Remington Rx5 Ultimate Series User manual

2 YEAR WARRANTY HC7000AU
ULTIMATE SERIES Rx5
H E A D S H AV E R
To register your product go to
www.remington-products.com.au
www.remington.co.nz
USE & CARE
MANUAL
PLEASE READ
PRIOR TO USE

2
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions should
always be observed, including the following.
READ ALL INSTRUCTIONS BEFORE USING
DANGER: As with most electrical appliances, electrical parts are
electrically live even when the switch is off.
For additional protection, the installation of a residual current
device (rcd) having a rated residual operating current not
exceeding 30 mA is advisable in the electrical circuit supplying
the bathroom. Ask your installer for advice.
WARNING: TO REDUCE THE RISK OF BURNS, ELECTROCUTION AND
FIRE OR INJURY TO PERSONS
• The appliance should never be left unattended when plugged into a
power outlet, except when charging the appliance.
• This appliance should not be used by children or other persons with
reduced physical, sensory or mental capabilities or lack of experience
and knowledge unless they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the
hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by children without
supervision.
• Never operate this appliance if it has a damaged cord or plug, if it is
not working correctly, if it has been dropped or damaged, or dropped
into water. If the supply cord or plug of the appliance is damaged it
must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard. It cannot be repaired.
• Keep the cord away from heated surfaces.
• Charge, use and store the product at a temperature between 0°C and
32°C.
• Do not use outdoors or where aerosol (spray) products are being used,
or where oxygen is being administered.
• Do not use this appliance with damaged or broken tracks, foils or
cutters, as injury may occur.
• For use on head hair only. Not intended for shaving the hair on your
face.
2

3
• Do not plug or unplug the appliance with wet hands.
• For household use only.
• Do not place or store the appliance or charging adaptor where it can
fall or be knocked into a sink or bath.
• Do not place in or drop into water or any other liquid for extended
periods of time.
• If an appliance falls into water, “unplug it” immediately. Do not reach
into the water.
• Unplug the charging adaptor from the electrical outlet immediately after
fully charging.
• Unplug the power adaptor from the appliance before cleaning the
appliance in water.
• Use this appliance only for its intended use as described in this
manual.
• Do not use attachments not recommended by Remington.
• Never drop or insert any object into any opening of this appliance.
• Always store the charging adaptor in a moisture-free location.
• Do not use on people who are asleep.
• Do not use an extension cord or a voltage converter with this
appliance.
• Do not wrap the cord around the appliance.
• Remington strongly recommends that an approved Safety Switch
(Residual current device) be installed to protect all bathroom power
outlets. Ask an electrical contractor for advice.
SAVE THESE INSTRUCTIONS
3

4
HC7000AU ULTIMATE SERIES Rx5 HEAD SHAVER
USE & CARE INSTRUCTION MANUAL
Thank you for purchasing your new Remington®Ultimate Series Rx5 head
shaver. Inside this manual you will find tips on using and caring for your
shaver.
KEY PARTS
1. On/Off Switch
2. Shaving Head
3. Pop Up Trimmer (not shown)
4. 360° Pivoting Neck
5. LED Battery Indicators
6. Hair Pocket
7. Charging Pins
Also Includes:
• Head Guard
• Storage Bag
• Cleaning Brush
• Power Adaptor
1
6
23
4
5
7

5
HC7000AU SPECIFICATIONS
Power System Cordless (Rechargeable)
Initial Charge Time 4 Hours
Full Charge Time 4 Hours
Cordless Run Time Up to 50 Minutes
Indicators 2 LEDs (Low / Charging / Full Charge)
Voltage Type Worldwide 100 - 240V
Waterproof Yes
Replacement Head & Cutters SP-HC7000AU
Power System: Cordless - shaver can only be used when disconnected
from the charging adaptor. The shaver will not run while it is charging.
Indicators:
• Low Charge: Flashes red when the shaver needs to be recharged.
• Charging: When plugged in, the charging indicator will light up green.
• Full Charge: Green LED indicator will turn off.
Note: Some countries will require the use of a plug adaptor that is not
included with your shaver.
CHARGING
Before using, read the important safety instructions in this manual.
1. Ensure the product is switched off. Connect the shaver to the adaptor
2. Connect to the mains and charge for 4 hours when using for the first
time. This first charge is important to the shaver’s battery life.
3. When plugged in, the charging indicator will light up green.
4. When empty, the battery should be charged for 4 hours for a full
charge and will provide up to 50 minutes of shaving time.
5. To preserve the life of the battery do not charge the battery after
each use. Best practice is to use the shaver until the red low charge
indicator appears and then recharge.
Caution:
• Make sure the shaver and your hands are dry when charging the
shaver.
• Always charge the shaver in a cool, dry place.

