richard Solo TY002 User manual

Thank you for purchasing the RichardSolo 12000 mAh Portable Jump Starter / Air Pump / Power Bank.
Please read these instructions before operation and save for future reference.
12000 mAh Portable
Jump Starter / Air Pump /
Power Bank
Model: TY002
INSTRUCTION MANUAL
Inflator connector port
EC5 jumpstart socket
USB-A output port
USB-C input port
LED flashlight / SOS flasher
LCD screen
Power (ON/OFF)
Preset (+)
Preset (-)
Unit switch / LED
Mode switch
USB-C / USB-A charge cable (not shown)
Intelligent jumpstart cables with built-in LED safety module
Air inflator hose with connector for vehicle tires
3 Inflator hose adapters (ball needle, mattress nozzle, bike
tire connector)
Storage case (not shown)
1
1
7
712
2
2
8
813
13
3
3
9
914
14
4
4
10
10 15
15
5
5
11
11
16
6
6
Battery Layout Included Parts/Accessories
Connect included USB charge cable (12) to any 5V/2A*
USB power source (not included)
Connect USB-C connector to USB-C input port (3) on
power bank
LCD charge icon (6) on power bank will flash and show
% of charge in power bank
When fully charged (100%) LCD shuts off — Remove
charge cable
Charge 12000 mAh Power Bank
Note: Use 5V/2A for best results. Less than 2A will require a longer charge time. For optimum performance, wait until flashing charge icon on LCD
shuts off to ensure full charge capacity. Total charge time (0 - 100%) = about 6 hours.
1
2
3
4

Page 2
Press/hold power button (7) for 3 seconds
LCD (6) shows remaining charge capacity 0 -100%
Press/hold power button for 3 seconds to shut off
LCD shuts off automatically in 60 seconds if no buttons are pushed
Connect intelligent jump start cables (13) to EC5 jump start socket (2)
Flashing RED/BLUE LED indicators on jump start cable module =
system is working properly
Press/hold jump start power button 3 seconds to power on
Make sure vehicle battery terminals are free from rust, dirt, and corrosion
Connect RED cable clamp to positive (+) battery terminal on vehicle
Connect BLACK cable clamp to negative (-) battery terminal on vehicle
Look for GREEN LED indicator on module and start vehicle immediately within 30 seconds
When motor starts, remove clamps immediately from battery terminals
• For best performance when starting vehicles, use Jump Starter at 30% charge capacity
or higher.
• DO NOT connect jump start cable clamps to wrong +/- battery terminals — RED = (+)
positive / BLACK = (-) negative
• DO NOT connect jump starter RED/BLACK cable clamps together
• Make sure Jump Start cable clamps are connected securely to battery terminals
• Always remove clamps within 30 seconds after motor starts
• Check battery terminals for rust, dirt, and corrosion before using Jump Starter — clean
if necessary to avoid poor performance
• DO NOT jump start again after 3 attempts to avoid damaging Jump Starter — check for
other vehicle issues
• Short circuit
• Over-current output
• Low voltage limits
• Reverse polarity
• Overheating
• Over voltage limits
• Overcharging
• Overload
• Dimensions: 6.5" x 3.9" x
1.95" (164.5 x 99 x 49.5mm)
• Weight: 1.68 lb (0.76 kg)
• Capacity: 12,000 mAh
• Cell Type: Li-polymer battery
• Type-C input: 5V/2A
• USB output: DC 5V/2A
• Start current: 600A
• Peak current: 1000A
• Air-pump power:
0-150 PSI (max)
• Inflation efficiency: 20L/Min
• Inflator speed: 15 minutes
— Tires up to 17” (0-100%)
• Operating temperature:
-4~140 degrees F (-20~60C)
• Storage temperature:
-4~140 degrees F (-20~60C)
• USB-C / USB-A charge cable
length: 20” (50.8 cm)
• Jump start cable length:
12" (30.5 cm)
• Inflator hose length:
12" (30.5 cm)
• Full charging time:
About 6 hours
• Nylon storage case: 9" x 5" x
4" (23 x 12.7 x 10.16 cm)
• 12000 mAh Jump Starter /
Air Pump / Power Bank
• USB-C / USB-A charge cable
• Inflator hose
• Inflator adapters (3)
• Jumpstart cable
• Storage case
• Printed instructions
Check remaining power bank capacity
Jump-start instructions
Notes for jump starting 12V vehicle batteries
Includes 8 protection characteristics
for safe jumpstarts
Specifications
Package Contents
1
1
2
2
3
4
3
4
5
6
7
8
12000 mAh Portable Jump Starter / Air Pump / Power Bank Model: TY001
Questions? Please email us at: [e-mail]
2301 Kerner Blvd. Suite C, San Rafael, CA 94901, USA www.RichardSolo.com

