Remington mb4560 User manual

MB4560
Register online for
£10,000 prize draw
EXTRA year guarantee
FREE rewards gallery
Visit www.productregister.co.uk/remington
.
You must register within 28 days
of purchase.
Touch Control Beard Trimmer

2
Thank you for buying your new Remington® product. Please read these
instructions carefully and keep them safe. Remove all packaging before use.
F IMPORTANT SAFETY INSTRUCTIONS
Warning – for additional protection the installation of a residual current device
(RCD) with a rated residual operating current not exceeding 30mA is advisable in
the electrical circuit supplying the bathroom. Ask an electrician for advice.
1 This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been supervised/instructed and
understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be done by children unless they
are older than 8 and supervised. Keep the appliance and cable out of reach
of children under 8 years.
2 An appliance should never be left unattended when plugged into a power
outlet, except when charging.
3 Do not immerse the appliance in liquid; do not use it near water in
a bath-tub, basin or other vessel; and don’t use it outdoors.
4 Do not use this product if it is not working correctly, if it has been
dropped or damaged, or dropped in water.
5 Make sure the power plug and cord do not get wet.
6 Do not plug or unplug the appliance with wet hands.
7 Do not use the product with a damaged cord. A replacement can be
obtained via our International Service Centres.
8 Store the product at a temperature between 15°C and 35°C.
9 Do not use attachments other than those we supply.
10 This appliance is not intended for commercial or salon use.
11 Keep the appliance dry.

3
CKEY FEATURES
1 3 position slide switch (O/On/Lock motor on)
2 Cutting length controls
3 Digital display for:
a. Battery level
b. Length setting, mm
c. Lock / unlock
d. Speed level
4 Motorised comb
5 Mode Button
6 Tri-Boost system
7 Micro USB port
8 USB cable
9 Adaptor
10 Storage pouch
9
10
8
6
2
7
5
4
3
1

4
CGETTING STARTED
Before the unit can be used for the rst time, keep hands away from touch screen
area and pull out the plastic tab marked with an arrow from the bottom of the
unit. The plastic tab is only for shipping and can be discarded.
,CHARGING YOUR APPLIANCE
•Before using your hair clipper for the rst time, charge for 90 minutes.
•Ensure the product is switched o.
•Connect the charging adaptor to the product and then to the mains. The
charging indicator will illuminate. When fully charged, the display screen
turns o.
•Your trimmer cannot be overcharged. However, if the product is not going
to be used for an extended period of time (2-3 months), unplug it from the
mains and store.
•Fully recharge your trimmer when you would like to use it again.
•To preserve the life of your batteries, let them run out every 6 months then
recharge for 90 minutes.
,CHARGING VIA STANDARD ELECTRICAL SOCKET
•Ensure the product is switched o.
•Connect the charging adaptor to the product and then to the mains.
•When charging the digital display will illuminate.
•Allow 90 minutes for a complete charge.
•This appliance should be charged by approved safety isolating adaptors
PA-0510E (for EU version) or PA-0510U (for UK version) with the output
capacity of 5.0V dc; 1A;
,USB CHARGING VIA PC
•Ensure the product is switched o.
•Connect your USB cable to the USB port on the PC.
•Connect the USB cable to your beard trimmer.
•When charging the digital display will illuminate.
•Allow 90 minutes for a complete charge.
,CORDED USE
•Connect the charging adaptor to the product then to the mains.
•When the cord is connected to the mains, a digital display will be displayed
on the appliance.

5
,CAUTION
• Extendedmainsonlyusewillresultinthereductionofthebatterylife.
,WARNING
• Theappliancecannotbeoperatedincordedmodewhileconnectedtoa
PC via the USB port.
,CORDLESS USE
• Whentheunitisswitchedonandfullycharged,theproductcanbeusedin
cordless mode for 50 minutes.
F INSTRUCTIONS FOR USE
• Alwayscombyourbeardormoustachewithanecombbeforeyoustart
trimming.
• Turntheproductonbyslidingthe3positionslideswitchdowntothe
middle position. This will turn the LCD display on and enable height
adjustments and boost adjustments to be made.
• Yourtrimmercanbeadjustedineither0.1mmor0.5mmincrements.To
switch between these, press and hold the mode button for 3 seconds. The
increment that the trimmer is now set at will be displayed (or ash) for 1
second.
,USING THE TOUCH SCREEN
• Thetrimmercombcanbeadjustedtogiveyou175dierenttrimlengths,
with 0.1mm increments, simply by pressing the arrows on the touch
screen. Press and hold the arrow up to increase the cutting length and
down to decrease it. The setting number will appear on the digital display.
• Selectthedesiredboostlevelbypressingtheboostbuttonwiththe3
position slide switch in the middle position. The display will indicate the
level.
• Oncethedesiredlengthandboostlevelhavebeenselectedslidethe3
position slide switch to the last position (the furthest down) to lock the
cutting length and turn the motor on.
• Toadjustthelengthorboostlevel,simplyslidethe3positionslideswitch
back into the middle position and adjust the cutting length or boost level
by pressing the arrows or boost button on the touch screen.
,Please note that the motor will only run when the 3 position slide switch is
set to lock, the last position (furthest down). This is to ensure the cutting
length does not adjust whilst you are trimming your facial hair.

