Remington SR9130 User manual

Featuring Counter Rotating
Pivot & Flex Technology
SR9130
When using an electrical appliance, basic precautions should always be observed,
including the following. Read all instructions before using this shaver.
DANGER
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, CAREFULLY
FOLLOW THESE INSTRUCTIONS:
■ For connection of the power supply unit to a power source not in the U.S.A. and
Canada, use an attachment plug adaptor of the proper configuration for the
power outlet.
■ Do not reach for an appliance that has fallen into water. Unplug it immediately.
■ Do not use while bathing or in the shower.
■ Use only when the shaver is in dry condition.
■ Detach the appliance from the power supply cord before cleaning.
■ Do not submerge in water.
■ Do not place or store this appliance where it can fall or be pulled into a tub
or sink. Do not place or drop into water or other liquid.
■ Except when charging, always unplug this appliance from the electrical outlet
immediately after using.
■ Unplug this appliance before cleaning.
WARNING
To reduce the risk of burns, fire, electric shock, or injury to persons:
■ An appliance should never be left unattended when it’s plugged in, except when
charging a rechargeable appliance.
■ Close supervision is necessary when this appliance is used by, on, or near
children, or individuals with certain disabilities or special needs.
■ Use this appliance only for its intended use as described in this manual. Do not
use attachments not recommended by the manufacturer.
■ Never operate this appliance if it has a damaged cord or plug or if it is not
working properly, if it has been dropped or damaged, or if it has been dropped
into water.
■ Keep the cord away from heated surfaces.
■ Never drop or insert any object into any of the appliance’s openings.
■ Household use only.
■ Do not use outdoors or operate where aerosol (spray) products are being used
or where oxygen is being administered.
■ Always attach the plug to the appliance, then to outlet. To disconnect, turn all
controls to OFF, then remove plug from outlet.
■ Always pull on cord plug to unplug from wall socket. Never pull on electric cord.
■ Do not plug or unplug this appliance when your hands are wet.
■ Do not use an extension cord or a voltage converter with this appliance.
■ Do not wrap the cord around the appliance.
■ Always store this appliance and cord in a moisture-free area. Do not store it in
temperatures exceeding 140°F (60°C).
■ Detach removable power cords from appliance for storage.
■ Do not use this appliance with a damaged or broken head or cutters, as facial
injury may occur.
■ The power unit is intended to be correctly oriented in a vertical or floor mount
position.
■ Shavers, including the trimmer, are for use on facial hair only.They should not
be used for shaving the hair on your head or any other part of your body.
IMPORTANT SAFETY
INSTRUCTIONS
SAvE THESE INSTRUCTIONS
Product Features Which Model Is Yours?
SHAVER PARTS
1. Pivoting head & cutter assembly
2. Head release button
3. Individual flexing heads
4. On/Off push button
5. Power port
1
2
10
3
4
5
6
7
9
8
6. Pop-up trimmer
7. Head guard
8. Power adaptor
9. Cleaning brush
10. LCD screen
Power System
Cord/Cordless – shaver can be used with or without the power cord.
Quick Charge
Shaver will charge long enough for one shave in 5 minutes.
Indicators
LCD Panel – displays the number of minutes of remaining battery power.
– displays when the shaver is charging.
– displays when replacement parts are needed.
Voltage Type
Worldwide Voltage – shaver automatically adapts to an outlet voltage between
100V and 240V.
SR9130
Power System Full Charge
Time
Quick
Charge Indicators Voltage Type
Replacement
Part No.
cord/
cordless 90 mins yes LCD world- wide SP9100
Charging
Before using, read the important safety instructions in front of the manual.
1. Plug power adaptor into shaver. (Diagram A)
2. Plug power adaptor into wall outlet. (Diagram B)
3. Charge shaver for 24 hours. Note: During initial charge ignore the electronic
indicators as they are in "start up cycle". (Diagram C)
4. Use shaver until recharge is required.
CAUTION!
■ Make sure the shaver and your hands are dry when charging the shaver.
■ Always charge the shaver in a cool, dry place.
