Remington PG6024AU User manual

2 YEAR WARRANTY PG6024AU
5-IN-1 TITANIUM
MULTI-GROOMING KIT
To register your product go to
www.remington-products.com.au
www.remington.co.nz
USE & CARE
MANUAL
PLEASE READ
PRIOR TO USE

2
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions should
always be observed, including the following.
READ ALL INSTRUCTIONS BEFORE USING
DANGER: As with most electrical appliances, electrical parts are
electrically live even when the switch is off.
For additional protection, the installation of a residual current
device (rcd) having a rated residual operating current not
exceeding 30 mA is advisable in the electrical circuit supplying
the bathroom. Ask your installer for advice.
KEEP AWAY FROM WATER
WARNING: TO REDUCE THE RISK OF BURNS, ELECTROCUTION AND
FIRE OR INJURY TO PERSONS
• Do not place or store the appliance or charging adaptor where it can
fall or be knocked into a sink or bath.
• Do not place in or drop into water or any other liquid.
• If an appliance falls into water, “unplug it” immediately. Do not reach
into the water.
• Unplug the charging adaptor from the electrical outlet immediately after
fully charging.
• Do not use while bathing or in the shower.
• Unplug and switch off this appliance before cleaning it.
• Use this appliance only for its intended use as described in this
manual.
• Do not use attachments not recommended by Remington.
• Never drop or insert any object into any opening of this appliance.
• Keep the cord away from heated surfaces.
• Do not use this appliance with a damaged or broken trimming
attachments as injury may occur.
• Always store the charging adaptor in a moisture-free location.
• For household use only.
• This appliance should not be used by children or other persons with
reduced physical, sensory or mental capabilities or lack of experience
and knowledge unless they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the
hazards involved.

3
• This appliance is not a toy. Children shall be supervised to ensure they
do not play with the appliance. Cleaning, use, and maintenance shall
not be made by children without supervision.
• Keep the appliance and the power cord away from edge of tables or
countertops and out of reach of children and persons with reduced
physical, sensory or mental capabilities.
• Do not use on people who are asleep.
• Misuse may cause injury.
• Never operate this appliance if it has a damaged cord or plug, if it is
not working correctly, if the charging adaptor has been damaged or
dropped into water.
• Do not use an extension cord or a voltage converter with this
appliance.
• Do not wrap the cord around the appliance.
• WARNING: For recharging the battery, only use the adaptor supplied
with the appliance.
• Always replace the adaptor with one of the original type.
WARNING - KEEP THE APPLIANCE DRY
SAVE THESE INSTRUCTIONS

4
PG6024AU 5-IN-1 TITANIUM MULTI-GROOMING KIT
USE & CARE INSTRUCTION MANUAL
Thank you for purchasing your Remington®5-in-1 Titanium Multi-Grooming
Kit. Inside this manual you will find tips on using and caring for your multi
groomer.
KEY PARTS
1. 32mm Trimmer Head with
Titanium Coated Blade
2. On/Off Switch
3. Charging Indicator
4. Groomer Handle
5. Adjustable Comb Attachment
(2-16mm)
6. Arc Detail Trimmer Head
7. Nose, Ear, Eyebrow Trimmer
Head
8. Mini Foil Shaver Head
ALSO INCLUDES
• Charging Adaptor
• Pouch
4
5
7
2
1
3
6
8