6
SHAVING YOUR HEAD
1. Hold the head shaver body in the palm of your hand. Press the On / Off
switch to turn the head shaver on.
2. Press the five cutting heads against your scalp. It is not necessary
to press hard to shave. Pressing hard does not cut closer and could
increase irritation. The cutting head will flex to follow the contours of
your head.
3. Move the shaver slowly around your head. You may use linear strokes,
or rotating motion, whichever you feel is most effective picking up and
cutting your hair.
4. Use a hand held mirror to check the back of your head to confirm a
complete and thorough shave. You may also use your other hand to
feel for complete and consistent cutting.
5. It is not recommended to use the head shaver for facial hair.
6. When finished turn the shaver off. Check for the red low charge
indication.
SHAVING TIPS
• Do not attempt to shave head hair that is longer than 4 days growth or
2.0 mm. The Ultimate Series Rx5 head shaver is intended to maintain
the shaved look and can be used daily or every two or three days.
• The Ultimate Series Rx5 head shaver cannot shave long hair down to
the shaved length. If your hair is longer than 2.0 mm you should trim it
down with a hair clipper first before using the head shaver.
• The Ultimate Series Rx5 head shaver can be used dry or it can be used
with shaving cream or gel in the shower.
TRIMMING
Pop-up Trimmer:
The pop-up trimmer is located at the back of the shaver handle. It can be
used for trimming edges of beards, sideburns or ears.
1. To activate the trimmer, turn the shaver on. Slide down the release
button for the trimmer to pop the trimmer up.
2. Use cutting strokes in the direction opposite of the trimmer’s spring
release.
3. When finished press the trimmer down and snap it back into the
stored position.
Note: Lubricate teeth with oil every 6 months.

7
CLEANING & MAINTENANCE
• The Ultimate Series Rx5 head shaver is designed to collect all the hair
clippings while it cuts. This avoids clippings spilling onto bathroom
counters or shower stalls making clean up easy.
• When cleaning your shaver, make sure it is turned off and
disconnected from the charging adaptor cord.
• The shaver is washable and can be cleaned by rinsing under warm
water.
• When using shaving creams or gels with the shaver it is especially
important to clean after each use to prevent the gel from drying and
clogging the cutters.
• When cleaning the external surfaces of the shaver, do not use strong
detergents or other chemicals.
• To dry, wipe the surface of the shaver with a dry towel. Do not use a
hair dryer or heater to dry the shaver.
• The shaver head and neck assembly is designed to be detachable from
the shaver body. Simply pull upwards from the neck of the shaver for
easy release. To reattach the neck, align it with the neck attachment
cavity so that it clips back into position.

SP4 $
Shaver Saver: Aerosol Spray Cleaner $11.95 AUD $14.95 NZD
Article Price each
AUD
Price each
NZD Qty Amount
$ $ $
Sub Total
Postage &
handling
TOTAL
7.50
$
Replacement Shaving Head & Cutters for HC7000AU SP-HC7000AU $39.95 AUD $44.95 NZD
Spectrum Brands Australia Pty Ltd Locked Bag 3004 Braeside, VIC 3195 Australia
Remington is a Registered Trademark of Spectrum Brands, Inc., or one of its subsidiaries.

CLEANING YOUR SHAVER
1. After every use, hold the shaver over the bin and remove the top of the
cutting head. Remove the head by gripping in the areas between the
four outer cutters and pulling up and away from the handle. (Diagram
A)
2. Tap the excess clippings that have been collected inside the hair
pocket into the bin. (Diagram B)
3. Rinse the cutting head thoroughly by running water through the
cutters from both sides of the head.
4. Rinse the hair pocket under running water.
5. Leave the cutting head detached and let it air dry. Reattach the
shaving head when dry and you are ready for the next use.
(Diagram C)
6. Lubricate the cutters on the inside surface once a week using
Remington Shaver Saver (SP4) to maximise performance.
10
ABC