repabad Kampen User manual

OPERATING INSTRUCTIONS
for baths with Aqua-Comfort
0037857-00_BEDBWAC © 12/2021 repaBAD GmbH
Always read the operating instructions carefully before using the bath with Aqua-Comfort!
Make sure that you observe the care instructions!
Repabad cannot be held liable for damages caused by inappropriate use.

20037857-00_BEDBWAC 12/2021 • repaBAD GmbH • We reserve the right to make technical changes. All dimensions in cm.
CONGRATULATIONS!
You have chosen an innovative, premium product from Repabad.
Our products combine impressive technology with ease of use.
Please read these operating instructions carefully, so that you can best use the bath with
Aqua-Comfort to improve your well-being and enjoy the product for many years to come.
Gunther Stolz
Managing Director, Repabad GmbH
Introduction

3
0037857-00_BEDBWAC 12/2021 • repaBAD GmbH • We reserve the right to make technical changes. All dimensions in cm.
01 SAFETY INFORMATION 4
02 WELLNESS TIPS 4
03 DESIGN 5
04 BEFORE USE 5
05 DURING USE 5
Safety shutdown 5
Loudspeaker safety shutdown 6
06 AFTER USE 6
07 MANUAL BLOW-OUT 6
08 DISINFECTION 6
09 SERVICING 7
Cleaning the nozzles 7
10 NOZZLE FUNCTION AND STRUCTURE 7
11 CLEANING THE DRAIN FILTER, ADJUSTING THE DRAIN PLUG 8
12 TROUBLESHOOTING TECHNICAL PROBLEMS 8
13 TECHNICAL DATA 8
14 HOW TO BATHE CORRECTLY WITH AQUA-COMFORT 9
The rules 9
Effect on the body and wellness 9
Aromatherapy 10
Rules for aromatherapy 10
Aromatherapeutic bath additives 10
Effects of the bath additives 11
WARRANTY CARD 12
Table of contents

40037857-00_BEDBWAC 12/2021 • repaBAD GmbH • We reserve the right to make technical changes. All dimensions in cm.
01 SAFETY INFORMATION
The human body nds a water temperature between 35 and 36°C to be most pleasant.
At a water temperature of 36°C, the bath duration should not exceed 20 minutes. At a water temper-
ature of 38°C, you should bathe for no more than 10 minutes.
In order to become accustomed to the invigorating massage effect, keep the massage time
short
initially. The massage duration can be increased over time to suit your preference. After use, you should
rest for at least as long as the time spent bathing.
02 WELLNESS TIPS
General
Danger to life! Danger of electric shock!
Ensure that no electrical devices are operating within the bath or in
close proximity while using it. If an electrical device that is plugged in
comes into contact with the water or oneself when bathing, fatal electric shocks
may occur.
With appropriate supervision, this product can be used by children
from age 8 and persons with reduced physical, sensory or metal
capacity, as well as those without knowledge and experience of the
product. Do not allow children to play with the product. Do not allow
children to clean and perform maintenance on the product without
supervision.
The bath with Aqua-Comfort can be used by anyone with a healthy cardiovas-
cular system. If you are uncertain in this regard or if you have questions, please
consult your doctor.
Do not use the bath with Aqua-Comfort if you are suffering from cold-like
symptoms, infectious diseases, open wounds or inammation. We recommend
waiting until you have fully healed before using it.
Only use Repabad bath additives. Using other bath additives
risks damaging
the Aqua-Comfort system.
Depending on the frequency of use, you should disinfect the bath with
Aqua-Comfort approximately every 4 weeks. Only use Repabad disinfectant.
If other agents are used, there is risk of damage to the bath.
The installation instructions are part of the operating instructions,
and must be stored together with them.

5
0037857-00_BEDBWAC 12/2021 • repaBAD GmbH • We reserve the right to make technical changes. All dimensions in cm.
03 DESIGN
04 BEFORE USE
05 DURING USE
The bath with Aqua-Comfort system is equipped with a  xed fan installed under the bathtub and
a jet pump. The Champagne nozzles (combined air and water nozzles) are located at the base of
the bathtub. When the Aqua-Comfort system is activated, these nozzles convey preheated air from
the fan into the bath, while the pump generates  ne jets of water. This creates tiny air bubbles for a
pleasant and relaxing massage. At the same time, the therapeutic nozzles massage your back and
feet with water.
The jet pump and fan are controlled via a control panel on the side of the bathtub.
- Rinse out the bath with cold water.
- Close the bathtub drain.
- Fill the bath with hot water.
Important: Since water must  ll part of the piping system before the bathtub can be  lled, it takes
some time for the water to visibly collect in the tub.
To enable the use of Aqua-Comfort,  ll the bath up to around the over ow with the user(s) inside.
Press the key on the side of the bathtub once to switch
on the pump and the fan together.
The LED illuminates when the system is switched on.
Press the key again to switch the system off.
If the LED  ashes when you press the key and only the
fan starts,
there is not enough water in the bath. In this case, add more water.
Safety shutdown
The pump switches off automatically 20 minutes after activation.
The pump remains in standby mode and can be reactivated at any time.
Operation

