Remington Style Series User manual

Style Series Foil Shaver
F4
I remington-europe.com
Register online for an EXTRA year guarantee
Visit uk.remington-europe.com/product-registration You must register within 28 days of purchase.

e
f
k
j
A
B
g
i
l
C
m

3
Thank you for buying your new Remington® product. Please read these instructions
carefully and keep them safe. Remove all packaging before use.
IMPORTANT SAFEGUARDS
• This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been supervised/instructed and
understand the hazards involved. Children shall not play with the
appliance. Cleaning and user maintenance shall not be done by children
unless they are older than 8 and supervised. Keep the appliance and cable
out of reach of children under 8 years.
• Always check the appliance before you use it. Do not use the appliance if it
is damaged, as this may cause injury.
• The adaptor contains a transformer. Do not cut off the adaptor to replace it
with another plug, as this causes a hazardous situation.
E Suitable for use in a bath or shower.
• WARNING: Detach the device from the charging adapter before cleaning it
in water.
• Do not use the product with a damaged cord. A replacement can be
obtained via our International Service Centres.
• WARNING: For recharging the battery, only use the charger supplied with
the appliance - type reference PA-0505K.
• Always replace a damaged adaptor with one of the original type.
• Do not use the appliance if it is damaged or malfunctions.
• Do not use attachments other than those we supply.
• This appliance should never be left unattended when plugged into a power outlet,
except when charging.
• Keep the power plug and cord away from heated surfaces.
• Do not plug or unplug the appliance with wet hands.
• Do not twist or kink the cable, or wrap it round the appliance.
• This appliance is not intended for commercial or salon use.

4
PARTS
1. On/off switch
2. Foil screens
3. Cutter assembly
4. Charging indicator lights
5. Hairpocket
6. Power port
7. Pop-up trimmer
8. Stubble head guard
Not shown:
9. Adaptor
10. Cleaning brush
GETTING STARTED
CHARGING YOUR APPLIANCE
• It is recommended to fully charge your appliance before using it for the first time.
• Ensure the product is switched off.
• The adaptor automatically adjusts to a main voltage between 100V and 240V.
• Connect the shaver to the adaptor and then to the mains.
CHARGING INDICATOR
Charge Level Indicator
Charging LED will show
Fully charged LED will continue to show
• Run time from fully charged is up to 50 minutes.
• Charge time from empty is 4 hours.
• To preserve the life of your batteries, let them run out every 6 months then recharge
for 24 hours.
INSTRUCTIONS FOR USE
It is recommended that you use your new shaver daily for up to two weeks to allow time
for your beard and skin to become accustomed to the new shaving system.
• Make sure your shaver is properly charged.
• Switch the shaver on by pressing the on/off switch.
SHAVING
• Stretch the skin with your free hand so the hairs stand upright.
• Hold the shaving head so that the foils touch your face.
• Use short linear strokes.

5
TRIMMING
• Slide up the trimmer release button to activate the trimmer.
• Hold the trimmer at a right angle to your skin.
• To retract the trimmer, push the top rear of the trimmer down until it locks under
the trimmer release button.
STUBBLE LOOK
Fit the stubble head guard to your shaver for a 3-day stubble look.
TIPS FOR BEST RESULTS
• Always hold the shaver at right angles to the skin so that all foils are touching the
skin with equal pressure.
• Use moderate to slow stroking movements. The use of short linear motions in
stubborn areas may obtain a closer shave, especially along the neck and chin line.
• DO NOT press hard against the skin in order to avoid irritation and damage to the
foil heads.
CLEANING AND MAINTENANCE
Care for your appliance to ensure a long lasting performance. We recommend you clean
your appliance after each use.
The easiest and most hygienic way to clean the appliance is by rinsing the appliance
head after use with warm water.
1. Remove the shaver head (pull the head up and off FIG A).
2. Tap out the excess hair shavings and rinse the foils under running water (Fig B, C).
3. Do not clean the shaving foil with a brush.
4. Replace the head assembly by placing the assembly on top of the hair pocket, press
down and click into place.
• Lubricate the teeth of the trimmer every six months with a drop of sewing machine
oil.
REPLACING THE FOILS AND CUTTERS
• To ensure continued high quality performance from your shaver, we recommend
the foils and cutters are replaced regularly.
SIGNS THAT YOUR FOIL/S AND CUTTER/S NEED REPLACING:
• Irritation: as foils get worn, you may experience skin irritation.
• Pulling: as the cutters wear, your shave may not feel as close and you may feel the
cutter pulling your hair.
• Wear through: you may notice that the cutters have worn through the foils.