Rem Air System replacement pump User manual

Congratulations, and thank you for purchasing the leading replacement air
system for luxury air mattresses. We know you will be pleased with the
quality and performance of your investment. Your new REM Air System
boasts the newest in remote sensor and whisper technology. In addition
you will also be happy with the simplistic setup and user friendliness.

Technical Specifications:
Model: REM Air System replacement pump
Voltage: DC12V
Pressure: 0-60mbar (Show 1-20 numerical value)
Flow: 20LPM
Power: 25W
Standby Power: 2W
Weight: 2.3Kg
Contour Dimension: Length 260* Wide 155* Height 105mm
Wireless Remote Control Air Pump Instruction Manual
TM

Operational Instructions:
1. Power on by connecting power source into outlet and plugging opposite end into the pump
input receiver. Pump LED light will show red for 30 seconds after initial start. When the LED
light turns green; this means the pump is working and communicating with remote.
2. To activate remote press any button on RC. The LCD screen will light up and turn off after 10
seconds of not being used.
3. For inflation and deflation: Press L/R button to choose which side of mattress to inflate/
deflate. When inflating the numerical reading will increase on a scale of 0-60 (True Scientific
Read Scale) Once the desire air pressure is reached press any key to stop inflation or deflation.
4. Memory Value: The memory function allows the user to find a desired air pressure and
return to the set pressure at the press of a button. To do so, choose which side of the mattress
to wish to inflate/deflate. Press the “Memory” button. The pump will then inflate or deflate to the
defaulted setting (factory default setting is 25mbar or 37 numerical value)
5. Memory Save: To save a memory setting of your choice; Inflate or deflate your mattress to
your desired pressure. Once the pump has stopped at the desired comfort number, hold down
the Memory button for 3 seconds. The LCD screen will show “Memory” and then flash “Save.”
The data is then memorized and your new memory setting is established. (You can save a
different memory setting for each chamber in a dual chamber mattress.
LCD
Inflate
Memory
Left & Right Conversion
Deflation

Quick Tips:
Your remote control has a range of 5 to 10 Meters. If you are out of range the remote will read
“Er.” Please use within rage.
Upon initial installation of your REM Air System; if your remote reads “Er,” and your are within
the allotted rage of 5 to 10 meters, no problem. This simply means the remote needs to be
calibrated with the pump. Its easy:
1. Disconnect and re-connect your pump to the wall outlet. When the pump’s LED light
shows red, press any button to wake up the remote. Then hold down the “L/R” button
for 3 seconds. Once the LCD screen shows “Su,” you have calibrate successfully.
Your REM air system is now ready for operation.
Batteries:
Remote requires (2) AAA-LR03-1.5V batteries. Remote LCD screen signal when the battery
power is low. Please change batteries in time to avoid any damage.