopy should be stored in a dry environment, secure from pests, re, and other hazardous chemicals.
Let the fabric dry completely before closing or storing to avoid mildew, stains, and mold.
After each use, use a mild soap and plenty of water to clean the fabric. Let the fabric dry completely before storing. It is recom-
mended that you use a seam sealer to prevent leaks along the seams of the fabric. Tighten the bolds on the canopy frame if they
become loose.
General Safety Guidelines
- Use caution when erecting Quest canopy frame. Avoid pinching hands/ngers as frame opens and closes. Gloves can be worn to
help avoid injury.
- Two or more people are required to set up and take down the canopy
- The purpose of this Quest canopy is as a temporary sun shelter
- Do not leave canopy unattended for long periods of time or overnight
- Do not use in inclement weather (storms, excessive wind, excessive water, etc.)
- Exposure to lightning can cause electrocution.
- Keep canopy away from ames, excessive heat, and hazardous fumes
- While in use, secure canopy to the ground using canopy stakes or canopy weight plates
- Wash canopy after each use using directions listed in the storage section
- Avoid using any damaged product
Failure to follow the instructions or safety guidlines can result in damage to your canopy, injury, and/or death. Proper care and safety
can allow you to enjoy many years of benets that your Quest canopy provides.
1-Year Limited Warranty
What this warranty covers:
This Quest product manufactured for Dick’s Sporting Goods, is warranted to be free from defects in material and workmanship for a
period of one year from the date of your original purchase. Dick’s Sporting Goods will, at its option, repair or replace any original part of this
product that is found to be defective under the terms of this warranty. This warranty is only valid for the original retail purchaser of this product
and is not transferable. Keep the original sales receipt. Proof of purchase is required to obtain warranty performance.
What this warranty does not cover:
This warranty does not cover damage due to abuse, misuse, normal wear, excessive wear and tear caused by owners neglect, including
failure to perform routine maintenance, accidents, malfunctions caused by unauthorized alterations, improper installation, use of unauthorized
parts or attachments, lost parts or if used for commercial or rental purposes and acts of nature. This warranty does not cover expendable
This Limited Warranty does not cover any consequential or incidental damages of any kind, including transportation to get warranty service,
loss of time, and loss of use. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above
limitation may not apply to you.
The period of coverage is:
This limited warranty lasts for a period of one year from the date of your original purchase. Any implied warranty arising under state law is
limited in duration to the period of this Limited Warranty. Some states do not allow limitations on how long an implied warranty lasts, so the
limitations may not apply to you.
How you can get service:
Please direct all warranty service inquiries as follows:
If in writing, Mail to: Quest
c/o Dick’s Sporting Goods, Inc.
345 Court Street
Coraopolis, PA 15108
Attention: Customer Service
If by telephone, call 1-866-632-1718
How state Law applies:
This limited Warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS PRODUCT FABRIC
This product meets the flammability requirements of CPAI-84. The fabric may burn if left in continuous contact with
any flame source. The application of any foreign substance to the product fabric may render the flame-resistant properties ineffective.
items,including by way of example only and not by way of limitation: batteries, light bulbs, fuses, zippers, tires, belts, shoe soles,fabric and
other items that experience wear as a result of normal use.
Other Quest Engineering Tent manuals