6
,Note: Trimmer comb must be attached to the groomer in order to use the
hair length selector.
,TO THIN AND TAPER THE BEARD/MOUSTACHE
(DIAGRAM 1)
• Usethetouchscreentosetthetrimmercombto
the desired length setting.
• Thesettingwillappearonthelengthposition
indicator. If you are trimming for the rst time start
with the maximum trimming length setting.
• Turntheuniton.
• Placetheattopofthetrimmercombagainstthe
skin.
• Slowlyslidethetrimmerthroughthehair.Repeat
from dierent directions as necessary.
• Ifhairbuildsupinthetrimmercombduringthe
trimming process, switch the unit o, pull o the
comb and brush o.
,TRIMMING EDGE OF SIDEBURNS (DIAGRAM 2)
• Holdthetrimmerwiththetrimmerbladefacing
you.
• Startwithedgeofsideburnandwiththetrimmer
blades resting lightly against your skin, use
motions towards edge of sideburn line to trim to
desired locations in facial area.
• Shapeasdesired.
,TRIMMING THE NAPE OF YOUR NECK
• Youwillneedahandmirrorforthisoperationif
performing it alone.
• Useyourngerstoliftthehairatthebaseofyourheadupotheneck.Your
index nger should be covering the roots of the hairs you are lifting to
prevent accidental removal by trimmer.
• Usingyourotherhand,holdthetrimmertothebaseofyourneckwiththe
cutting unit facing up, and move the trimmer up the length of the neck until
it touches your nger covering the hair roots at the base of your head.
• Besuretomovetheunitslowlywhenperformingthisoperationandtokeep
the hair roots at the base of your head out of the way of the trimmer.
ETips for Best Results
•Beard, moustache and sideburn hair should be dry.
•Avoid using lotions before using your trimmer.

7
C CARE FOR YOUR TRIMMER
,AFTER EACH USE
•Ensure the appliance is switched o and unplugged from the mains before
cleaning.
• Brushtheaccumulatedhairfromtheblades.Donotsubmergetheclipperin
water.
• Tocleantheunit,wipewithadampclothanddryimmediately.
• Onlytheattachmentguidecombsandtrimmerblademayberemovedfrom
the product for cleaning.
• Cleaningshouldonlybedonewithasoftbrush.
,CLEANING CAUTIONS
• Donotrinseunderwater.
• Onlyusealight-gradeoilorsewingmachineoilontheblades.
• Donotuseharshorcorrosivecleanersontheunitsortheirblades.
• Donotsubmergeinwaterasdamagewilloccur.
,RESET INSTRUCTIONS
•You will never have to force a system reset under normal conditions. If the
clipper experiences abnormal behaviour, such as low or high touch
sensitivity or subjected to electrostatic discharge disturbance, or subjected
to electrical fast transient/burst from the LV network, the system can be
reset.
• Holdthemodebuttonfor8secondswiththeproductswitchedonandthe3
position slide switch set to the middle position, the system will enter reset
mode.
• Systemwillshow18.8mm,fullbattery,fulllockandfullboostlevel.
• Ensurenoobjects,handsorngersarenearthetouchbuttons.
• Pushthemodebuttononce.
• Thecombwilltraveldowntoitslowestsettingandthedisplaywillshowthe
current battery level, lock status and 1st boost level.
• Lettheproductsituntilthescreendims.
• Productisnowready,turnitonandconrmproperfunction.
,STORAGE
•Always store this appliance and cord in a moisture free area. Do not store it in
temperatures exceeding 140°F (60°C).
•Do not wrap the cord of the charging adaptor around the appliance.

8
BATTERY REMOVAL
•The battery must be removed from the appliance before it is scrapped.
•The appliance must be disconnected from the supply mains when removing
the battery.
•Turn the trimmer on and discharge all remaining power.
•Remove the comb attachment.
•Detach the blade head.
•Remove the head clip using a screw driver.
•Using a screwdriver carefully pry apart the top and bottom housing.
•Unscrew the (2) screw on the circuit board.
•Remove the upper circuit board.
•Disconnect the battery from the low circuit board.
•The battery is to be disposed of safety.
H ENVIRONMENTAL PROTECTION
To avoid environmental and health problems due to hazardous
substances in electrical and electronic goods, appliances marked with
this symbol must not be disposed of with unsorted municipal waste, but
recovered, reused or recycled.
E SERVICE AND GUARANTEE
Defects aecting product functionality appearing within the guarantee period will
be corrected by replacement or repair at our option provided the product is used
and maintained in accordance with the instructions.
Your statutory rights are not aected.
Consumables are excluded.
Defects from repair by an unauthorized dealer are not covered.
If you call the Service Centre, please have the Model No. to hand, as we won’t be
able to help you without it. The Model No. can be found on the rating plate of the
appliance.
Replacement parts and accessories are available to buy at
www.remington.co.uk/parts-accessories

9
E SERVICE CENTRE
United Kingdom
GTel 0800 212 438 (free call mainland UK)
G+44 161 947 3111 (call outside the UK)
Spectrum Brands (UK) Ltd
Fir Street, Failsworth, Manchester
M35 0HS, UK
www.remington.co.uk
Ireland
GTel 142 951 40
Remington Consumer Products,
Unit B12, Ballymount Corporate Park,
Ballymount, Dublin 12.
www.remington.co.uk
I REGISTER ONLINE FOR
£10,000 prize draw, EXTRA year guarantee, FREE rewards gallery.
Visit www.productregister.co.uk/remington. You must register within 28 days
of purchase.
Model No. MB4560
14/UK/ MB4560 T22-0002176 Version 03 /14
Remington® is a Registered Trade Mark of Spectrum Brands, Inc., or one of its subsidiaries.
Spectrum Brands (UK) Ltd
Fir Street,
Failsworth,
Manchester
M35 0HS
www.remington.co.uk
© 2014 SBI