Rich Green Valley Technology HRM706 User manual

Operation Guide
Exercise Effects in dfferent Heart Rate Zone
Install “nRFready Utility” on your Bluetooth
Smart Ready device(iPhone 4S, iPhone 5,etc)
This HRM is compatible with many apps running on Bluetooth Smart Ready devices.
Below is a demo pairing with iPod touch,using Nordic nRFready Utility.
Select “Bluetooth Smart” menu bar.
Enable “Wildcard” in the settings, then select
the “CONNECT” to find your BLE Heartrate
Monitor
Now your heart beat shows on your
Apple device
Bluetooth Smart Fabric Chest Belt
Model: HRM706
User Manual
the HRM-706 water resistant fabric chest belt is equipped with
the latest Bluetooth Smart technolongy to achieve reliable
thansmission linkage with sports system device that is with
the logo Bluetooth and corresponding application.
OVERVIEW
WEARING THE CHEST BELT
front view
back view
Snap buttons
Snap buttons
Battery compart
Conductive pads
HEART RATE DETECTOR BELT STRAP
The chest belt counts your heartbeat and transmits the data.
1.Align the heart rate detecotor unit with the snap buttons on the belt strap.
Secure by snapping into place.
2.unfasten the belt strap.
3.Wet the conductive pads on the underside of the chest belt with a few
drops of water or conductive gel to ensure solid contact.
4.Position the heart rate detector unit below your chest, while making sure
logo is the right way up. Wrap the strap around your chest and fasten into
place.
To ensure an accurate heart rate signal, adjust the strap until the belt sits
snugly below your pectoral muscles.
Tips
.The position of the chest belt affects its performance.
.Avoid areas with dense chest hair.
.In dry, cold climates, it may take several minutes for the chest belt to function
steadily. This is normal and should improve with several minutes of exercise.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.