5
Note: The Adjustable Comb Attachment has various length settings. When
first becoming familiar with your groomer, begin with a higher numbered
setting. Adjust cutting length, as desired.
PG6024AU SPECIFICATIONS
Power System Cordless (Rechargeable)
Initial Charge Time 24 Hours
Full Charge Time 14-16 Hours
Run Time 60 Minutes
Indicators LED Charging Indicator
Voltage Type AC Adaptor - 220-240V
ABOUT YOUR GROOMER
CHARGING
• Before using your groomer for the first time, charge it for 24 hours.
The groomer will be fully charged in 16 hours.
• Check to ensure that the groomer On/Off switch is OFF. Plug the
adaptor into your groomer and then plug the charging adaptor unit into
a domestic power outlet. The Charging Indicator will illuminate when
it is connected to the power source, the light will remain on until it is
disconnected from the power source (even when it is fully charged).
• The batteries cannot be overcharged, but it is recommended that
charging be discontinued and the groomer be stored away if it will not
be used for an extended period of time (2-3 months).
• The groomer will be fully charged in 14 to 16 hours.
• To preserve the life of the batteries, discharge them by running the
groomer until the blades move slowly. Switch off and recharge for 24
hours. Do this every 6 months.
• Use the groomer only with the charging adaptor supplied.

6
ATTACHING THE GROOMING ATTACHMENTS
• The groomer attachments are removed by rotating anticlockwise and
lifting off.
• Insert the required attachment and rotate clockwise to lock into
position.
HOW TO USE YOUR GROOMER?
What attachments to use:
Arc Detail
Trimmer
Full size
Trimmer
Nose & Ear
Trimmer
Adjustable
Beard &
Stubble
Comb
Mini Foil
Shaver
Beard X X
Beard line X X X
Ear X
Eyebrow X X
Moustache X X X
Nape of
neck X X
Nose X
Sideburns X X X X
ATTACHING AND REMOVING THE GROOMING HEADS
• Ensure that the groomer is switched off before fitting or
removing heads.
• To remove, rotate the head anti-clockwise until it unlocks and then
lift off.
• To fit, place the desired head on top of the groomer and rotate head
clockwise to lock into place.
ATTACHING AND REMOVING ADJUSTABLE COMB ATTACHMENT
• To attach, line up the rails on the comb with the slots on the sides of
the groomer and slide the comb downwards onto the groomer.

7
• To adjust, press and hold the adjustment button on the back of the
comb and slide the comb up or down. Release the button to lock the
comb at that position. The length of cut is indicated by the scale on the
side of the groomer.
• To remove, press and hold the adjustment button and push the comb
up and off the groomer.
• The Adjustable Comb attachment has 8 length settings: 2-16mm (in
increments of 2mm). Begin with a higher numbered setting. Adjust
cutting length as desired once you are familiar with using the groomer,
it is better to select a longer hair length setting in order not to trim too
much hair.
GROOMING TIPS
Hair Clipping: 32mm Trimmer Head With Adjustable Comb (2-16mm)
• Should be dry and free of lotions or other liquids.
• Comb outward to obtain maximum height / length and facing in the
same direction.
Step 1: Nape of the neck
1. Using a hand-held mirror is necessary if self-trimming.
2. Fit the 32mm trimmer head and adjustable comb.
3. Set the adjustable comb to 4 mm or 6 mm.
4. Hold the groomer with the blade teeth pointing upwards. Begin
starting at the centre of the head at the base of the neck.
5. Slowly lift the groomer, working upwards and outwards through the
hair, trimming just a little at a time.
Step 2: Back of the head
• With the adjustable comb set at 12 mm or 16 mm, cut the hair at the
back of the head.
Step 3: Side of the head
1. Adjust the comb to a shorter length setting for the areas around the
ears.
2. Increase the length setting on the adjustable comb to gradually
transition the length of hair on the side of the head to the longer hair
on the top of the head.

