Remington MB5000AU User manual

2 YEAR WARRANTY MB5000AU
ENDURANCE BEARD
TRIMMER KIT
To register your product go to
www.remington-products.com.au
www.remington.co.nz
USE & CARE
MANUAL
PLEASE READ
PRIOR TO USE

2
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions should
always be observed, including the following.
READ ALL INSTRUCTIONS BEFORE USING
DANGER: As with most electrical appliances, electrical parts are
electrically live even when the switch is off.
For additional protection, the installation of a residual current
device (rcd) having a rated residual operating current not
exceeding 30 mA is advisable in the electrical circuit supplying
the bathroom. Ask your installer for advice.
KEEP AWAY FROM WATER
WARNING: TO REDUCE THE RISK OF BURNS, ELECTROCUTION AND
FIRE OR INJURY TO PERSONS
• The appliance should never be left unattended when plugged into a
power outlet, except when charging the appliance.
• This appliance should not be used by children or other persons with
reduced physical, sensory or mental capabilities or lack of experience
and knowledge unless they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the
hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by children without
supervision.
• Never operate this appliance if it has a damaged cord or plug, if it is
not working correctly, if it has been dropped or damaged, or dropped
into water. If the supply cord or plug of the appliance is damaged it
must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard. It cannot be repaired.
• Keep the cord away from heated surfaces.
• Charge, use and store the product at a temperature between 0°C and
32°C.
• Do not use outdoors or where aerosol (spray) products are being used,
or where oxygen is being administered.
• For use on facial hair only. Not intended for shaving the hair on your
head.

3
• Do not plug or unplug the appliance with wet hands.
• For household use only.
• Do not place or store the appliance or charging adaptor where it can
fall or be knocked into a sink or bath.
• Do not place in or drop into water or any other liquid for extended
periods of time.
• If an appliance falls into water, “unplug it” immediately. Do not reach
into the water.
• Unplug the charging adaptor from the electrical outlet immediately after
fully charging.
• Unplug the power adaptor from the appliance before cleaning the
appliance in water.
• Use this appliance only for its intended use as described in this
manual.
• Do not use attachments not recommended by Remington.
• Never drop or insert any object into any opening of this appliance.
• Always store the charging adaptor in a moisture-free location.
• Do not use on people who are asleep.
• This appliance should be supplied with approved safety isolating
adaptor PA-0510A (AUS version) with the output capacity of 5V DC,
1A; 200mA (adaptor output).
• Do not use an extension cord or a voltage converter with this
appliance.
SAVE THESE INSTRUCTIONS

4
MB5000AU Endurance Beard Trimmer Kit
Use & Care Instruction Manual
Thank you for purchasing your Remington®Endurance Beard Trimmer Kit.
Inside this manual you will find instructions on using and caring for your
groomer.
KEY PARTS
1. Line Edger T-Blade
2. On/Turbo/Off Switch
3. Adjustable Beard & Stubble
Comb (1.5mm - 5.0mm)
4. 20mm Detail Head
5. 7mm Detail Head
6. Full Size Foil Shaver Head
7. 9 x Trimming Guides
(1.5 - 25mm)
8. Endurance Lock
Also Includes:
• Power Adaptor
• Storage Pouch
• Lubricating Oil
• Cleaning Brush
1
6
7
2
3
4
58

5
Note: The trimming guide attachments supplied are of various lengths
(1.5 - 25mm). When first becoming familiar with your Endurance Beard
Trimmer Kit, begin with a longer numbered setting. Adjust cutting length as
desired.
ABOUT YOUR TRIMMER
MB5000AU SPECIFICATIONS
Power System Cordless (Rechargeable)
Full Charge Time 4 Hours
Run Time 4.5 Hours
Quick Charge Yes (5 Minutes)
Indicators Fuel Gauge (see chart)
Voltage Type (adaptor voltage type) Worldwide 100-240V
CHARGING
• Before using your groomer for the first time, charge it for 4 hours. The
groomer will be fully charged in 4 hours.
• Plug the adaptor into your groomer and then plug the charging adaptor
unit into a 100-240V domestic power outlet. Check to ensure that
the battery lock switch is in the unlocked position (left). The unit will
not charge if the switch is in the lock position. The fuel gauge will
illuminate to indicate that it is charging. When the battery is full the
fuel gauge will remain illuminated until disconnected from the power
outlet.
• The battery cannot be overcharged, but it is recommend that charging
be discontinued and the groomer stored away if it will not be used for
an extended period of time (2-3 months).
• To preserve the life of the battery, discharge it by running the groomer
until the blades move slowly. Switch off and recharge for 4 hours. Do
this every 6 months.
• Use the groomer only with the charging adaptor supplied.
Endurance Lock
• The groomer features an endurance lock which helps preserve battery
charge during storage.
• To enable the endurance lock when the trimmer is not in use, slide the
endurance lock switch to the right.