Shaving
1. Press power button to turn on. (Diagram D)
2. Shave face and neck using short, circular strokes. (Diagram E)
A B C
B
DE
Register Your New Product Today!
By registering your new Remington®product, you will receive these important benefits:
Proof of Ownership • Product Protection • Product Registration • Special Offers
Register online at: www.RemingtonProducts.com
Use and
Care Guide
Become a Fan:
Remington HairCare& Grooming

Weekly:
1. Perform the daily cleaning steps 1 and 2.
2. Place a drop of liquid dish soap on the inside near each cutter. (Diagram M)
3. Apply a small amount of water to each cutter. (Diagram N)
4. Close the head assembly. (Diagram L)
5. Turn the shaver on allowing it to run for several seconds. (Diagram O)
6. While the shaver is running, use your finger to flex the shaver heads multiple
times working the soap into a lather. (Diagram P)
7. Turn the shaver off. (Diagram O)
8. Open the head assembly and rinse thoroughly with water. (Diagram K)
9. Gently shake off excess water, close head assembly, and allow to dry.
(Diagram Q)
**Trimmer: Lubricate teeth with oil every six months.
Replacing Cutters
IMPORTANT: DO NOT attempt to disassemble the cutters. Replacement of
new cutters requires a new head assembly.
To Remove the Rechargeable Battery:
1. Unplug the shaver.
2. Run shaver until motor stops.
3. Remove head from shaver (Press release button and pull head straight away
from shaver body)
4. Using a small screwdriver pry front cover from shaver body.
5. Remove four screws located on front of shaver.
6. Remove rear cover from inner housing to expose batteries.
7. Pry batteries free from circuit board and cut wires.
8. Dispose of batteries.
IMPORTANT: **The head assembly of your rotary shaver is a precision
cutting system. Do not attempt to disassemble the cutters as this will
reduce their effectiveness and void your warranty. To maintain peak perfor-
mance, follow the daily and weekly cleaning instructions below.
NOTE: **When cleaning your shaver, make sure the shaver is disconnected
from the power cord.**
CAUTION!
■ To clean the external surfaces of the shaver, use a damp cloth. Do not use strong
detergents or other chemicals.
■ To dry, wipe the surface of the shaver with a dry towel. Do not use a hair dryer
or heater to dry the shaver.
■ The shaver should not be used until it has dried.
■ Because your satisfaction is important to us, we want to make it simple for you
to keep your new shaver performing at its peak.
■ Did you know that for the best possible shave, it is necessary to replace the
heads and cutters on your shaver every 12 months?
■ Remington makes this easy!
Two Easy Ways to Order!
1. U.S. Residents call 1-800-392-6544
Canadian Residents call 1-800-268-0425
2. Order Online at www.RemingtonProducts.com
1. Pull trimmer release button to engage trimmer. (Diagram F)
2. Trim long, difficult hairs and side burns. (Diagram G)
3. Close trimmer by pressing down. (Diagram H)
■ Ensure your skin is dry and free of oils.
■ Wait at least 15 minutes after getting up before shaving, to ensure your face is
free of puffiness that may be present from sleeping.
■ Always hold the shaver at a right angle to the skin so that all three heads are
touching the skin with equal pressure.
■ Stretch skin with the free hand so hairs stand upright, making it easier for them
to enter the cutting chamber.
■ Use moderate to slow, circular stroking movement.
■ The use of short, circular motions in stubborn areas may obtain a closer shave,
especially along the neck and chin line.
■ Do not press hard against the skin to avoid skin irritation and/or damage to the
rotary heads.
**Remington recommends that you use your new shaver daily for up to four
weeks to allow time for your hair and skin to become accustomed to the
new shaving system**
Shaving Tips
Trim
F G H
The shaver is a washable appliance. The head
assembly part may be cleaned under warm water.
Cleaning & Care Daily:
1. Press the release button on front of shaver and open head assembly. (Diagram I)
2. Tap out excess hair shavings. (Diagram J)
3. Rinse the head of the shaver in running water. (Diagram K)
NEVER submerge the shaver in water!