60037857-00_BEDBWAC 12/2021 • repaBAD GmbH • We reserve the right to make technical changes. All dimensions in cm.
Loudspeaker safety shutdown
Whirlpool loudspeakers (a special accessory) are equipped with overload protection.
If the volume of the connected music system is set too high, overload protection is activated.
This results in the loudspeakers becoming considerably quieter or even being switched off. In this case,
the volume of the music system must be reduced immediately. After a short period the loudspeakers
will work normally again.
06 AFTER USE
07 MANUAL BLOW-OUT
08 DISINFECTION
First steps
- Turn off the system
- Open the bathtub drain and drain the water out completely
- Rinse out the bathtub with hot water
Automatic blow-out
- The air pipes are automatically dried after the bath is completely drained.
This is indicated by a double ashing of the indicator light.
- The fan is automatically de-activated after the end of the blow-out time (approx. 20 min.).
Afterwards
- Dry the nozzles and bathtub using a soft, non-abrasive and lint-free cloth
- Leave the bathtub drain open
- When the bathtub is empty, press the key once to switch on the fan. The LED ashes.
This manually blows out the pipes.
Press the key again to switch the fan off.
Disinfectants cause skin irritation!
Ensure that you observe the safety instructions on the label of the disinfectant!
Keep disinfectants out of reach of children! You must not bathe in the bath
whilst it is being disinfected!
Usage / Disinfection

7
0037857-00_BEDBWAC 12/2021 • repaBAD GmbH • We reserve the right to make technical changes. All dimensions in cm.
10 NOZZLE FUNCTION AND STRUCTURE
To enable cleaning, you can unscrew the nozzle inserts using the
special keys (Champagne nozzles: art. no. 0035112, therapeutic
nozzles: art. no. 0034796):
- To remove the inserts (1), carefully insert the metal pins of the
key (2) into the holes on the nozzle caps, and unscrew in an
anti-clockwise direction.
Do not twist or remove the nozzle body (3)!
- Screw the nozzle insert (1) back in
ush with the chrome ring.
Removing the nozzle inserts (1) does not negatively
affect the seal of the bath.
2
3
1
3
1
09 SERVICING
Cleaning the nozzles
If required, remove the lime scale deposits on the nozzles using Repabad “Special cleaner” (art. no. 0010276).
Depending on the frequency of use, you should disinfect the bath roughly every 4 weeks.
Only use Repabad disinfectant. If other agents are used, there is risk of damage to the bath.
Make sure the bath is lled up to at least 5 cm above the nozzles before disinfection!
- Add disinfectants to the water after bathing:
Use approx. 80 - 500 ml, depending on the bathtub size (concentration 100 ml to 100 l of water).
- Let the disinfectant solution react for approx. 30 minutes.
- During this time, allow the pump and the fan to run 3 times for 1 or 2 minutes.
Switch off the bath, open the bathtub drain and let the disinfectant solution drain out.
- The key ashes until automatic blow-out.
- After blow-out, dry the nozzles and bathtub using a soft, non-abrasive and lint-free cloth.
- Leave the bathtub drain open.
Servicing / nozzles
Champagne nozzle Therapeutic nozzle

