Rack Solutions 104-2109 User manual

Universal Equipment
Wall Mount
Installation Instructions
Kit P/N: 104-2109
104-4010
Patent(s) Pending

Page 2
Kit Contents
Assembly Components:
(1) Wall Bracket
(1) Clamp Bracket
(2) Adjustment Knobs
Wall Mount Hardware Package:
(4) Pan Head Screws
(4) Anchors
Wall Mount Installation Instructions
Step 1. Determine Location: Select appropriate location on wall. Consider cable routing
and length.
Step 2. Mark Hole Positions: Hold Wall Bracket in position and mark 4 hole positions
with pencil.
Step 3a. Install Drywall Anchor: Install one drywall anchor at each hole mark. Using a
#2 Phillips head screwdriver press the anchor into the drywall while turning
clockwise until it is seated ush with the wall.
Step 3b.Install 4 Screws: Leave 1/4" of each screw out of wall.
1/4"

Installation Instructions
Page 3
Step 4. Attach Wall Bracket: Attach Wall Bracket to wall using the 4 screws that were
installed in 3b. Tighten Securely.
Wall Bracket
Clamp
Bracket
(2) Adjustment Knobs
Step 5. Install Clamp Bracket: Slide Clamp Bracket onto the Wall Bracket then install
the Adjustment Knobs as shown. Pull Clamp Bracket out from the wall as far as
possible. Do not tighten the Adjustment Knobs at this time.

Warranty Statement
Innovation First, Inc. warrants our products against defects in material and workmanship for a
period of one (1) year from the date of purchase. Innovation First, Inc. liability shall be limited to
repairing or replacing, at our option, any defective product.
Installation Instructions
Step 7. Secure Equipment: Push Clamp Bracket rmly against the equipment, then fully
tighten Adjustment Knobs.
2109 4010
Step 6. Install Equipment: Slide equipment into Bracket Assembly as shown. See table
below for minimum and maximum equipment widths.
Equipment
Bracket Assembly
P/N Minimum Maximum
104-2109 2.35" 4.00"
104-4010 4.00" 8.00"