8
Step 4: Top of the head
1. Adjust the comb to the longer length settings (up to 16 mm) then cut
the hair on top of the head against the direction in which the hair
normally grows.
2. Always work from the back of the head.
Beard / Moustache: 32mm Trimmer Head With Adjustable Comb
(2-16mm)
1. Use a small comb to straighten hairs for trimming.
2. Fit the 30mm trimmer head and adjustable comb.
3. Set the adjustable comb to the desired length.
4. Start trimming under the chin following the line of the jaw.
5. Work upwards towards the ear and upper beard line.
Contour Edging and Close Hair Cutting: 32mm Trimmer Head
1. Hold the groomer with the cutting blade (teeth) facing you and at 90
degrees to the skin.
2. Start with the edge of the beard/moustache line and, with the blade
resting lightly against the skin, use slow controlled movements to
create contoured lines.
Beard Line: Arc Detail Trimmer Head
1. Hold the groomer with either the 32mm trimmer or arc detail trimmer
blade facing you.
2. Start with the edge of the beard line and with the cutting blades
resting lightly against your skin. Use downward motions towards the
edge of the beard line to trim the beard line to the desired shape in the
facial areas and around the neck.
Sideburns: Arc Detail Trimmer Head
1. Comb sideburns following the direction of your hair growth.
2. Hold the groomer vertically with either the 32mm trimmer or arc detail
trimmer head facing you.
3. Trim sideburns using a downward motion. After trimming, lightly go
over the trimmed areas with the mini foil shaver head to remove any
short hairs remaining and to get a smooth clean finish.
Mini Foil Shaver Head
• Use the Mini Foil Shaver head to clean-up detailed areas. For best
results, avoid holding at an angle.

9
Note: The mini foil shaver is designed to shave the detailed areas around
your beard, moustache and sideburns. It is not designed to shave your
entire face.
Ears: Nose, Ear, Eyebrow Trimmer Head
1. When trimming inner ears, avoid inserting the groomer more than
6mm into ear canal.
2. Turn the groomer on.
3. Insert the groomer’s cutting unit gently into the ear canal.
4. Rotate the groomer in a circular motion while gently moving in and out
of ear canal.
Eyebrows: Nose, Ear, Eyebrow Trimmer Head
1. Guide cutting edges to stray hairs along eyebrows.
2. For best results, do not use the groomer to define entire eyebrow.
Nose: Nose, Ear, Eyebrow Trimmer Head
1. Turn the groomer on.
2. Carefully insert the groomer’s cutting unit no more than 6mm
into nostril.
3. Rotate the groomer in a circular motion while gently moving in and out
of nose.
CLEANING, CARE & MAINTENANCE
Note: Always clean the groomer heads and attachment immediately after
use to ensure maximum performance and a proper operating life.
Cleaning Mini Foil Shaver Head
Note: Do not rinse or lubricate the mini foil shaver with oil as it is
permanently lubricated.
1. With the head removed from the handle, remove the foil head from the
attachment by pressing the latch button.
2. Shake to remove excess clippings.
3. Replace attachment by gently snapping back into place.
Clean the Comb and Trimmer Heads With a Soft Brush (not included)
• With the head removed from the handle, gently brush out hair clippings
from the cutting system and top of trimmer handle.

10
Cleaning Heads With Water
• With the head removed from the handle, rinse ONLY under warm
running water. Do NOT use hot water as this might cause damage.
Note: Do not rinse the mini foil shaver head.
Oiling Blades & Cautions
• Rinsing attachments under water will require a re-lubrication of the
cutting blades once per month. Using only light grade oils (e.g. sewing
machine oil), simply place one or two drops lightly over cutters with
fingertip. Wipe away all excess
Note: Do not lubricate the foil shaver with oil as it is permanently lubricated.
BATTERY DISPOSAL
Note: The battery is not intended to be removed or replaced under normal
use.
• The PG6024AU contains a nickel metal hydride battery. Once the
trimmer has reached the end of its life, to ensure proper disposal of
the product, please take the appliance to a recycling centre, where the
internal rechargeable battery should be removed by a professional and
recycled separately.
• For more information about recycling of electrical and battery operated
appliances, please contact your local council office or your household
waste disposal service.
Caution: Do not put in the fire or mutilate your batteries when disposing as
they may burst and release toxic materials. Do not short circuit as it may
cause burns.
We suggest you use local waste management centres to recycle this
product at end of life.
This product is not suitable for use in the bath or shower.
This product conforms to radio interference requirements.
Any product purchased and used commercially carries a limited 90 day warranty.