45
2
SETTING THE DATE AND TIME IN THE LOGGER
13
6
DOWNLOADING A RUN FILE
2
5
3
1
4
5
ADDING OPTIONAL VNET SENSORS
4
When installing new sensors or items on the V-Net system, you must update/sync the conguration le in your PC
to insure that any changes and/or updates performed on your Racepak system will properly take affect. Carefully
follow the instructions below to perform the conguration update.
• Start the DataLink software.
• Connect the programming cable between the Racepak data logger in the
car and your PC.
• Apply power to the RacePak data logger.
• If the Sportsman_Cong is not already loaded, select File from the menu
bar then select Open Car Configuration. Select the Sportsman_Cong
and click on the OK button.
• Select Edit from the menu bar then select Read VNET Config. Your may
also use the ‘READ’ button in the toolbar which appears on the left
side of your screen.
• The message log will appear and your configuration will begin to update.
Click on the OK button when you see the message “Devices Read Successfully”.
• If you receive an error at the beginning of this step, verify that you are set on the COM
port that matches the port that the cable is installed on.
• Select File from the menu bar and select Save. This ensures that the changes performed are saved into the
conguration le on your PC.
• Programming is now complete. Turn the off the power to the Racepak data logger and disconnect the serial cable.
-
STATUS LED
CHECK THE LIGHT
DO NOT REMOVE OR INSERT SD CARD WITH POWER ON.
!
?If you wish to set time and date, refer to back page.
Check to ensure all cables and
connectors are connected.
Install
Datalink
Software
Power
Sportsman
ON.
WINDOWS
ONLY
SOLID RED
RED GREEN
SOLID GREEN
SOLID YEL-
LOW
Power is on and ready to go.
Flashing 3 red 1 green, data is recording
and writing to memory card.
Firmware update in progress.
SD memory card not recognized.
:
:
:
:
CHECK YOUR WORK
3
