Reece KADO LUSSI User manual

KADO
LUSSI FREESTANDING BATH
SPECIFICATIONS
Recommended use Domestic, hotel and commercial
Material Cast Solid Surface
Colour White
Capacity 1505mm Bath - 267 Litres
1705mm Bath - 354 Litres
Weight 1505mm Bath - 115 kg
1705mm Bath - 130 kg
Size Options 1505mm x 730mm x 580mm
1705mm x 800mm x 580mm
Overflow Ye s
Tap hole No Taphole
Tapware should be floor or wall mounted
Plug and Waste 40mm Pop Up Waste (included)
Fixing Silicone to floor
Standard Inclusions Bath Bag & Maintenance Kit (Included)
To see the complete KADO range go to
www.reece.com.au/bathrooms
We recommend the use of soapy water or approved cleaners.
This product should not be cleaned with abrasive materials.
Damage caused by any improper treatment is not covered by the product warranty . Refer to Warranty Conditions.
CLEANING RECOMMENDATIONS
Dimensions are nominal measurements only
page 1 of 3
Disclaimer: Products in this specification manual must by regulation be installed by licensed and
registered trade people. The manufacturer/distributor reserves the right to vary specifications or
delete models from their range without prior notification. Dimensions are nominal measurements only.
Dimensions and set-outs listed are correct at time of publication however the manufacturer/distributor
takes no responsibility for printing errors.
Tech Page Version 1

INSTALLATION INSTRUCTIONS
Important:
• Please unwrap the bath and check it carefully to ensure it has not been damaged in handling or transport.
• Please check that all parts have been supplied.
• Assemble bath on a mat to protect against damage to bath surface.
• Please do not remove the old fixture before you unpack and inspect the new unit.
• Store the bath in a safe place until you begin installation to avoid damage.
• Any installation should be carried out by a qualified tradesman with knowledge of statutory plumbing requirements in your area.
• This product requires a two person lift – use proper lifting techniques.
• This installation guide does not include details of waste connection; final decision about installation of waste connection should
be taken by a suitably qualified person.
Parts supplied:
1x
1
4x
When fitting the waste, ensure the slotted
side faces the overflow channel.
Slot
Overflow
channel
page 2 of 3
Plumbers, please ensure a copy of the installation instructions
is left with the end user for future reference
KADO
LUSSI FREESTANDING BATH

4x
24H
Place the bath on two wooden blocks over the waste
connections. Connect the waste. Fill the bath with water
and check for leakage. Place the wedges in position.
The wedges can now be
disposed of.
Care and Maintenance:
• Repairing a scratch: If any scratches occur during installation these can be removed by rubbing with a 1500+grit water-
proof abrasive paper and water.
• Repolish the surface afterwards using a neutral automotive colour restorer or household metal polish. For best results
limit sanding to the smallest possible area around the scratch.
• It may be possible to polish very fine scratches away without using abrasive papers: scrubbing gently with a soft brush or
plastic pad (not metal scouring pad) and a mildly abrasive cream cleaner. Afterwards scrub the whole area with plenty of
clean water and re-polish as before.
Everyday cleaning
We recommend a non-abrasive bathroom cleaner.
page 3 of 3
KADO
LUSSI FREESTANDING BATH
Plumbers, please ensure a copy of the installation instructions
is left with the end user for future reference