80037857-00_BEDBWAC 12/2021 • repaBAD GmbH • We reserve the right to make technical changes. All dimensions in cm.
Connection Via separately connected electricity supply
Separate 2-pin residual current
circuit breaker mandatory:
RCD with I Δ N ≤ 30 mA (overvoltage category III)
Supply voltage 230 V AC, 50 Hz
Fuse without 16 A-B for 3 x 1.5 mm² supply line
supplementary heating
Connected load 1.3 kW
13 TECHNICAL DATA
Servicing / technical data
12 TROUBLESHOOTING TECHNICAL PROBLEMS
PROBLEM
1.No display on control panel
2.
Key ashes when pressed
and fan starts
3. Key double ashes
during/after draining.
4.Both pump and
fan switch off
automatically.
5.
Irregular water pump
suction. Fluctuating
water nozzle output
SOLUTION
- Check the electricity supply
- Not enough water in the bath
- Fill up the bath to approx. 5-8 cm above the top nozzles
- Automatic blow-out active, fan starts after
timer period.
- The system switches off automatically after around
20 min. via a timer. You can then reactivate it
immediately.
- Not enough water/water loss (see 2.)
- Drain outlet is blocked/drain plug is incorrectly positioned.
Tighten the adjustment screws by approx. 2-3 mm.
- Adjust at the plug (see section 11)
- Remove the drain cover (4) together with the drain plug (5)
by lifting it upwards
Attention: The plug is only loosely tted, it can
fall out and damage the bath
- Clean the lter (6)
-
You can adjust the drain plug using the adjustment screw (7)
4
5
7
6
11 CLEANING THE DRAIN FILTER,
ADJUSTING THE DRAIN PLUG

9
0037857-00_BEDBWAC 12/2021 • repaBAD GmbH • We reserve the right to make technical changes. All dimensions in cm.
14 HOW TO BATHE CORRECTLY WITH AQUA-COMFORT
Immerse yourself in pleasantly hot water. The massage relaxes your muscles, relieving tension.
It stimulates the metabolism, has a positive effect on the vegetative nervous system, the brain releases
“happy hormones” – you feel good all over.
We have compiled a few tips here that will help you better understand the positive effect
of the
Aqua-Comfort on body and mind, along with information on how to use these functions correctly .
The rules
1. The feeling and experience of the Aqua-Comfort function varies depending on the combination
of time, massage and water temperature. Choose a short, cool massage to leave the bath feeling
refreshed. A longer and warmer massage leaves one feeling relaxed and calm.
2. Scented oils have a lasting effect, depending on the feeling desired. If you wish to feel invigorated
after bathing, use an energising aroma such as eucalyptus or lemon.
Only use appropriate bath additives that produce little to no foam.
Effect on the body and wellness
- The connective tissue, muscles etc. feel weightless and
therefore tension-free.
- The heat and moisture open the pores of the skin.
- The heat relieves tension and cramps, and
gives a relaxed massage.
- The temperature on the surface of our skin determines how we
feel.
- As a result of the opened pores, the skin’s oxygen intake increases.
- The oxygen is transported better due to the even stimulation of blood ow.
- The aroma substances are both transported through the air and absorbed more effectively.
- The massaging movement has a relaxing effect, stimulating circulation.
- The high humidity soothes the respiratory tract, stabilising the mucous membranes.
Bathing tips

10 0037857-00_BEDBWAC 12/2021 • repaBAD GmbH • We reserve the right to make technical changes. All dimensions in cm.
Aromatherapy
Aromatherapeutic bath additives improve physical and mental
well-being. Some aroma molecules penetrate the skin and then
produce their effect, others stimulate the nerve endings when
inhaled.
The nose registers the aromatic signals in just 2 seconds and passes
them on to the part of the brain responsible for the memory and
emotions.
Aromatherapeutic bath additives remain in the air for approximately 15 minutes; the nose becomes
accustomed to the aroma quickly and stops transmitting scent signals. Nonetheless, you should not
put more bath additives in the bath water. The concentration is sufcient to achieve the desired reac-
tion. Too many aroma signals have the opposite effect.
Rules for aromatherapy
Only add aromatherapy bath additives once the bath is full and
stir thoroughly so that the oil droplets are distributed evenly.
Once the body has absorbed aromatherapeutic bath additives via the skin, they remain effective
for approximately 4-6 hours, provided no alcohol or beverages with caffeine are consumed.
Aromatic steam evaporates, so always close the door and windows in the bathroom if
aromatherapeutic bath additives are used.
If the water temperature is high, the oil penetrates the skin more easily, so be careful with dosage
if bath additives are used in hot bath water.
Aromatherapeutic bath additives
Bath additives from Repabad are ideally suited for use in baths with Aqua-Comfort and whirlpools,
as they only foam a little and leave no deposits in the system. Their proportions of essential oils make
them ideal care for the body and soothing to the soul. Selection: Mountain Pine, Eucalyptus, Camo-
mile, Lavender, Mango, Rose Garden and Lemon Grass.
Please note:
The tips listed above are general recommendations.
If you have health problems, please consult a doctor rst.
Bathing tips / aromatherapy