Raymarine St290 User manual

ST290 Graphic Display - quick reference guide
ST290 Graphic Display Alarm pages
Alarm pages enable you to set alarm modes & thresholds
How to see Alarm pages
1. Enter the ALARMS chapter
D6298-1
You can use alarm pages to:
Set the threshold of each Alarm, to define when the Alarm will operate.
2. Select the Alarm page you want
SHALLOW
alarm DEEP alarm
SHALL.
ANCHOR
alarm
OFF
COURSE
alarm
AWA
LOW
alarm
AWS
HIGH
alarm
AWS
LOW
alarm
TWA
HIGH
alarm
TWA
LOW
alarm
LO SEA
TEMP
alarm
TWS
LOW
alarm
DEEP
ANCHOR
alarm
TWS
HIGH
alarm
SPEED
LOW
alarm
SPEED
LOW
alarm
AWA
HIGH
alarm
1 s
Set the operating mode of each Alarm, either OFF, ON or for operation with
an Auxilliary (external) alarm unit.
Note: This illustration shows the Alarm pages available in an
ST290 Full Profile. If a different profile is selected, some Alarm
pages may not be available.
Note: Where examples are required, this guide uses the High Apparent Wind Angle Alarm. The principles are valid for all Alarms.
HI SEA
TEMP
alarm
All Alarm pages display
Anchor Alarm pages display
ST290 Graphic Display - quick reference guide
ST290 Graphic Display Alarm pages
Alarm pages enable you to set alarm modes & thresholds
How to see Alarm pages
1. Enter the ALARMS chapter
D6298-1
You can use alarm pages to:
Set the threshold of each Alarm, to define when the Alarm will operate.
2. Select the Alarm page you want
SHALLOW
alarm DEEP alarm
SHALL.
ANCHOR
alarm
OFF
COURSE
alarm
AWA
LOW
alarm
AWS
HIGH
alarm
AWS
LOW
alarm
TWA
HIGH
alarm
TWA
LOW
alarm
LO SEA
TEMP
alarm
TWS
LOW
alarm
DEEP
ANCHOR
alarm
TWS
HIGH
alarm
SPEED
LOW
alarm
SPEED
LOW
alarm
AWA
HIGH
alarm
1 s
Set the operating mode of each Alarm, either OFF, ON or for operation with
an Auxilliary (external) alarm unit.
Note: This illustration shows the Alarm pages available in an
ST290 Full Profile. If a different profile is selected, some Alarm
pages may not be available.
Note: Where examples are required, this guide uses the High Apparent Wind Angle Alarm. The principles are valid for all Alarms.
HI SEA
TEMP
alarm
All Alarm pages display
Anchor Alarm pages display

Document number: 86084-1
Use with: ST290 Instrument System Owner’s Handbook
Date: 15 May 2003
Document number: 86084-1
Use with: ST290 Instrument System Owner’s Handbook
Date: 15 May 2003
ST290 Graphic Display Alarm pages
How to adjust Alarm levels
Repeat steps 2 to 5 for each Alarm you
want to set up.
6.
3.
to enter setup mode.
Hold down for 1 s
to set the alarm value
you want
orUse
4.
to leave setup mode and
save the alarm value you
have set.
Hold down for 1 s
5.
1.
Use to select the
Alarm you want to set up
2.
How to set the Alarm mode
Switch the alarm OFF Switch the alarm ON Set the alarm to operate
with an Auxilliary alarm unit
Auxilliary alarm
indicator
1.
Use to select the
Alarm you want to set up
2.
3.
D6299-1
ST290 Graphic Display Alarm pages
How to adjust Alarm levels
Repeat steps 2 to 5 for each Alarm you
want to set up.
6.
3.
to enter setup mode.
Hold down for 1 s
to set the alarm value
you want
orUse
4.
to leave setup mode and
save the alarm value you
have set.
Hold down for 1 s
5.
1.
Use to select the
Alarm you want to set up
2.
How to set the Alarm mode
Switch the alarm OFF Switch the alarm ON Set the alarm to operate
with an Auxilliary alarm unit
Auxilliary alarm
indicator
1.
Use to select the
Alarm you want to set up
2.
3.
D6299-1