Remington D2056AU User manual

1
2 YEAR WARRANTY D2056AU
STUDIO STYLES
PRO PACK
USE & CARE
MANUAL
PLEASE READ
PRIOR TO USE
Anti stAtiC
iOn geneRAtOR
90% mORe iOns fOR less fRizz*
eVen HeAt

2
IMPORTANT SAFEGUARDS
Warning: Do not use this appliance near bath tubs, showers,
basins or other vessels containing water.
When using electrical appliances, especially when children
are present, basic safety precautions should always be
followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING
For additional protection, the installation of a residual current
device (RCD) having a rated residual operating current not
exceeding 30 mA is advisable in the electrical circuit
supplying the bathroom. Ask your installer for advice.
KEEP AWAY FROM WATER
DANGER – As with most electrical appliances, electrical parts
are electrically live even when the switch is off.
To reduce the risk of death by electric shock:
• Always unplug it immediately after using.
• Do not place or store an appliance where it can fall or be pulled
into a bath or sink.
• Do not use while bathing.
• Do not place or drop into water or other liquid.
• If an appliance falls into water, “unplug it” immediately. Do not
reach into the water.
WARNING – TO REDUCE THE RISK OF BURNS,
ELECTROCUTION, AND FIRE, OR INJURY TO PERSONS.
• An appliance should never be left unattended when plugged in
to a power outlet.
• When the hairdryer is used in a bathroom, unplug it after use
since the proximity of water presents a hazard even when the
hairdryer is switched off.

3
• This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
• Children should be supervised to ensure they do not play with
the appliance.
• Use this appliance only for its intended use as described in this
manual. Do not use attachments not recommended by
Remington.
• Never operate this appliance if it has a damaged cord or plug,
if it is not working correctly, if it has been dropped or damaged,
or dropped into water. If the supply cord or plug of this hair
dryer is damaged it must only be replaced by a qualified
electrical tradesperson.
• Keep the cord away from heated surfaces.
• Do not use on people who are sleeping.
• Never drop or insert any object into any opening of this
appliance.
• Do not use outdoors or where aerosol (spray) products are
being used or where oxygen is being administered.
• Do not direct hot air towards the eyes or other heat sensitive
areas.
• Attachments, where provided, may be hot during and after use.
Allow them to cool before handling.
• When using the appliance, keep your hair away from the air
inlet grille. Do not let your hair get drawn into the appliance.
SAVE THESE INSTUCTIONS

KEY PARTS
4
D2056AU STUDIO STYLES PRO PACK
Use & Care Instruction Manual
Thank you for purchasing your new Remington® Studio Styles hair
dryer. This hair dryer is a 2200 watt hair dryer and features ceramic
+ tourmaline ionic for anti static and even heat, and an ioniser that
emits 90% more ions for less frizz* and enhanced shine. The pack
includes a translucent concentrator and diffuser and a volumising brush.
1. Translucent concentrator
2. Air inlet grille with
removable filter
3. Hang loop
4. Heat Settings
Low heat
Medium heat
High heat
5. Speed Settings
O – Off
x – Low speed
X – High speed
6. Cool shot
7. Air outlet grille
8. Ceramic + tourmaline grille
9. Ionizer
10. Translucent diffuser
11. Volumising brush
1
3
2
6
10
11
9
7
5
4
8

5
CERAMIC + TOURMALINE IONIC TECHNOLOGY
Tourmalines are precious gemstones with highly unique properties.
Heating crushed tourmalines results in the powerful natural emissions
of ions and far-infrared heat. Remington puts tourmaline technology
to work in this powerful hair dryer to reduce static and frizz.
IONIC HYDRATING TECHNOLOGY
The hair dryer emits 90% more ions *. This allows the hair cuticle
to lie flat which reduces static and frizz and creates a healthy shine,
therefore giving the hair a more nourished look and smoother finish.
COOL SHOT
This hair dryer is equipped with a cool shot, which is used to hold
your hairstyle. Press and hold the cool shot button to rapidly cool and
hold your hair once it has been styled.
BASIC HAIR CARE INSTRUCTIONS
For optimal results, shampoo and condition your hair prior to styling
and towel dry to remove excess moisture.
QUICK DRYING
Select a high or medium heat and a high speed setting and roughly
dry hair. Use a brush or your hand to shake out excess moisture
whilst drying and keep the hair dryer in constant motion.
STRAIGHTENING
Select high or medium heat and a high speed setting and roughly dry
the hair. When the hair is nearly dry, attach the concentrator (which
minimises frizz) and reduce the heat and speed. Section the hair
according to thickness and begin with straightening bottom layers
first. Using a brush, follow the brush with the concentrator from
above, while slowly gliding down the each section of hair from roots
to tips. Once bottom layers have been straightened, then straighten
the mid section and complete by straightening top layers.

