RAFFEL SYSTEMS ACC PS2 U2 04 User manual

EDGE POWER STATION
USER MANUAL
ACC PS2 U2 04
888-987-1011 | raffel.com | [e-mail]
PRODUCT OVERVIEW*
*drawings are not to scale
AC plug
hand knob (x2)
cap
under mount bracket
under mount
surface mount
surface mount bracket
screws (x4)
power station
ONE YEAR LIMITED WARRANTY
Raffel Systems warrants its products against all defects in materials and workmanship for a period of one year
from the date of purchase, subject to the following terms and conditions:
This warranty applies only for normal use of the product, and shall not be effective for products or parts
which do not function properly due to misuse, alteration, installation, accident, negligence, misapplication,
modication, improper maintenance or commercial use, or if any product or part has been serviced or repaired
by other than Raffel Systems. This warranty extends only to consumers and does not extend to Retailers.
This warranty is effective only if the product is operated in the country in which the product was purchased. A
product that requires modications or adoption to enable it to operate in any other country than the country
for which it was designed, manufactured, approved and/or authorized, or repair of products damaged by these
modications is not covered under this warranty.
Liability of Raffel Systems, shall be limited to repair or replacement of any defective product or part, which
option shall be the sole decision of Raffel Systems. This warranty is effective only on behalf of the original
owner of the product and is not transferable. This warranty is effective only if the user manual instructions have
been followed.
THE WARRANTY PROVIDED HEREIN SHALL BE THE SOLE AND EXCLUSIVE WARRANTY. THERE SHALL BE NO
OTHER WARRANTIES EXPRESS OR IMPLIED INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY
OR FITNESS OR ANY OTHER OBLIGATION ON THE PART OF RAFFEL SYSTEMS WITH RESPECT TO
PRODUCTS COVERED BY THIS WARRANTY. RAFFEL SYSTEMS SHALL HAVE NO LIABILITY FOR ANY
INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES. IN NO EVENT SHALL THIS WARRANTY REQUIRE
MORE THAN THE REPAIR OR REPLACEMENT OF ANY PART OR PARTS WHICH ARE FOUND TO BE DEFECTIVE
WITHIN THE EFFECTIVE PERIOD OF THE WARRANTY. NO REFUNDS WILL BE GIVEN. IF REPLACEMENT
PARTS FOR DEFECTIVE MATERIALS ARE NOT AVAILABLE, RAFFEL SYSTEMS RESERVES THE RIGHT TO MAKE
PRODUCT SUBSTITUTIONS IN LIEU OF REPAIR OR REPLACEMENT.
To obtain warranty service on this product, mail the product and your dated sales receipt (as proof of
purchase), postpaid, to the following address:
Raffel Systems Consumer Relations
N112W14600 Mequon Road
Germantown WI 53022
No COD’s will be accepted.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce risk of injury to persons:

READ INSTRUCTIONS BEFORE OPERATING.
INJURY MAY RESULT FROM IMPROPER USE.
NEVER REMOVE COVERS.

·This appliance should never be left unattended when in operation.
·Unplug appliance from outlet before relocating or
troubleshooting.
·Do not connect an extension cord to this unit.
·Close supervision is necessary when this appliance is used by, on,
or near children, invalids, or disabled persons.
·Use this appliance only for its intended use as described in the
operating instructions.
·Do not use attachments not recommended by the manufacturer.
·Keep all cords away from heated surfaces and pinch points.
·Do not use outdoors. INDOOR USE ONLY.
·Do not use on an infant or on a sleeping or unconscious person.
·Do not use on sensitive skin. Prolonged exposure may have an
adverse affect on sensitive skin – Always check the skin in contact
with the heated area of the appliance.
·Never operate this appliance if it has a damaged cord or plug, if
it is not working properly, if it has been dropped or damaged, or
dropped into water. Contact a service center for examination and/
or repair.
·To disconnect, turn all controls to the off position, then remove
plug from outlet.
DANGER – TO REDUCE RISK OF ELECTRIC SHOCK:
·Do not reach for an appliance that has fallen
into water. Unplug immediately.
·Never use pins or other metallic fasteners with this appliance.
·Discard the appliance if the covering shows any sign of
deterioration, such as checking, blistering, or cracking.
·Keep dry. Do not operate in a wet or moist environment.

EDGE POWER STATION
USER MANUAL
ACC PS2 U2 04
888-987-1011 | raffel.com | [e-mail]
1. Place mounting bracket on
bottom of the power station
2. Attach mounting
bracket with four
screws provided
3. Thread hand knobs
into mounting bracket
4. Add cap to hand knob
top (optional)
SURFACE MOUNT ASSEMBLY INSTRUCTIONS
1. Choose an edge mount location for the power
station near a 120V power source. Slide the
power station onto horizontal surface until
bracket is ush
3. Plug power station into
120V power source
2. Twist hand knobs until
power station is secured
SURFACE MOUNT INSTALLATION INSTRUCTIONS

EDGE POWER STATION
USER MANUAL
ACC PS2 U2 04
888-987-1011 | raffel.com | [e-mail]
1. Place mounting bracket on
bottom of the power station
2. Attach mounting bracket using
the provided screws
UNDER MOUNT ASSEMBLY INSTRUCTIONS
1. Choose a location for the power station near 120V power
source. Place the power station onto horizontal surface
until bracket is ush
3. Plug power station into
120V power source
2. Mount the power station to
the surface using screws
UNDER MOUNT INSTALLATION INSTRUCTIONS