Resilite Pre-Elite Low Beam User manual

Pre-Elite Low Beam
Assembly Instructions
PO Box 764, Sunbury PA 17801
Call Toll Free: 1-800-THE-MATS or 1-800-843-6287
Fax: [phone] • E-mail: [email protected]
Web Site: www.resilite.com
09/10 SPT100025 - REV 4/14
Because of the nature of the sport, the possibility of serious injury is
inherent in gymnastics. The equipment is intended for use only by
properly trained and qualified participants under the supervision of
and in accordance with the guidance of a trained and qualified
instructor. When using any mat or training equipment know your
limitations and the limitations of your equipment. Before performing
maneuvers, always make sure that there is enough space to properly
and safely perform the chosen maneuver. Keep your equipment in
good condition by inspecting for loose fittings or damage and test
for stability before each use.
WARNING
Recommendations Before Using
• Resilite Folding Mats should always be
positioned under the Pre-Elite Low Beam.
• The Pre-Elite Low Beam must be used on
a stable, level floor.
• Check to be certain that the beam
sections are securely fastened togther.
• Periodically check and reposition the
beam sections as needed.
• Use this mat ONLY
under the supervision
of or in accordance with
the guidance of a trained and
qualified instructor.

STEP 2
Once the Beams are laying flat and have
been pushed tight together, Loop the
velcro strap through the D-ring and
securely fasten the beam sections together.
Pre-Elite Low Beam
Thank you for purchasing Resilite’s Pre-Elite Low Beam. This beam is
manufactured in two (2) 4-ft long sections for easy handling and storage.
Each section quickly and easily connects together with a D-ring and velcro
strap. No tools required. The Pre-Elite Low Beam features a synthetic suede
working surface that has the look and feel of a regulation beam.
We hope you enjoy this exciting and innovative product!
STEP 1
Place the two beam body sections, end-to-end, on a flat, stable surface.
Be sure to align the two ends with the connection straps.
(1 section will have a D-Ring, the other, a Hook-and-Loop
fastebning strap)
Your New Pre-Elite
Low Beam Includes:
• Two (2) 4-ft long sections.
Each Section:
4” top x 9” wide base
• Built-in D-ring connectors
and Hook-and-Loop
fastening straps.
* Additional 4-ft long
Pre-Elite Low Beam Extension
sections may be ordered to extend the length of your beam.
-- 12-ft long beam shown above using one 8-ft Pre-Elite beam
and one 4-ft beam extension section ( sold separately ).
www.resilite.com / 1-800-843-6287