Remington R3150AU Installation guide

2 YEAR WARRANTY
Use and Care Instruction Manual
PLEASE READ PRIOR TO USE
R3150AU

7
IMPORTANT SAFETY INSTRUCTIONS
When using an electric shaver, basic safety precautions
should always be observed, including the following.
Read all instructions before using this shaver.
KEEP POWER ADAPTOR AWAY FROM WATER
WARNING – TO REDUCE THE RISK OF BURNS, FIRE,
ELECTRIC SHOCK OR INJURY TO PERSONS:
s The shaver should never be left unattended when
plugged into a power outlet, except when charging the
shaver.
s This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way
and understand the hazards involved. Children shall not
play with the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
s Use this shaver only for its intended use as described in
this manual. Do not use attachments not recommended
by Remington.
s Never operate this shaver if it has a damaged cord or
plug, if it is not working correctly, if it has been dropped
or damaged, or dropped into water. If the supply cord or
plug of this shaver is damaged it must be replaced. It
cannot be repaired.
2

8
s Keep the cord away from heated surfaces.
s Charge, use and store the product at a temperature
between 0°C and 32°C.
s Never insert any object into any opening of this shaver.
s Do not use outdoors or where aerosol (spray) products
are being used, or where oxygen is being administered.
s Do not use the shaver with a damaged or broken tracks
or cutters, as injury may occur.
s For use on facial hair only. Not intended for shaving the
hair on your head.
s Do not plug or unplug the shaver with wet hands.
s For household use only.
Remington strongly recommends that an approved
Safety Switch (residual current device) be installed to
protect all bathroom power outlets. Ask an electrical
contractor for advice.
SAVE THESE INSTRUCTIONS
3

Product Features
SHAVER PARTS
1. Pivoting head & cutter assembly
2. Hairpocket release button
3. Individual flexing heads
4. On/Off slide switch
5. Power port
6. Trimmer button
6
7
9
8
7. Head guard
8. Power cord
9. Cleaning brush
2
3
4
5
1
7
8
4

Power System
Corded – shaver can only be used with the power cord.
Voltage Type
Worldwide Voltage – shaver automatically adapts to an outlet voltage
between 120V and 240V.
About Your Shaver
FEATURE R3150AU
POWER SYSTEM corded
VOLTAGE TYPE worldwide
REPLACEMENT PART NO. SP-5161AH
Adjusting To Your Shaver
Removing The Protective Head Guard
As with every shaver, your shave will improve over time. Allow up to four weeks
of daily shaving to develop an effective shaving style and for your skin to adjust
to the new shaver. The adaptation period may take a little longer if your skin
is sensitive, if you are switching from a different method of shaving, or if you
alternate between shaving methods.
Before operating your shaver, remove the protective head guard, which protects
the head and cutter assembly. It is important to remove it correctly to avoid
damaging the clips that hold it to the shaver.
1. Press lightly on the top of the protective head guard.
2. Lift the lower rear edge.
3. Pull the protective head guard away from the shaver. When the shaver is not in
use, always keep the protective head guard on the shaver head and keep the
trimmer in the OFF position.
5

Shaving
Before using, read the important safety instructions in this manual.
1. Press the On/Off button to activate for shaving (Diagram A).
2. Hold the shaver so that all the heads touch your face together (Diagram B).
This allows the shaver to work the way it was designed for the closest shave
and minimum wear. Avoid holding the shaver at an angle so that only one head
touches the skin.
Use short, circular stokes. Use your free hand to stretch your skin. This
encourages your whiskers to stand out, making it easier for them to enter
the cutting chamber.
Never press hard when shaving. Pressing hard only flattens the whiskers,
which makes it harder for them to enter the cutting chamber. It will also
cause the cutting surface to wear out more quickly.
3. Press the On/Off button to turn the shaver off (Diagram A).
A B
A B
■ Ensure your skin is dry and free of skin oils.
■ Wait at least 15 minutes after getting up before shaving, to ensure your face
is free of puffiness that may be present from sleeping.
■ Always hold the shaver at a right angle to the skin so that all three heads are
touching the skin with equal pressure.
■ Stretch skin with the free hand so hairs stand upright, making it easier for
them to enter the cutting chamber.
■ Use moderate to slow, circular stroking movement.
■ The use of short, circular motions in stubborn areas may obtain a closer shave,
especially along the neck and chin line.
■ Do not press hard against the skin to avoid skin irritation and/or damage to
the rotary heads.
**Remington recommends that you use your new shaver daily for up to four weeks to
allow time for your hair and skin to become accustomed to the new shaving system**
Shaving Tips
6

