Quietside DPW-199C User manual

This appliance is certified for use without any limitation of the any altitude
installation. However for better combustion, from 2,000ft to 4,500ft
installation decrease the manifold pressure 0.3' W.C.for Natural Gas.
From 4,500ft to 6,000ft installation derease the maniforld pressure 0.6'W.C.
from the regular manifold pressure for Nature Gas. For installation above
6,000ft or for specific instructions on how to adjust the manifold pressure,
please contact technical .Quiteside support
4
58
62
61
64
73
DPW-199C

doesn’t match supplied gas and specified gas,
case

,

DPW-199C

This water heater shall not be connected to any heating system or
component(s) previously used without thoroughly flushing the system
prior to filling. Contaminated space heating water can cause scale or
sludge build-up which affects the system efficiency and life of unit and
its components.

Control Dial
When the boiler is operating,
Burner lamp is on.
Space heating Button
Push this button to turn
on space heating mode
and set the temperature
of space heating water.
When it’s turned on,
on left side of LCD.
Power button
Use this button to
turn on/off the boiler.
Outdoor Reset button
Indoor Temperature
Indicator
Indicates the current
room temperature of
around room controller
If there is not enough
water in appliance,
this lamp turns on.
Repeated timer setting button
Set range:1∼12 hours
Domestic hot water
temperature indicator
After pressing Domestic
hot water temperature
button, please set
domestic hot water
temperature by using
the control knob
Spacce heating
temperature setting
Repeated timer setting
Domestic hot water
temperature setting
DSR-420F
Temperature Control Indicator
and Button Function(DSR-420F)
During the cumbustion,
symbol displayed
Combustion Symbol
Low water level
warning light
℉
Press this button to
use the outdoor reset
function.
The function is
automatically setting
target temperature
for
with sensing outdoor
temperature.
space heating
Press the button to start
timer function and set off
time with the control knob.
This will force the unit to
run space heating mode
for 20 min every
(your set value) hrs.
AUTO.ECO
Press this button and use
the control knob to set hot
water temperature you want
Outdoor Reset lamp
This lamp indicates outdoor
reset function is turned on.
temperature will dispaly

DSR-420F
℉
AUTO.ECO
DSR-420F
℉
AUTO.ECO
controlling the control dial
DSR-420F
℉
AUTO.ECO
DSR-420F
℉
AUTO.ECO
using
the control dial.
42
is blinking.

DSR-420F
℉
AUTO.ECO
DSR-420F
℉
AUTO.ECO
DSR-420F
℉
AUTO.ECO
use the control dial
the control dial

DSR-120F
℉
AUTO.ECO
℉
Outdoor reset
Press the power button to turn
the unit on.
Press the outdoor reset button,
the boiler use the reset function.
In outdoor reset mode, unit ignores
the set temp and operates according
to heating curve graph depending on
your selected reset ratio.
℉
To set the reset ratio
Hold down outdoor reset button for
5 sec. Reset ratio(0~3) will start to
blink on LCD displaying current
reset ratio. Select desired reset ratio
by turning control dial. Number will
blink for 5 sec and screen will display
set temp.
120
130
140
150
160
170
180
-20 -10 0 10 20 30 40 50 60 70 80
HEATING CURVES
Reset Ratio 0 Reset Ratio 1 Reset Ratio 2 Reset Ratio 3

1.85gal in the