
5
RaceAmerica Black Flag Display
STEP 3-
For the wireless unit operated via PC
download the PC software le (BFcontrol.exe)
from the download section of the RaceAmerica
website(www.raceamerica.com)-click on
download link, from the drop down menu clink
on PC software. Scroll down the page until you
see BF CONTROL. Follow the instructions for
download.
POWER-ON SELF-TEST
The system will check internal systems and
external components. You will see the visual check
of the display as it steps through each segment
of the digits, one segment at a time. The display
then blanks out.
Mounting the system:
The Black Flag display has mounting 1/4-
20 PEMS on each corner. Utilize these points to
mount the display in the desired location.
DISPLAY OPERATION
PC SOFTWARE OPERATION
Run the BFcontrol software le ‘BFcontrol.
exe”. Select the COM port (g1) and the display
goes to the main screen (g 2)
Input the racer number to be displayed using
the Keyboard or extended keyboard keys.
Click update (or hit [Return] or [ENTER]
keys) to update the display with the number you
just entered on the PC screen.
NOTE: If a number is entered but not
updated, the update button and “press enter” will
ash on the screen for up to 10 seconds. (Fig 4)
If nothing is done within 10 seconds, the screen
will return to the former number.
Clear the screen/display -Clicking the
[CLEAR] button will blank out the display.
POWER REQUIREMENTS
Three-digit Black Flag Display operates on an
external 110VAC/230VAC power source.
SPECIFICATIONS
Models 6630/6430
Display Type: 7-Segment
Digit Height 6630 15in/38cm
Digit Height 6430 24in/61cm
Number of Digits: Three
Dimensions 6630 22.3 x 64 x 4 in
57 x 163 x 10 cm
Dimensions 6430 29 x 112.5 x 4 in
74 x 286 x 10 cm
Mounting 1/4-20 PEMs on
each corner
Enclosure Powder Coated
Aluminum
View Filter Red acrylic
View Range 6630 660ft/201m
View Range 6430 1000ft/305m
Data Transmission
Domestic USA 4520 @ 900Mhz
International 4620 @ 2.4Ghz
DISPLAY SET-UP
RaceAmerica suggests setting up the system
prior to an event and become familiar with setup,
connections and overall operation.
Familiarize yourself with all components.
STEP 1-
Install the power cable and connect to an
external 110VAC/230VAC power source.
STEP 2-
For wired displays, plug the interconnect
cable between the Black Flag and the IP TrackNet,
then connect an ethernet cable between the IP
TrackNet and the IP network.
For wireless units, screw the antennas onto
the connectors on the top of the display and the
wireless modem(or T-link)