Richmond Claudia User manual

Wall-Mounted Hair Dryer

Thank you very much for becoming a user of our products, which
will bring convenience and pleasure to you in coming days.
This series Wall Mounted Hair Dryer focuses on safety,
convenience and power-saving with modern streamline shape,
shows smart combination of Scientific and aesthetics, It's
installation method is amazing because it can be installed on wall,
It's a ideal choice for hair-drying in hotel and family.
Features:
1. Characterized with a general power switch to allow this unit be
power off when is not in using.
2. Two heatings and cool shot.
3. Slightly press on the spring button to turn on and work,
release that switch to turn off.
1. dryer body
2. holder
3. slide switch
4. power button
5. spring button
6. chrome

Warning:Don't install the hairdryer in the places easy wet.
How to install this unit with plug connected wire:
1. Loosen the screw which on the bottom of the dryer holder ,
disassemble the front cover(picture 3)
2. Drill 4 holes of 6mm diameter and depth of 35mm on the
wall then insert the plastic toggles into the holes according
to picture 2 and fix the bracket on the wall with the 4 screws
enclosed
3. Fix the front cover to the bracket then screwing the screw
on the bottom to make the bracket and front cover tightly
4. Connect with general power and move power switch to
"ON"position
How to install this unit without plug-connected wire:
1. Loosen the screw which on the bottom of the dryer holder,
disassemble the front cover
2. Pull the reserved wire through the hole show in picture 2 (there
are three holes are available for the direct wiring ).
3. Fix the reserved wire on terminal,please notice its direction of
N,L wire replace terminal to its original
4. Fix the bracket to the wall then fix the front cover to the
bracket screwing the screw on the bottom to make the bracket
and front cover tightly
5. Turn on general power and move power switch to ON" position.

How to use:
Switch on general power and pick up the dryer body, the dryer will
work when the spring button is held on, move the push button up
and down for higher or lower heating. " 1 " for hot heating, " 2 " for
warm heating " c " for cool shot.
Notes:
1. Ensure the voltage of hair dryer is same with the power supply.
2. Please follow the below safety frameworks when you operate
the hair dryer. Don't operate the hair dryer when your hands
are wet.Don't pull out the combined cord. Don't let the man
who don't know how to operate the hair dryer operate it alone
except monitored by man.
3. Clean and keep hair dryer
Please pull out the power plug from electrical outlet when you
cleaning the hair dryer. Please pay attention the hair dryer to
avoid absorbing in the inlet of hair dryer. Please use the
cleaning solution of water with soap to clean the housing of
hair dryer, don't use spray liquid or abrasive.
We don't responsible for any danger things if you don't follow
the above instructions.
Parts in the package:
one set hair dryer
one manual
Accessories:
four piece of screws
four piece of goggles