Racking Solutions OC-001 User manual

Chrome 2-Tier Rack
OC-001
PACKAGE CONTENTS
Please inspect box contents to ensure you have received all components.
Note: the black circular plastic tops in between the shelves are used only for
packaging purposes. They are NOT NEEDED. Please discard responsibly &
EX16+2
AX1 BX1
CX4 DX4
GX4
FX2
Bottom Pole (with threaded
insert pre-installed)
Rubberwood Top
extra Slip sleeve
HELP LINE
01977 555007
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED
Never climb or stand on the shelves.
Informaon
if in doubt contact the supplier
Allow adequate working space and be
aware of others working around you
Inspect all packages for damage and
check that all components have been
supplied
Cauon
During Assembly
!
Warning
Rules for safe use of shelving
!
ENSURE THAT THE MAXIMUM LOAD
CARRYING CAPACITIES ARE NOT
EXCEEDED
Dispose of packaging materials
responsibly
Wear appropriate clothing -protecve
gloves and footwear are
recommended
Make sure the floor is level
Take care when handling heavy items
parcularly when liing or stretching
Please read these instrucons
throughly before commencing
assembly.
Assembly should be undertaken by
at least two people
Not suitable for use in damp or wet
environments.
Shelves must be loaded evenly, and load
heavier items on the boom shelves
Rubber Mallet
Total weight capacity is 60 kg on casters.
Basket
Top Pole (with end cap and
pole connector pre-installed)
Casters (2 locking;
2 non
Sidebar - locking)
keep away from small children.

ASSEMBLY INSTRUCTIONS
STEP 1: ASSEMBLING THE CASTERS
Screw each Caster (G) into the bottom of each Bottom Pole (D). Turn
clock-wise to screw in place. Screw in tightly.
D
G
STEP 2: SLIP SLEEVES
On the Bottom Pole (D), place 1 pair of slip sleeves (E) at the desired
level. Please make sure the arrow faces up and that the word “ top ”
is right side up. Do this for each Bottom Pole (D) and make sure that
the heights are identical for Bottom Pole (D).
Slide the pair of Slip Sleeves (E) until you hear a click to confirm the
pair is locked onto the Bottom Pole (D).Do not place more than one
pair on each Pole (D) at a time.
**Note: There will be a very small gap in-between the Slip Sleeves
(E) -this is normal.
E
STEP 3 : INSTALLING THE BASKET
Place The Basket (B) on its side and slide the Bottom Pole (G)
through the holes in the Basket (B). Make sure that the Basket (B)
corner cylinders are positioned over the Slip sleeves (E).
Stand the unit upright.
B
B
STEP 4 INSTALLING TOP POLES
Screw the Top Pole (C) into the Bottom Pole (D). The tops of these
poles are indicated by the black end up.
C
D
STEP 5: INSTALLING THE RUBBERWOOD TOP
Repeat Step 2 for the Rubberwood Top (A) and place the slip
sleeves (E) at the highest position. Slide Rubberwood Top onto
the Slip Sleeves (E).
A
STEP 6: INSTALLING THE SIDEBAR
Place the sidebar (F) on the poles as shown.
F
STEP 7: FINISH AND ENJOY YOUR QUALITY
RACKING SOLUTION PRODUCT
**Use a rubber mallet, if needed, to secure the Basket(B).