INSTRUCTIONS FOR USE
• Switch the product on by pressing the On/Turbo/Off button once for
normal mode, again for turbo mode, and a third time to turn it off.
• Turbo mode is intended for thick beards or heavier areas of facial hair.
• Turbo function provides a boost in motor speed to power through thick
beards.
HOW TO USE YOUR ENDURANCE BEARD TRIMMER KIT
What attachments to use:
T-Blade
Foil
Shaver
Head
Adjustable
Stubble
Comb
Trimming
Guides
7mm
Detail
Head
20mm
Detail
Head
Beard X X X X
Beard Line X X X X
Moustache X X X X X X
Nape of
Neck X X
Sideburns X X X X
Nose X
Ear X
Eyebrow X
Body X X X X
Head X
FUEL GAUGE DISPLAY OF CHARGE LEVELS
Blue
Red
100% 70% 40% 10% 5 min. left
(rapid flashing)

7
ATTACHING THE GROOMING ATTACHMENTS
Note: Ensure the groomer is switched off before changing any attachments.
To Attach & Remove the Attachment Heads:
• To attach any of the attachment heads, slide the selected head onto
the body until it clicks into place.
• To remove the T-Blade & the Detail Heads, press on the eject symbol
on the back of the head and slide forward. Make sure the blade is
facing away from you.
• The foil shaver attachment has a release button on the back. To
remove, press then slide off.
Trimming Guides:
Note: Make sure the T-Blade is on the groomer.
• To attach trimming guides, ensure the trimmer blade is facing away
from you. Hook the trim guide on the front of the trimmer blade and
push down to click into place.
• To remove, pull the tab on the back of the trim guide upwards and
away from the trimmer blade.
Adjustable Stubble Comb:
• The stubble comb can be adjusted to give you length settings between
1.5 - 5.0mm by turning the wheel to the desired length.
• Turn the wheel clockwise for longer length and counterclockwise for
shorter lengths. The wheel has an indicator that points to the length
setting selected.
GROOMING TIPS
Beard / Moustache:
• Use a small comb to straighten hairs for trimming.
• When TRIMMING, first select a Trimming Guide and attach to the
T-Blade. If you are trimming for the first time start with the maximum
length. Adjust the trim guide length as desired once you are familiar
with using the groomer.
• Starting under the chin, follow the jaw line back towards the ear. Trim
in multiple directions to capture all stray hairs.
• When THINNING or TAPERING, use a small comb to hold beard in
place. In your opposite hand, hold the Groomer with the cutting system
facing outward while slowly moving through the hair.

8
• If hair builds up in the trimmer comb during the process, switch the
unit off, pull the comb off and remove excess hair by pulling it out of
the comb.
• The Adjustable Beard Comb Attachment can also be used to achieve
the desired look.
Foil Shaver:
• Use the Foil Shaver attachment to clean-up detailed areas. For best
results, avoid holding at an angle.
Note: The foil shaver is designed to shave the detailed areas around your
beard, moustache and sideburns. It is not designed to shave your entire
face. Ensure to trim your facial hair before shaving.
Nape of Neck
• Using a mirror is necessary if self-trimming.
• Lift hair off neck, using index finger to cover & protect hairs NOT
needing trimming.
• Carefully touch cutting blade to neck, slowly moving the groomer in an
upward direction until stopped by index finger.
Eyebrows:
• Attach the 7mm detail head trimmer.
• Guide cutting edges to stray hairs along eyebrows.
• For best results, do not use the trimmer to define entire eyebrow.
Nose:
• Attach the 7mm detail head trimmer.
• Carefully insert groomer no more than 1/4” into nostril.
• Rotate the groomer in a circular motion while gently moving in and out
of nose.
Ears:
• Attach the 7mm detail head trimmer.
• When trimming inner ears, avoid inserting the groomer more than 1/4”
into ear canal.
• Rotate the groomer in a circular motion while gently moving in and out
of ear canal.

9
CLEANING, CARE & MAINTENANCE
Note: Always clean the groomer attachments regularly to ensure maximum
performance and a proper operating life.
Cleaning Attachments With Water
1. Remove attachment.
2. Rinse the attachment under warm running water. Do NOT use hot
water as this might cause damage.
Cleaning Attachments With The Brush
• After first removing attachment, thoroughly brush and blow out hair
clippings from cutting system, attachment and top of groomer handle.
Cleaning Foil Shaver Attachment
The foil shaver attachment has a release button at the back to remove it
from the groomer. To remove, press the button then slide off.
Oiling Blades & Cautions
• Rinsing attachments under water (above) requires lubricating the
cutting blades 1x monthly. Using only light-grade oils (e.g. sewing
machine oil), simply spread 1-2 drops lightly over cutters with
fingertip. Wipe away all excess.
• Use only light-grade oils as these will not evaporate nor slow down
speed of cutting blades.
• Do not use hair oil, grease, or any oil mixed with kerosene or solvent
as these too will evaporate.

10
BATTERY DISPOSAL
Note: The battery is not intended to be removed or replaced under normal
use. The only time the battery should be removed or the unit opened or dis-
assembled is at the end of the product’s useful life before it is discarded.
• The MB5000AU contains a lithium-ion battery. Once the groomer has
reached the end of its life, to ensure proper disposal of the product,
please take the appliance to a recycling centre, where the internal
rechargeable battery should be removed by a professional and
recycled separately.
• For more information about recycling of electrical and battery operated
appliances, please contact your local council office or your household
waste disposal service.
Caution: Do not put in the fire or mutilate your batteries when disposing as
they may burst and release toxic materials. Do not short circuit as it may
cause burns.
This product is suitable for use in the bath or shower.
This product conforms to radio frequency interference requirements
Any product purchased and used commercially carries a limited 90 Day Warranty.