Redline Communications AN 80i User manual

-1 -
AN 80i Configuration Instructions

-2 -
Configuration Instructions AN80i
For connections please refer to Figure 1.
For the link distance of three meters and antenna gain of 9 or 15 dBi, 10dB attenuator should be used onthe client
side.
Figure 1

-3 -
Figure 2: Block Diagram of the EUT
To access AN80i using GUI:
-Open Internet Explorer and access AN80i Web page at IP addresshttp://192.168.25.3or
http://192.168.25.2 ( IP address of each unit is given on the label attached to the unit)
-Login using adminas User Name and Password.
Figure. 3 Login

-4 -
Figure. 4 General Information
-From the Web page menu selectConfigure System to set RF parameters.
-The frequency can be set in steps of 2.5MHz.
-Please note that antenna gain should be entered according to the antenna used.
-After changes are done, click on Save button at the bottom of the page.

-5 -
Figure. 5 Configure System

-6 -
Figure. 6 Configure System (continued)
TxOff or Chg Freq should be selected depending onthe test performed
When Chg Freq is selected Client should have Auto scanenabled.

-7 -
The link status can be checked by selecting System Status from the Web page menu
Figure. 7 System Status

-8 -
Telnet Session
Start a telnet session by entering the following commands:
telnet 192.168.25.2 or 192.168.25.3
Figure. 8 Telnet
Login using debug as User Name and Password
At the prompt type dbg dfs to enter DFS debug mode
Commands available for testing purpose:
evtime Evaluation time 60 sec. default value
Should not be set less than 10sec.
resetevents To reset number of events detected
txoffdis 1or 0To disable/enable TxOff after radar detection
txofftime To reduce TxOff time after radar detection
In sec. 1800 default value