Quick Eagle Networks Solo T1 DSU User manual

Quick Eagle’s Solo T1 DSUTM is a full-featured, single port DSU that provides a
versatile, cost-effective interface between high-speed data terminal equipment
(DTE) and public or private T1 networks. It features a software-selectable DTE
interface, which can be configured for RS-449/EIA-530 or V.35. Bandwidth
allocation, also software selectable, allows you to configure the Solo T1 DSU for
data rates from 56 kbps up to a full T1 data rate of 1.536 Mbps.
You can manage the Solo T1 DSU from a Telnet or local VT-100-compatible
terminal. It can also be managed from a management station located at a c
entral site. The Solo T1 DSU supports the industry-standard Simple Network
Management Protocol (SNMP) management information base (MIB II). It also
features a device-specific enterprise MIB that allows you to configure, monitor
and control all significant operating parameters.
The Solo T1 DSU offers an extensive suite of diagnostic capabilities for local
and remote fault analysis, and features more than a dozen user-settable alarm
parameters and performance thresholds for remote alarm reporting.
The Solo T1 DSU
Providing a new level of versatility
for broadband access.
Main Features:
•Fully SNMP-manageable
•Telnet management access via
COMM port
•Alarm dial-out connection for
unattended remote operation
•Extensive diagnostic features:
• Front-panel LEDs
• Built-in test patterns, test
loops, and diagnostic tests
•Non-disruptive downloadable
code for easy upgrades
•Available in stand alone and
chassis-based module versions

Access Speed
Network Interface
Line Rate
Connector Type
Line Code
Framing
Output Level
Input Level
System Timing
Data Interface
Port
Data Rate
Connector Type
Management Connectors
COMM Port
Power Requirements
Voltage
Consumption
Regulatory
Diagnostics
Loopback Tests
Test Patterns
NetworkAlarms
Data PortAlarms
Front-panel LEDs
Physical
Stand-alone Dimensions
Weight
Module Dimensions
Weight
Environmental
Operating Temperature
Storage Temperature
Relative Humidity
MaximumAltitude
T1
1.544 Mbps ± 50 bps
DA-15 socket
AMI, B8ZS
D4, ESF
0, -7.5, or -15 db LBO
-24 dB0
Network, data port, or internal
RS-449/EIA-530 or V.35
Nx56/64 kbps, (N = 1 through 24)
DB-25 socket
DE-9 socket
110 VAC, -48 VDC
6 W maximum
FCC Part 15, FCC Part 68
UL 1459, UL1950; IC, CUL
VCCI Class 1
T1 network, T1 payload, fractional T1 payload, loop-up/loop-down commands, and DTE
1:1, 1:2, 1:4, 1:8, 3:24, QRW, all Os, all 1s, smart jack, two user programmable 24-bit patterns
Net carrier loss, net sync loss, netAIS received, net yellow received, CRC, BPV, OOF threshold
RTS loss, DTR loss
Power/test, network status, network loopback, remote loopback, DTE loopback, TD, RD, CTS,
RTS, DTR
22.2 cm (8.75 in) W x 4.45 cm (1.75 in) H x 29.2 cm (12 in) D
3.0 kg (6.5 lbs)
1.90 cm (0.75 in) W x 21.92 cm (8.63 in) H x 20.96 cm (8.25 in) D
0.34 kg (0.75 lbs)
0º - +50º C
-20º - +60º C
0% - 95% non-condensing
4,572 Km (15,000 ft)
Solo T1 DSU
T1SN
T1
S
NMPD
SU
T1
Solo T1 DS
SU
U
U
Route
er
Rout
Remote
S
it
e
Remote
S
it
e
Rou
Rou
T1
Network
NxT1
Compan
y
Headquarter
s
Worksta
ation
Wo
Management
ment
t
M
en
Subnet
t
es
with S
h
S
w
© 2007 Quick Eagle Networks. All rights reserved.
PDF/05/07
The information presented herein may change without notice
and should be used for informational purposes only. Solo T1
DSU is a trademark of Quick Eagle Networks. All product and
service names mentioned are trademarks of their respective
owners.
Northern, Central & Eastern Europe
[email protected]
Southern Europe, Middle East & Africa
[email protected]
Asia / Pacific Rim
[email protected]
Latin, Central & South America
[email protected]
Canada
[email protected]
Headquarters
Quick Eagle Networks (USA)
830 MaudeAvenue
Mountain View, CA 94043
[phone] Phone
[phone] Fax
[email protected]
www.quickeagle.com