Range Road RR5510 User manual

RR5510 Wood Edger
Range Road Enterprises Ltd
Box 944
Eckville AB T0M 0X0
www.range-road.ca
Assembly of the RR5510 Wood Edger
1) Tools Needed for Build:
-14, 16, 17mm wrenches
2) Unbolt the crate, open and remove all parts. Main edger body can be left on the crate to be strapped and lifted.

RR5510 Wood Edger
Range Road Enterprises Ltd
Box 944
Eckville AB T0M 0X0
www.range-road.ca
Use equipment to lift edger high
enough off ground to install legs
Use straps to lift
Straps need to be placed on the
outside of the engine and
hydraulic tank as shown in
pictures
They will be out of the way for
attaching legs and support the
edger evenly

RR5510 Wood Edger
Range Road Enterprises Ltd
Box 944
Eckville AB T0M 0X0
www.range-road.ca
There are four different leg
types
2 x square bottom with bolts
2 x square bottom with no bolts
1 x square bottom with short
neck
4 x round bottom with
adjustable feet
Install two square bottom legs
with bolts on exit side (engine
side) of the machine
The bolts will be used to mount
the sawdust shoot

RR5510 Wood Edger
Range Road Enterprises Ltd
Box 944
Eckville AB T0M 0X0
www.range-road.ca
Attach single leg with square
bottom and short neck under
engine mount plate
Attach the remaining two square
bottom legs to entrance side
(control side) of machine
After these legs are attached
the machine can be lowered and
set on the ground

RR5510 Wood Edger
Range Road Enterprises Ltd
Box 944
Eckville AB T0M 0X0
www.range-road.ca
The sawdust shoot on the exit
of the machine can now be
bolted on
Locate the four collared bolts
on the bottom of the main body
Loosen these four bolts but
don’t take them out
The sawdust shoot can be put
over top of these bolts and slid
into place
After the shoot is in place
tighten the bolts
Shoot can be placed in
preferred direction, facing to
the left or the right of the
machine

RR5510 Wood Edger
Range Road Enterprises Ltd
Box 944
Eckville AB T0M 0X0
www.range-road.ca
Table with rollers can now be
attached, leaving the three
bolts loose for now
Use something to support the
table to make this easier
Use two of the round bottom
adjustable legs for each roller
table
Adjust the legs so the roller
table is level with the deck of
the edger, then tighten the
three bolts we left loose earlier
Repeat this step on the other
side

RR5510 Wood Edger
Range Road Enterprises Ltd
Box 944
Eckville AB T0M 0X0
www.range-road.ca
The battery con be connected
and the edger is now complete
and ready to be filled with fluid
*Gasoline
*Hydraulic Fluid
*Engine oil