A. Installation Steps
1. Using an Ethernet cable, connect the WAN port on
the back panel of the VRT210 to your existing
broadband access point (cable modem, DSL
modem, router or switch).
2. Connect one end of a phone cord to the Phone port.
Connect the other end to your analog phone or
fax machine.
3. The LAN port may be optionally used to extend your
Ethernet network by connecting it to your PC, switch,
router or other devices using an Ethernet cable.
4. Connect the power adapter to the power port on
the back panel of the VRT210 and to an electrical
outlet or power strip.
Warning: Use only the power adapter provided.
Do not disconnect the power adapter during
firmware upgrades or configuration.
B. LED Indicators
NOTE: If the LED indicator is not displaying a status as
described in the table above, please check the
associated hardware and connections.
LED
Indicator Color Status Description
PHONE Green
Solid Registered and no call
Slow Blinking In off-hook or ringing status
LAN/WAN Green
Solid Linked
Fast Blinking Data transmission
Light off Unlinked
POWER
Red Solid System power is on
Green
Solid Device is working normally
Fast Blinking Last provision failed, trying
again
Slow Blinking Device is upgrading
