radefy AVATON User manual

Digital lock
Connecting AVATON
IoT Smart Device to
Local WiFi Network

To connect the AVATON IoT Smart Device to the Local WiFi Network, we perform
the following steps:
1. We connect the AVATON to the power plug,
2. In 1-2 sec the Green Light will turn ON indicating that the power supply is
connected and the AVATON IoT has power
3. A few seconds later the Red Light will start flashing, indicating that the AVATON
IoT is not connected to the WiFi
4. Press button S4 for 1-2 sec as indicated in the video and the picture below:
5. A few seconds after you release the S4 button, the Red light will start blinking
faster

6. On your mobile phone’s WiFi Connection
settings, the RADEFY WiFi network connection
(RADEFY-SD-xxxxxxxxxxxx) will appear
7. Select RADEFY-SD-xxxxxxx from your mobile
WiFi connection list
8. When prompted enter the
RADEFY-SD-xxxxxxxxxx password 12345678
9. From the Current Network, select the
RADEFY-SD-348b6ae1.. to open the Browser
10. When in the Browser press on the Burger ( )
on the top right side of the screen
11.Select “Config New AP”

12.Select the Local WiFi network from the list
13.Enter the Local WiFi network’s password
14.Press Apply
15. If password is correct the Browser will automatically close from your phone and
the Red Light will stop blinking and remain ON.
16. If password is not correct it will take you to the Local WiFi network selection
page to start network selection from the beginning.