Rezek BLISS 13 User manual

Artemide inc.
1980, New Highway, Farmingdale (NY) 11735
T. [phone] | [email protected] | www.artemide.net
Artemide Ltd.
11105, rue Renaude Lapointe, Montréal (QC) H1J 2T4
T. [phone] | [email protected] | www.artemide.net 1
BLISS 13
WALL/CEILING Assembly instructions rev 0.1
Attention: Read and understand these instructions before installing xture. This xture is intended for
installation in accordance with National Electric Code and local regulation: To assure full compliance with
local codes and regulations, check with your local electrical inspector before installation. This equipment
is guaranteed only when used as indicated in these instructions; Therefore they should be kept for future
reference. To prevent electrical shock, turn off power supply before carrying out any connection or
maintenance operations.
STEP 1 Make sure you have all the elements of the xture
Your box should contain the following parts
ø5” J-Box Mounting plate
Universal plate
Complete Bliss
assembled to be mounted
STEP 2 Disasemble the xture
1. Remove the two diffusers 2. Loosen nuts on the threaded pins
3. Remove the front plate
2.1
2.1
2.3
2.2

Artemide inc.
1980, New Highway, Farmingdale (NY) 11735
T. [phone] | [email protected] | www.artemide.net
Artemide Ltd.
11105, rue Renaude Lapointe, Montréal (QC) H1J 2T4
T. [phone] | [email protected] | www.artemide.net
2
BLISS 13
WALL/CEILING Assembly instructions rev 0.1
STEP 3 Fix the xture to the wall/ceiling
1. Fix the universal plate to the J-Box
(Screws not supplied)
2. Remove the back plate from the xture by unscrewing
the two screws
3.1
3.1
3.2
3.2
STEP 4 Install the xture
1. Through the mounting plate, make the
appropriate electrical connection
2. Fix the mounting plate and back plate to
the J-Box
(screws not supplied)
3. Fix the xture to the back plate through the two screws
unscrewed at STEP 3.2
4. Install the lamp
4.1
4.3
4.3
4.2
4.4

Artemide inc.
1980, New Highway, Farmingdale (NY) 11735
T. [phone] | [email protected] | www.artemide.net
Artemide Ltd.
11105, rue Renaude Lapointe, Montréal (QC) H1J 2T4
T. [phone] | [email protected] | www.artemide.net 3
BLISS 13
WALL/CEILING Assembly instructions rev 0.1
STEP 5 Reinstall the complete xture
1. Reinstall the front plate by slipping the
threaded pins into the slots in the bracket
2. Secure by tightening the nuts
3. Reinstall the 2 diffusers by snapping the ridge on the plastic
diffuser into the channel at the rear of the xture, working
from one side to the other
5.1
5.2
5.3
5.3