6
NATURAL WAVY TEXTURE
Using the hair dryer on a low or medium heat and a low speed
setting, ‘Scrunch’ sections of hair with your fingers into the palm of
your hand, while directing airflow through your fingers. Once you
have achieved the desired effect, use the cool shot on each section
of hair to hold style. For more volume lean forward and dry the hair in
the upside down position.
LIFT & VOLUME
Using hair dryer on a medium to high heat and a high speed setting,
work from the roots of hair and begin at the back of the head.
Section your hair and use brush or fingers to dry against its natural
growth pattern. This creates lift at the roots, which creates a style
with volume.
STYLING
Attach the concentrator, for precision drying, and select a medium or
low heat setting and a low speed setting. Section the hair, and style
using a brush. Concentrate the airflow directly on the hair while
styling in the direction you desire. If necessary, hold the airflow for
2-5 seconds on each section while curling under or over for
additional hold.
USING THE DIFFUSER
This hairdryer comes with a professional style diffuser. This diffuser
dries hair fast without blowing out the style. Perfect for naturally curly,
permed and fine hair, or to give your hair a boost of volume.
DRY YOUR HAIR USING THE HAIR DRYER DIFFUSER
Dry your hair beginning at the roots and using circular motions,
always moving in the same direction. Use the diffuser with the hair
dryer set at low speed. Continue drying, keeping the hair dryer at a
90-degree angle from scalp. This will lift the roots away from the
scalp giving your hair volume. Finish by drying the ends.

7
ADD VOLUME TO YOUR HAIR USING A DIFFUSER
To add volume to your hair, dry it upside down so that the roots fall
away from your scalp. Use the diffuser with the hair dryer set at low
speed. Point the hair dryer at the roots to give your hair maximum
volume. Continue the process to the ends of your hair.
Note: Always select the lowest heat setting when using the diffuser,
as damage may occur to the diffuser if higher heat settings are used.
USER INSTRUCTIONS
This hair dryer is equipped with a thermostat that will cycle `OFF’ if
the temperature exceeds the comfort level due to partially blocked air
inlet or air outlet grilles. In the event that the hair dryer stops during
use turn off all switches and allow the hair dryer to cool down, at
which time the thermostat will automatically reset. Before using again,
check that the air inlet and air outlet grilles are not blocked. Unplug
the hair dryer and clean the openings if necessary. During use, do not
block the air openings or let your hair be drawn into the hair dryer.
MAINTENANCE
Your hair dryer is designed for household use and is virtually
maintenance free. No lubrication is needed. When cleaning becomes
necessary, turn all switches off and disconnect the hair dryer from the
power outlet.
To maintain peak product performance, it is important to clean the air
inlet grille and filter at the back of the dryer. To access the air inlet
grille and filter, simply place your thumb under the lug at the top of
the air inlet retaining ring and pull outwards. This will release the air
inlet grille. The filter can now be cleaned with a soft brush or a
vacuum cleaner. When clean, replace the filter and click the air inlet
grille back into place. The exterior of the hair dryer can be cleaned by
wiping it with a damp cloth.

8
This product is not suitable to use in a bath or shower.
This product conforms to radio frequency interference requirements.
Any product purchased and used commercially carries a limited 90
Day Warranty.
*vs. standard Remington hair dryer
STORAGE
When not in use, always unplug the hair dryer from the power outlet.
Allow the hair dryer to cool and store out of the reach of children in a
safe dry place. Never wrap the power cord around the hair dryer since
this will cause the cord to wear prematurely and break. Handle the
cord carefully for long life and avoid jerking, twisting or straining
especially at the plug connections. If the cord becomes twisted in use,
periodically straighten it.
You may also use the hang loop to store the hair dryer within
convenient reach, ensuring that water cannot be splashed on to it
when it is hung up.

