25
III. Warnings
1. The reVive is an electrical device. To avoid electrical shock:
a. Do not wash unit with water.
b. Do not touch the plug or device with wet hands.
c. Do not touch unit to wet skin.
d. Do not use if cord or plug appears to be damaged.
e. Do not use the unit if it has been dropped, damaged, left
outdoors, or dropped into water.
f. Do not pull, lift, or carry unit by the power cord.
g. Do not use the cord as a handle, close a door on the cord, or
pull the cord against sharp edges or corners.
h. Do not use near heated surfaces.
2. Do not operate the unit in areas where flammable or combustible products
or vapors may be present. Explosion or fire may occur.
3. Do not allow children to use – this is not a toy. Do not leave small
children unattended close to unit.
4. Not to be used by disabled, sleeping or unconscious persons.
5. Do not use the unit on an open wound, as heat may increase circulation
and cause bleeding.
6. Do not use over thyroid gland (the neck area) if the user has been
diagnosed with or suspects thyroid problems. No clinical data is available
to support use for patients with thyroid gland problems.
7. Do not use with liniments, salves or ointments that contain heat-
producing ingredients as a skin burn could result.
V. ASSEMBLY INSTRUCTIONS
(Continued)
5. Push Power button to start device
6. Press Power button to stop device
VI. Technical Specifications
• ONLY USE SUPPLIED AC Power Supply.
• Device includes only an on/off switch; all settings are set at the factory.
• Unplug system when not in use.
• Inspect power supply cords and all cables for fraying.
• Inspect LEDs to determine if any are broken.
• The reVive is NOT user serviceable.
♦Operating Temperature: 0°C to +27°C (32°F - 80°F)
♦Relative Humidity: 85%
♦Storage Temperature Range: -30°C to +55°C (-22°F to +130°F)
♦Wavelengths: Infrared LED 880nm, RED LED 660nm
♦Power: 12 Watts, Range 8-55/mWcm² - maximum output 55/mWcm²
VII. Cleaning Instructions
• Clean unit monthly with rubbing alcohol and cotton cloth.
Allow system to cool before applying rubbing alcohol.
• Allow alcohol to dry before use.
2. Attach Head.
Align Notches and insert Head into handle (1)
Turn Head clockwise (2)
until it locks in place.
3. Attach Power supply to
handle base.
4. Plug Power Supply into electrical outlet