
1. INSTRUCTIONS
2. APPLICATION/USE
3. MAINTENANCE
4. BATTERY REPLACEMENT
2/3 www.rhinomotive.com
• Before using the Digital Tread Depth Gauge, loosen the locking screw. Press the «ON/OFF» button
to power on.
• Select the unit system needed by pressing «mm/inch» button.
• Lay measuring bridge on a flat surface, then push the beam down to make the depth bar contact with the
flat surface
• Press ZERO button
• Tool is now ready for use
• For passenger safety, it is crucial to check the tyre tread depth of any vehicle
• Gauge reads tyre tread depth
• Depth measuring range covering cars, SUVs and a wide range of heavy-duty vehicles
• Do not cleanse the display module with organic solutions.
• Keep this Digital Tread Depth Gauge away from dust, high temperature and radiation.
• Keep this Digital Tread Depth Gauge away from liquid such as water and coolant.
• Never apply any electric pressure on any part of the Digital Tread Depth Gauge
• Avoid bumping or dropping during measurement.
• If the Digital Tread Depth Gauge will not be used for more than 3 months, take out the battery.
• Beware of sharp edges when using the caliper.
• Keep it in the place where children cannot reach.
• Flashing of digits shows a flat battery. Take off the battery cap in the direction shown by the arrow
and replace the battery (positive side facing out)