910
Spectrum Brands Australia Pty Ltd and Spectrum Brands New Zealand Limited
WARRANTY AGAINST DEFECTS
In this warranty:
Australian Consumer Law means the Australian consumer law set out in Schedule 2
to the Competition and Consumer Act 2010;
CGA means the New Zealand Consumer Guarantees Act 1993;
Goods means the product or equipment which was accompanied by this warranty and
purchased in Australia or New Zealand, as the case may be;
Manufacturer, We or us means:
1. for Goods purchased in Australia, Spectrum Brands Australia Pty Ltd
ACN, 007 070 573; or
2. for Goods purchased in New Zealand, Spectrum Brands New Zealand Limited,
as the case may be, contact details as set out at the end of this warranty;
Supplier means the authorised distributor or retailer of the Goods that sold you the Goods
in Australia or in New Zealand; and
You means you, the original end-user purchaser of the Goods.
1. Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law, or the CGA. You are entitled to a replacement or refund for a major failure
and compensation for any other reasonably foreseeable loss or damage. You are also
entitled to have the goods repaired or replaced if the goods fail to be of acceptable
quality and the failure does not amount to a major failure.
2. The benefits provided by this Warranty are in addition to all other rights and remedies in
respect of the Goods which the consumer has under either the Australian Consumer Law
or the CGA. The original purchaser of the Goods is provided with the following Warranty
subject to the Warranty Conditions:
3. We warrant the Goods for all parts defective in workmanship or materials for the period
of two (2) years from the date of purchase (Warranty Period). If the Goods prove
defective within the Warranty Period by reason of improper workmanship or material, we
may, at our own discretion, repair or replace the Goods without charge.
Warranty Conditions
4. The Goods must be used in accordance with the manufacturer’s instructions. This
Warranty does not apply should the defect in or failure of the Goods be attributable
to misuse, abuse, accident or non-observance of manufacturer’s instructions on the
part of the user. As far as the law permits, the manufacturer does not accept liability
for any direct or consequential loss, damage or other expense caused by or arising
out of any failure to use the Goods in accordance with the manufacturer’s instructions.
5. Exhaustible components (such as shaver heads, cutters and foils) of the Goods
are included under this Warranty only where there is a defect in workmanship or
materials used.
6. The warranty granted under clause 3 is limited to repair or replacement only.
7. Any parts of the Goods replaced during repairs or any product replaced remain the
property of the manufacturer. In the event of the Goods being replaced during the
Warranty Period, the warranty on the replacement Goods will expire on the same date
as for the Warranty Period on the original Goods which are replaced.

10
8. In order to claim under the warranty granted under clause 3 you must:
(a) Retain this warranty with your receipt/proof of purchase; and
(b) Return the Goods to us at the relevant address below or to the Supplier by prepaid
freight within the Warranty Period accompanied with (i) the legible and unmodified
original proof of purchase, which clearly indicates the name and address of the
Supplier, the date and place of purchase, the product name or other product serial
number and (ii) this warranty.
9. This warranty is immediately void if:
(a) Any serial number or appliance plate is removed or defaced;
(b) The Goods have been serviced or otherwise repaired by a person not authorised to
do so by us or where non approved replaced parts are used.
10. The Goods are designed for domestic use only. A limited 90-day Warranty applies to any
industrial or commercial use of the Goods. The Goods must be connected to the electrical
voltage requirements as specified in the ratings label located on the Goods.
11. This warranty does not cover the cost of claiming under the warranty or transport of the
Goods to and from the Supplier or us.
12. This warranty is only valid and enforceable in Australia against Spectrum Brands
Australia Pty Ltd and in New Zealand against Spectrum Brands New Zealand Limited.
Contact us or the Supplier for further details.
Spectrum Brands Australia Pty Ltd
Chifley Business Park
1 Chifley Drive
Mentone, VIC 3194 Australia
Customer service in Australia: 1800 623 118
E-mail: consumer.enquir[email protected]
Website: www.remington-products.com.au
Spectrum Brands New Zealand Limited
Building C, Ground Floor
600 Great South Road,
Greenlane, Auckland 1051 New Zealand
Customer service in New Zealand: 0800 736 776
E-mail: [email protected]
Website: www.remington-products.com.au
REMINGTON SERVICE HOTLINE

Australia 1800 623 118 (toll free)

New Zealand 0800 736 776 (toll free)
AUTHORISED REPAIR CENTRES
Visit www.remington-products.com.au for Authorised repair centre details.
® Registered Trade Mark of Spectrum Brands, Inc., or one of its subsidiaries
©2012 SBI
Rev. 05/12
Part No. T22-0000406