Reel EFX DF-50 User manual

3/13/08 2:50 PMDF-50 DIFFUSION? HAZER
Page 1 of 5http://www.reelefx.com/products/df50man.htm
DF-50 DIFFUSION HAZER
INTRODUCTION
The DF-50 Diffusion Hazer is the cleanest most cost effective atmospheric fogger available in the market today. Fluid
use is less than 2 ounces an hour! The Diffusion Haze produced is totally odorless and can only be detected visually.
No more sore throats or burning eyes. This patented machine utilizes a triple filtered system that breaks down the
Diffusion Fluid (food grade mineral oil) to a uniform 1-micron sized or less droplet. The unit is self-contained needing
only the proper power rating and a sufficient amount of fluid.
UNPACKING
Each DF-50 is carefully checked and tested to strict factory standards before being shipped. In each carton is the DF-
50 and accompanying power cord.
Warning: Do not connect the power cord to the unit and switch on until you have thoroughly read the operating
instructions section of this manual.
OPERATING INSTRUCTIONS OVERVIEW
The DF-50 Diffusion Haze should NOT be considered as a standard haze machine. Because of the minute particulate
size of the haze produced and its long lasting hang time (3+ hours in an enclosed area) it is not necessary to have the
concentration of haze that is normally associated with other machines. The particles produced are so minute that they
are hardly visible to the eye. Although you make think the concentration is insufficient, you will find that after a very
short period of use the DF-50 will have produced more than a sufficient amount of atmosphere.
Due to the efficiency of the machine it is recommended that the machine be used intermittently, NOT continuously, and
in situations where the machine is not monitored by an operator, it is suggested you use a timer to switch the machine
ON and OFF. Under normal conditions you may find that a running time of 10 minutes ON each 15-20 minutes should
provide the desired atmosphere, however length of running time will vary for each job.
Another important factor in the operation of the DF-50 is that it should NOT be fully enclosed, unless enclosed in a
case approved by the manufacturer such as the one shown on Page 9. If the air temperature around the machine rises
too high the thermal sensor in the machine will turn it OFF. The machine works on the principle of drawing air from the
back of the machine and passing air through the machine, then out the front of the machine mixed with the diffusion
particles, which have gone through a triple filtration process. Therefore, a steady flow of cool air is recommended for
the machine, hence it is best operated in an unobstructed position.

3/13/08 2:50 PMDF-50 DIFFUSION? HAZER
Page 2 of 5http://www.reelefx.com/products/df50man.htm
If the machine is used non-stop (and this is NOT recommended) over a long period you may create a situation
whereby the concentration of smoke is too much, which can result in build-up of residue in the environment. You may
also experience some residue after a long period of using the machine as recommended and this can be seen on
equipment close by, especially those with air filters and fans etc. However, normal periodic cleaning of this equipment
will prevent this. If the machine is to be used continuously, then a timer should be used to create a 10-second off
period to allow the water trap to automatically drain.
OPERATING
Always
1. Transport the unit right side up or empty.
2. Before operating, fill with Diffusion Fog Fluid just below the top of the tank window on the side of the unit. ALWAYS
TAKE CARE NOT TO OVERFILL.
3. Check the machine for correct voltage.
4. Check the female plug for tight connection before plugging the male end into an AC voltage
receptacle. New line DC
voltage will result in damage to the machine.
5. If the circuit breaker trips, then turn OFF the machine and reset by depressing the breaker
button, then turn back ON. Be
sure to plug directly into a wall outlet or use a 2.5mm2 extension cord. Note: When starting the
voltage must not drop
less than 80% of nameplate voltage. If it continues to trip contact your dealer.
6. The machine must be level to operate properly.
7. The machine holds 2 liter’s or 1/2 gallon of fluid. DO NOT OVERFILL. If you overfill, then it may
be necessary to remove
thecover to clean up the excess fluid.
FILLING INSTRUCTIONS
1. Unscrew the cap on the top of the unit and pour fluid into the opening. Be careful not to overfill.
2. Do not use more than 2 liter’s or 1/2 gallon of fluid.
3. Check the level by using the sight window on the side of the unit.