Page 3
Connect air inflator hose (14) to inflator connector port (1) on top panel of power bank
Connect opposite end of air inflator hose to air valve on vehicle tire ensuring all connectors are tight and completely aligned
Press/hold ON/OFF air pump switch (7) for 3 seconds to activate air pump
Press Mode switch (11) - select car icon
*Tap Unit/LED (10) - select PSI
Tap Preset increase (+) (8) or Preset decrease (-) (9) to set desired PSI amount
Tap ON/OFF (7) to add air
Current pressure shows on LCD as vehicle tire fills to preset PSI level
When preset level is reached, pump shuts off automatically - Remove air inflator hose
• Compatible with vehicles having inflatable wheels less than 5 tons GVW (Gross Vehicle Weight)
*Select from 4 different units for air pressure measurement: PSI - Bar - Kpa - Kg/cm²
Connect inflator hose (14) to inflator connector port (1)
Connect to tire — ensure all connections are secure
Connect inflator hose (14) to inflator connector port (1)
Securely connect appropriate adapter (15) for the application
Press power switch (7) ON
Press Mode switch (11) - select bicycle or ball icon
Tap Unit/LED (10) — select PSI
Tap Preset increase (+) (8) or Preset decrease (-) (9) to set
desired PSI amount
Tap ON/OFF (7) to add air
Current pressure shows on LCD as item fills to preset PSI
level
When preset level is reached, pump shuts off automatically -
Remove air inflator hose
Press power switch (7) to ON
Press MODE switch (11) — current tire air pressure appears on LCD
Air Pump instructions for vehicle tires:
Air Pump Applications
How to check tire air pressure
Inflating balls, air mattresses, bike tires, etc.
1
1
1 7
3
2
2
2 8
3
9
4
5
6
4
3
4
5
6
7
8
9
12000 mAh Portable Jump Starter / Air Pump / Power Bank Model: TY001
Additional notes:
•For smoother connections with tire valves, apply a small amount of
spray lubricant (WD-40, etc.) to inner threads of connector on air
inflator hose.
•During periods of heavier use, air pump may automatically pause
30-60 seconds after pressing power button to allow pump motor to
cool. Caution: Metal parts may become hot.
•Attach inflator hose adapters (15) to air inflator hose for balls, air
mattresses, bike tires, etc.
Questions? Please email us at: [e-mail]
2301 Kerner Blvd. Suite C, San Rafael, CA 94901, USA www.RichardSolo.com
Air pump can operate in manual or preset mode for automatic inflation. After selecting a mode, you can manually adjust the pressure to fit the
application.
4 Preset Modes: Car, Motorcycle, Bicycle, Basketball

Page4
Connect USB charge cable to USB-A (5V-2A) port (4) on power bank
Connect cable to your device
Press/release power ON/OFF switch (7)
Monitor charge via charge icon or LED on device
Backlit LCD shows remaining power bank capacity while charging devices
When device reaches 100%, remove cable
If cable is not removed, power bank will continue to safely trickle-charge device
Connect included USB charge cable (12) to any 5V/2A USB power source (not included)
Connect USB-C connector to USB-C input port (3) on power bank
LCD charge icon (6) on power bank will flash and show % of charge in power bank
Connect USB device to USB-A output port (4)
Monitor device’s charge status on its own screen or LED indicators
Device and power bank charge simultaneously
Press power ON (7) — LCD illuminates
Press/hold LED button (10) for 2 seconds – LED flashlight illuminates
Tap LED button (10) — LED SOS/strobe flashes
Tap LED button (10) — LED shuts off
Press power OFF (7) — LCD shuts off or shuts off automatically in 60 seconds
Note: When power bank is fully charged (LCD = 100%) — connected device continues to recharge. When device is fully charged, power bank
shuts off automatically.
Charge USB-C smartphones, tablets, etc. using included cable (12)
or use appropriate USB cable included with your device
Tandem charging
Built-in LED flashlight / SOS safety flasher
1
1
1
2
2
2
3
3
3
4
4
4
5
5
5
6
6
7
12000 mAh Portable Jump Starter / Air Pump / Power Bank Model: TY001
Questions? Please email us at: [e-mail]
2301 Kerner Blvd. Suite C, San Rafael, CA 94901, USA www.RichardSolo.com