Raytec URBAN-X Mini Series User manual

www.rayteccctv.comRaytec Global Tel: [phone]
Americas Tel: [phone]
Box Contents
• Urban-X Mini luminaire
• Fixing Grub screws Qty 2
• Cableglandandnut(ifsupplycablenottted)
• Lightweight and durable design
• Excellentefciency>110lm/W
• TheluminairesareClass1forinsulation
• Intelligent driver programs
• 5-year warranty
• The luminaires are suitable for use
Outdoors and Indoors
Safety Warnings
Eye Safety:
Caution–EN62471RiskGroup2Classication-Possiblehazardousoptical
radiation emitted from this product. May be harmful to eyes, do not stare at the
lamp.HazardDistanceis1,480mm.
Warning: High Voltage product
AllElectricalInstallationworktobeperformedbyasuitablyqualiedpersonin
line with the local regulations.
Riskofelectricshock-isolatemainsbeforeremovingcover.
Mechanical Installation:
Ensureunitismountedsecurelytopreventriskofinjuryandthesupplycordisinstalledas
per the instructions.
URBAN-XMiniInstallationGuide
Ver.11/18

www.rayteccctv.com Raytec Global Tel: [phone]
Americas Tel: [phone]
Installation Steps
Connection of Supply Cable to the inside of the Unit. For models without a supply cable see
section(1).Formodelswithasupplycableseesection(2).
Important Information:
Theunitmustbettedwiththecableglandsuppliedwiththeproduct.Thisisacombination
cable and ventilation gland. Without this gland, the product will not function properly. Failure
to use this gland may cause damage to the unit and will void the warranty.
Asuitablyrated3corecable(5coreforusewithDALI)mustbeused.
ConductorsizeCSA:0.75mm²to1.0mm²
CableO/D:Min4.5mmtoMax10mm
(1) Connection procedure
• Removecoverplate(5screws)
• 3 Core Mains supply cable
- Preparesuitable3coremainscableas
shown. Ensure cable gland is tightened
in correct position. Feed cable and gland
through the mounting spigot and secure
tightly with nut ~3.5Nm (22mm spanner
required).
• Terminatemainssupplywirestoterminalblock
 -(L)Live-(N)Neutral-()Earth
• Fit the cable through the restraining clip and
tighten on to base plate. Clip out excess cable
tie tail.
• Replacethecoverplate
- You must use the screws supplied with
the product
- Torqueto4Nmtoensurethe
environmental seal
• DALI connection (when used):
- The additional cores should be stripped to
8.5mm-9.5mmandsuitablyterminated
- Connect directly to the driver terminals
labelledDA(BL)Blue.Theconnectionis
non-polarity sensitive
60mm
50mm
=60mm
8mm
120mm
L&NWires=50mm
1.5Nm(20mmspannerrequired)

www.rayteccctv.comRaytec Global Tel: [phone]
Americas Tel: [phone]
(2) Mechanical installation
• Mountunitonappropriatesupportspigotofsize34-42mmDiameter
• Secure unit on spigot with supplied grub screws. Ensure spigot is fully engaged and tighten
grubscrewstotorque17Nm(5mmhex)
• For Outdoor applications the supply cable should be suitably protected from the environment
e.g. inside conduit or a lighting column
WARNING:
Ifthefactoryttedcableisdamageditmustbereplacedbyasuitablyqualiedpersonto
avoida hazard.The lightsource containedin thisluminaire shallonly bereplaced bythe
manufacturer or a nominated representative.
Functionality
TheunitrespondswhenpowerissuppliedtotheinternalLEDdriver.IftheunithasaPhotocell
ttedthisactsasanon/offswitchforthepowerreachingtheinternalLEDDriver.(For Photocell
On/Off Lux Levels please see the specication table)
Driver Programs (these will be marked on the driver)
The unit will function according to one of the following factory-set programs;
ID1 - Soft Start: 100%outputfordurationofnight(5secondsoftstart).
ID2 - Timer Dimming: 100%power(5secondsoftstart)for5hoursfrompowerup,
then50%poweruntilthenextcycle.
*ID3 - Active Dimming 50%
*ID4 - Active Dimming 25%: 100%output(5secondsoftstart)frompowerup,thendimsto
either50%(ID3)or25%(ID4)power,aroundthemidpointof
thenightanduptoamaximumof6hoursafter,thenbackto
100%ifit’sstilldark.
Thisprogramwouldtypicallyrequiretheuseofaninbuiltor
remotephotocelltomonitorthehoursofdarkness.
ID5 - Event Trigger: Theluminairewilloperateat100%for30minutesandthen
switch off until re-activated
Custom: Acustomerspecicprogram.
* Notsuitableforlocationswherethelengthofnightis23hoursorgreater.Fortherst3nightsthe
luminaireisonat100%powerfromsunsettosunrisewhilstthesystemlearnsthelengthofnights.
Unitdoesnotcompensateforvariationswithinlocaltimezones.Unitdoesnotcompensatefor
internationalclockchanges.

www.rayteccctv.com Raytec Global Tel: [phone]
Americas Tel: [phone]
Ensurealltestsareundertakenbyaqualied,
trainedengineer.Ensuresafeworking
practices are followed at all times.
• Checkmainsinput
• Checkallmainswiringconnectionsare
correct
• Checkphotocellisworking(iftted)
• CheckDriverProgram
• Checkluminairephysicalalignment
• IfDALIcontrolledcheckDALI
communications and connections
• CallRaytecforfurtherassistance
Product Dimensions
444mm (17.5")
58.5mm
(2.3")
315mm (12.3")
160mm (6.3")
130mm (5.2")
54mm
(2.1")
49
49mm
(1.9")
Urban-X Mini Troubleshoot
All units can be supplied with
or without a photocell unit.
Model Type Urban-X Mini 20 Urban-X Mini 30 Urban-X Mini 40
Operating Temperature -30°C to 60°C (-22°F to 140°F)
Power Output (Lumens) 2,200 3,300 4,400
Consumption 20W 30W 40W
Input (nominal) 220-240V AC (50-60Hz)
Surge Protection Photocell tted: 2kV
No Photocell tted: 8kV
Weight (Excluding Cable) 2kg (4.4lbs)
Photocell Switching (If tted) On at 55 Lux ; Off at 28 Lux
Environment IP66
Impact Protection IK08
Dimensions (L x W x H) 444 x 160 x 58.5mm (17.48 x 6.3 x 2.3”)
(Height 81mm/ 3.1” with photocell tted)
Optional Cable Length 8M (26ft) or 12M (39ft)
DALI control
• TheLEDdriverisDALIcompatible
allowing further control functionality and
simultaneous control of multiple luminaires.
ATC
• The unit has inbuilt automatic thermal control
which protects the unit in high temperature
installationsbyturningtheLEDsdownto
prevent damage to the product
All units can be supplied with
or without a supply cable.
Nemasocketoptions
available.
Urban-X Mini Specications:
*Modelshownwithoutphotocelltted*