3/13/08 2:50 PMDF-50 DIFFUSION? HAZER
Page 3 of 5http://www.reelefx.com/products/df50man.htm
4. If overfilled, empty excess by tipping to the side of the spout and pouring back out. If you have
spilled fluid inside the machine it may be necessary to remove the cover to clean up the excess
fluid. If this is required DISCONNECT the machine from the power supply before opening.
CAUTION
Only Diffusion Fog Fluid may be used in the operation of the DF50. Any other fluid may clog the
machine, create a health hazard, cause damage to the machine and will void the manufacturer’s
warranty coverage.
DO NOT ATTEMPT TO SERVICE THE DF-50
CALL YOUR DEALER IF YOU HAVE ANY QUESTIONS
ROUTINE MAINTENANCE
FLUID LEVEL: Using the glass sight level on the side of the machine fill with a sufficient amount of fluid to
approximately 1/2" below the top level. If you overfill, then tip the machine on its side to dispose of the excess.
COMPRESSOR: No maintenance is required and no attempt should be made to service the compressor. The
compressor is rated at MTBF 5000+ hours before any rebuild may be necessary.
AIR FILTER: Remove top of the black filter element. By twisting counter clockwise 1/4 turn. Remove wool element and
wash in soap and water, then reassemble.
WATER TRAP: To maintain maximum filtering efficiency and to avoid excessive pressure drop, the filter must be kept
clean. To access the filter you need to remove the cover of the DF-50. Turn the drain valve to remove any bowl
accumulation before it reaches level of lower baffle. A visible coating of dirt or condensation on the filter element or
excessive pressure drop indicates cleaning is necessary.
To clean, depressurize air line and remove bowl. Wash filter elements with household soap. Elements should be
replaced if soiled or creating excessive pressure drop. Blow out body with compressed air. Clean bowl only with
household soap.
TANK: No maintenance is required and no attempt should be made to service.
If any problems occur, you should contact your dealer

3/13/08 2:50 PMDF-50 DIFFUSION? HAZER
Page 4 of 5http://www.reelefx.com/products/df50man.htm
USEFUL TIPS
The DF-50 Diffusion Hazer provides a fine atmospheric mist. The maximum recommended
level for use in an eight-hour day is 5mg/M3. If OSHA levels have to be met, please contact your dealer
for information on the Diffusion Fog Meter.
Always use Diffusion Fog Fluid. Operation with any other fluid will invalidate the warranty and
fail to meet CAL/OSHA tested standards.
It is helpful to use an ‘RE’ Fan or other type of fan to disperse the mist produced, but it is not
recommended to mist through the fan as this will result in build-up on the fan blades.
It is NOT necessary to place the unit where mist is required, as the DF-50 will provide an
even amount of atmospheric ambiance in all enclosed space.
Do not leave the machine ON continuously in a small room as this will result in too high a
concentration and may leave unwanted residue
DO NOT block the supply of air to the back of the unit as you will prevent the compressor
from performing efficiently and may overheat the compressor.
SPECIFICATIONS
SIZE: 35cmH X 38cmL x 21cmW
14"H X 15"L x 8" W
WEIGHT: 16kg or 35 lbs. net without fluid
POWER: 100v 50-60Hz
120v 60Hz
200-240v 50Hz
FLUID: Diffusion brand haze fluid
FLUID CAPACITY: 2 Liters or 1/2 gallon
RUNTIME: 35+ Hours

3/13/08 2:50 PMDF-50 DIFFUSION? HAZER
Page 5 of 5http://www.reelefx.com/products/df50man.htm
HAZE HANG TIME: 3+ Hours in an enclosed space
SAFETY TESTING: CAL-OSHA Tested (Test results on request)
League of American Theaters
Actors Equity
WARRANTY: 5 years parts and labor on compressor
1 year parts and labor all other components
AVAILABLE ACCESSORIES
Remote (radio) Road Case
(100v~110v only)
Automatic Fill System and Interval Timer
AutoFill System
Interval Timer
Timer-AutoFill Combo (110v & 220v)