4. Close head assembly. (Diagram L)
I J K L
M N O P
Q
When your rechargeable shaver reaches the end of its useful life, the Ni-MH bat-
teries must be removed from the shaver and be recycled or disposed of properly
in accordance with your state and local requirements. If this is not required by
law, you may elect to dispose of the shaver with the batteries.
CAUTION! Do not put in fire or mutilate your batteries when disposing as they
may burst and release toxic materials. Do not short circuit as it may cause burns.
Dispose of properly in accordance with your local and state requirements.
Battery Removal
By registering your new Remington®product you will receive these important
benefits:
■ Proof of ownership
■ Product protection
■ Product registration
■ Special offer
Register online at: www.RemingtonProducts.com
Product Registration
How To Order Shaver Accessories
Please refer to the shaver comparison and features chart near the front of
this manual that lists the correct replacement part number for your shaver.
It is very important to replace your head and cutters when necessary to ensure
a close, comfortable shave without irritation. We recommend they be replaced
every 12 months. Here are some signs of head and cutter wear, indicating that
replacement is needed:
■ Irritation: As the heads get excessively worn you may experience some skin
irritation. This would be especially noticeable when you apply moisturizing lotion.
■ Pulling: When the cutters wear you may feel a sense of pulling and a loss of
closeness when you shave. This is an indication that it is time to replace your
heads and cutters.
Maintain your shaver’s peak performance!
Keep Your Shaver Performing Like New!
Limited Two-Year Warranty
Spectrum Brands, Inc. warrants this product against any defects that are due to faulty
material or workmanship for a two-year period from the original date of consumer
purchase.This warranty does not include damage to the product resulting from acci-
dent or misuse. If the product should become defective within the warranty period, we
will replace it free of charge. Return your product and sales receipt with your name,
address and day time phone number to: Remington Returns Center, 507 Stokely Dr.,
P.O. Box 1, Deforest, WI 53532. For more information call 800-736-4648 in the
U.S. or 800-268-0425 in Canada.
Warranty excludes:
■Heads and cutters
KEEP ORIGINAL SALES RECEIPT AS PROOF OF PURCHASE FOR WARRANTY
PURPOSES.
This warranty does not cover products damaged by the following:
■ Accident, misuse, abuse or alteration of the product
■ Servicing by unauthorized persons
■ Use with unauthorized accessories
■ Connecting it to incorrect current and voltage
■ Wrapping cord around appliance causing premature wear & breakage
■ Any other conditions beyond our control
Warranty
Spectrum Brands, Inc. Money-back Offer
If within 30 days after you have purchased your Remington®branded product, you
are not satisfied and would like a refund, return it with the sales slip indicating
purchase price and date of purchase to the retailer from whom it was purchased.
Spectrum Brands, Inc. will reimburse all retailers who accept the product within 30
days from the date of purchase. If you have any questions concerning the money-
back guarantee, please call 800-736-4648 in the US or 800-268-0425 in Canada.
Questions or comments: Call 800-736-4648 in the US or 800-268-0425 in
Canada. Or visit www.RemingtonProducts.com
Dist. by: Spectrum Brands, Inc., Madison, WI 53711
Dist. by: Spectrum Brands Canada, Inc., 4180 Sladeview Crescent,
Mississauga, ON L5L 0A1
Remington is a Registered Trademark of ROVCAL, Inc. a subsidiary of
Spectrum Brands, Inc.
© 2010 ROVCAL, Inc. 08/10 Job #CS40442
Manufactured to Remington’s specifications in the PRC. T22-30689
Performance Guarantee
SPECTRUM BRANDS, INC. SHALL NOT BE RESPONSIBLE FOR ANY INCIDENTAL,
SPECIAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS
PRODUCT. ALL IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO IMPLIED
WARRANTIES OF FITNESS AND MERCHANTABILITY, ARE LIMITED IN DURATION TO
TWO YEARS FROM DATE OF ORIGINAL PURCHASE.
This warranty gives you specific legal rights and you may also have other rights
which vary from state to state or province to province. Some states do not allow the
exclusion or limitation of incidental, special or consequential damages.
NContains
listed adaptor
Contient un
adaptateur
homologué UL