REV.247 REV1200 User manual

REV1200 - ASSEMBLY MANUAL
PACKING LIST
Frame
Column
Long feet
End pipe
Outer pipe
Connection pipe
Cable clamp
Rubber grip
Rubber washer
Hole cap
Screws
Screw for motor house / Outer pipe, M6x16mm
Screw for feet, M10x16mm
Tailstock for connection pipe, M10x20mm
Screw for tabletop, Ø5x20mm
Screw for hand control, Ø4x22mm
pcs
2
2
2
4
2
8
4
18
4
pcs
8
8
8
14
2
Maximum 6Nm
Maximum 10Nm
Maximum 10Nm
< 6Nm
Tightening torque
Tailstock
Screw for motor house and outer pipe
Screw for feet and tabletop
Screw for hand control
Make sure all screws are tightened, also after a period of use!
Reset the desk before use
Press both up and down buttons at the same time for 3 seconds.
Continue pressing the buttons until both columns are in lowest
position. When finish reset, the control box makes a sound and
the buttons can be released. Now the system is operational.
WARNING
Carefully arrange all the cables not to be damaged by tabletop
screws.
PACKING LIST
Frame
Column
Short feet
Short Outer pipe
Outer pipe
Connection pipe
Cable clamp
Rubber grip
Rubber washer
Hole cap
Control box / Hand control
AC cable
Motor Extension cable
Hand control
Control box
Screws
Screw for motor house / Outer pipe, M6x16mm
Screw for feet, M10x16mm
Tailstock for connection pipe, M10x20mm
Screw for tabletop, Ø5x20mm
Screw for control box, M4x6mm
pcs
1
1
2
2
2
6
2
6
2
pcs
1
1
1
1
pcs
4
4
6
8
2
Step 1
1
Step 2
Step 4
Step 3
www.rev-247.com | 800.743.7738

x14
Adjust frame length
Step 8
Step 10
Step 9
x12
Step 5
Step 7
Step 6
2
www.rev-247.com | 800.743.7738

x22
x2
Step 11
Step 13
Step 12
3
x12
Step 14
Step 15
www.rev-247.com | 800.743.7738