1. Pull trimmer release button down to engage trimmer. (Diagram C)
2. Trim long, difficult hairs and side burns. (Diagram D)
3. Close trimmer by pressing down on trimmer housing. (Diagram E)
Trim
Cleaning & Care
CD E
NOTE: **When cleaning your shaver, make sure the shaver is turned off and
disconnected from the power cord.**
CAUTION!
■ To clean the external surfaces of the shaver, use a damp cloth. Do not use strong
detergents or other chemicals.
■ To dry, wipe the surface of the shaver with a dry towel. Do not use a hair dryer
or heater to dry the shaver.
■ Ensure that the main body of the shaver remains dry at all times.
7

Daily:
1. Press the hairpocket release button to open hairpocket assembly. (Diagram F)
2. Tap out excess hair shavings. (Diagram G)
3. Close hairpocket assembly. (Diagram H)
Monthly:
1. Perform the daily cleaning steps 1 and 2.
2. Remove the cover from the hair pocket assembly. (Diagram I) Place the body of
the shaver aside to ensure that it will not get wet.
3. Place a drop of liquid soap on each cutter. (Diagram J)
4. Brush the soap around vigorously using the supplied cleaning brush. (Diagram K)
5. Release the inner cutter carrier by rotating the locking arms counter-clockwise.
(Diagram L)
6. Remove the inner cutter carrier away from the cutters. (Diagram M)
7. Remove the cutters. (Diagram N)
F G HI
JKLM
NO P Q
R
8

Replacing Your Heads & Cutters
Please refer to the shaver comparison and features chart near the front of
this manual that lists the correct replacement part number for your shaver.
It is very important to replace your head and cutters when necessary to ensure
a close, comfortable shave without irritation. We recommend they be replaced
every 6 months. Here are some signs of head and cutter wear, indicating that
replacement is needed:
QIrritation: As the heads get excessively worn you may experience some skin
irritation. This would be especially noticeable when you apply moisturizing lotion.
QPulling: When the cutters wear you may feel a sense of pulling and a loss of
closeness when you shave. This is an indication that it is time to replace your
heads and cutters.
8. Thoroughly brush any hair off of the inner and outer cutters (Diagram O) and
rinse away any soap and debris from inner and outer cutters. (Diagram P)
9. Replace the inner cutters. (Diagram Q)
10. Place the inner cutter carrier back into position and lock into place by rotating
the locking arms clockwise until they snap into place. (Diagram R)
11. Lubricate each cutter with household oil.
12. Close the head assembly. (Diagram H)
** Trimmer: Lubricate teeth with oil every six months
Lubricate
Remington® Shaver Saver (SP-4) lubricates and cleans your shaver’s cutters and
head assembly. The lubricant helps remove hair clippings while reducing wear.
Spray on the heads and cutters after each shave to keep your shaver operating at
peak performance.
9

This product is not suitable for use in a bath or shower.
Money Back Offer - Australia/New Zealand Only
If within 30 days you are not fully satisfied with your Remington® shaver, just
return the shaver with this completed coupon and a copy of your Australian/New
Zealand purchase receipt to Remington®. In return, we will send you a cheque
for the full purchase price of the shaver. Please allow 6-8 weeks for your cheque
to arrive.
Name:
Address:
City:
State: Postcode:
10