ReDeal PC615N Series User manual

Introduction
This UPS is specially aimed for use with multi function personal computer. It is equipped with
boost & buck AVR to stabilize the wide input voltage range. It also comes with high-efficient
switch-mode battery charger. This charger design minimizes power loss to save charging time.
The built-in DC start function enables the UPS to be started up without a supply of AC power. The
main features of this UPS are listed below:
Microprocessor control guarantees high reliability
Built-in enhanced boost & buck AVR
Fast charger
Green power function for energy saving
DC start function
Auto restart during AC recovery
Provide Modem and phoneline surge production
Built-in RS-232 communication port
Compact size, light weight
Important Safety Instructions
To safely operate this uninterruptible power supply system, please read and follow all instructions
carefully. Please read this manual thoroughly before attempting to unpack, install, or operate UPS,
and keep this manual for further reference.
This UPS utilizes voltages that may be hazardous. Do not attempt to disassemble the unit.
The unit contains no user replaceable parts. Only authorized service personnel may
perform repairs.
Internal battery voltage is 12V DC. Sealed, lead-acid, 6 cells battery.
Connection to any other type of receptacle other than a two-pole, three-wire grounded
receptacle may result in shock hazard as well as violate local electrical codes.
In the event of an emergency, press the “OFF” button and disconnect the power cord from
the AC power supply to properly disable the UPS.
DO NOT allow liquids or any foreign object to enter the UPS. Do not place beverages or
any other liquid-containing vessels on or near the unit.
This unit intended for installation in a controlled environment (temperature controlled,
indoor area free of conductive contaminants). Avoid installing the UPS in location where
there is standing or running water, or excessive humidity.
DO NOT plug the UPS input into its own output.
DO NOT attach a power strip or surge suppressor to the UPS.
DO NOT attach non-computer-related items, such as medical equipment, life-support
equipment, microwave ovens, or vacuum cleaners to UPS
To reduce the risk of overheating the UPS, do not cover the UPS cooling vents and avoid
exposing the unit to direct sunlight or installing the unit near heat emitting appliances such
as space heaters or furnaces.
Unplug the UPS prior to cleaning and do not use liquid or spray detergent.
DO NOT dispose of batteries in a fire as they may explode.
DO NOT open or mutilate the battery or batteries. Released electrolyte is harmful to the
skin and eyes. It may be toxic.
A battery can present a risk of electrical shock and high short circuit current. The following
precautions should be observed when working on batteries :
1) Remove watches, rings, or other metal objects from the hands.
2) Use tools with insulated handles.
3) Wear rubber gloves and boots.
4) Do not lay tools or metal parts on top of batteries.
5) Disconnect charging source prior to connecting or disconnecting battery terminal.
Servicing of batteries should be performed or supervised by personnel knowledgeable of
batteries and the required precautions should be taken. Keep unauthorized personnel
away from batteries.
When replacing batteries, replace with the same number of the sealed lead-acid batteries.
The socket-outlet shall be installed near the equipment and easily accessible.
With the installation of the UPS, it should be prevented that the sum of (UPS and) the
connected (load) leakage current exceeds 3.5mA.
This pluggable type A equipment with battery installed by the supplier is operator installable
and may be operated by laymen.
Attention!! Hazardous through electric shock. Also with disconnection of this unit from the
mains, hazardous voltage still may be accessible through supply from battery. The battery
supply should be therefore disconnected in the plus and minus pole at the connectors of the
battery when maintenance or service work inside of the UPS is necessary.
System Description


Installation & Operation
1. Placement
Install the UPS in a protected area that is free of
excessive dust and has adequate air flow. Please
1. Power Switch
2. UPS status LED
AC Mode: green lighting
Battery Mode: green flashing
3. AC mode indicator: green lighting
4. Battery mode indicator: yellow
flashing
5. Fault mode indicator: red lighting
6. AC Mode: indicating load level
Batt. Mode: indicating battery
capacity
1. AC Input & AC fuse
2. Output receptacles
3. USB com. port
4. Modem/Phone/Network surge
protection
PC615N Series
User’s Manual
www.redeal.pt
[email protected]
ReDeal


place the UPS away from other units at least 20 cm to avoid interference. DO NOT operate the UPS
where the temperature and humidity is outside the specific limits. (Please check the specs for the
limitations.)

Plug in the AC input cord to the wall outlet. For the best results,
suggest charging the battery at least 4 hours before initial use. The
unit charges its battery while connecting to the utility.

Plug in the loads to output receptacles on the rear panel of the UPS.
Simply turn on the power switch of UPS unit, then devices
connected to the UPS will be protected by UPS unit.

To surge protect a network connection, connect a network cable from the wall jack outlet to the IN
jack of the UPS. Then connect a network cable from the OUT jack of the UPS to the network
device.

UPS equipped with communication port allows monitoring and controlling from computer screen.
Connect one end of a communication cable to your PC and the other to the com port at the rear of
the UPS.
ViewPower is an UPS power management software, allowing users to control and monitor UPS
straightly from PC monitor. Insert ViewPower software CD or download ViewPower software from
http://www.power-software-download.com to your hard drive. Follow on-screen instructions to
complete the software installation.
After computer is restarted, ViewPower is geared and presents as an orange plug icon located in
the system tray at the right-bottom corner.
 
To turn on the UPS, press power switch lightly. To turn off the UPS, please press power switch
again.
 !"# 
PC615N-650 and PC615N-850 UPS are equipped with Green Power Function. For saving power
and protecting battery, the method of deep discharging protection is adopted on inverter mode.

Trouble-shooting

Use the table below to solve minor problems. If any abnormal situations occur that are not listed
above, please call service technician for assistance.
Problem Possible Cause Solutions
Low battery. Charge the UPS at least 6 hours.
Battery fault. Replace the battery with the same type of
battery.
No LED display on
the front panel.
The UPS is not turned on. Press the power switch again to turn on the
UPS.
Alarm continuously
sounds when the
mains is normal.
The UPS is overload. Remove some loads first. Before reconnecting
equipment, please verify that the load matches
the UPS capability specified in the specs.
The UPS is overload. Remove some critical load.
Battery voltage is too low. Charge the UPS at least 6 hours.
When power fails,
back-up time is
shortened. Battery defect. It might be due to high
temperature operation environment, or
improper operation to battery.
Replace the battery with the same type of
battery.
The mains is normal,
but LED blinks..
Power cord is loose. Reconnect the power cord properly.

Specifications

Model 650 850 1000 1500 2000
CAPACITY 650VA/
360W 850VA/ 480W 1000VA/ 600W 1500VA/ 900W 2000VA/ 1200W
INPUT
Voltage 110/120 VAC or 220/230/240 VAC
Voltage Range 81-145 VAC / 162-290 VAC
OUTPUT
Voltage Regulation +/-10%
Transfer Time Typical 2-6 ms, 10 ms max.
Waveform Simulated Sine Wave
BATTERY
Type & Number 12V/7AHx1 12V/9AHx1 12V/7AHx2 12 V/9 AH x 2
Charging Time 4-6 hours recover to 90% capacity
PHYSICAL
Dimension, DxWxH, (mm) 287x100x142 350x146x 160 397x146x205
Net Weight (kgs) 4.25 4.90 8.0 11.1 11.5
Environment
Humidity 0-90 % RH @ 0-40°C (non-condensing)
Noise Level Less than 40 dB
MANAGEMENT
USB Supports Windows 98 SE/ME/NT 4.x/2000/2003/XP/Vista/2008
* Product specifications are subject to change without further notice.

www.redeal.pt
[email protected]
ReDeal