Riedel RiFace User manual

Riedel Communications GmbH & Co. KG |Uellendahler Str. 353 |42109 Wuppertal |Germany www.riedel.net
21.01.2013 |Rev 0.2
Slide the radio in the rack and plug7.
the audio cables (left cable faces left,
right cable faces right).
Turn the top plate to the back side2.
and unplug the grounding connector
from the grounding terminal on the
top plate.
Unplug carefully both audio cables3.
from the PCB connector.
Remove both screws of the4.
connector PCB.
Slide the locking PCB in the notch of5.
the radio connector.
Plug the connector PCB on the radio6.
connector and x it on the locking
PCB.
Remove the 13 screws on the top.1.
This guide describes the steps to install the radios in the RiFace rack.
A T10 Torx driver and a 4mm hexagon driver are required for the assembly.
All different radio types are mounted in the same way. Only the connectors can vary in type.
Following table shows the different RiFace versions with the compatible radios.
RiFace Radios
1550200 RiFace G2 GM360 Simplex
1550210 RiFace G2 GM360 Duplex
Motorola
GM360/GM340/CM360/Pro5100/CDM1550
1550220 RiFace G2 CM300 Simplex
1550230 RiFace G2 CM300 Duplex
Motorola
CM300/CM340/CM360
1550240 RiFace G2 DM3400 Simplex
1550250 RiFace G2 DM3400 Duplex
Motorola
DM3400/DM3600/XPR4550
1550260 RiFace G2 MTM700 Simplex
1550270 RiFace G2 MTM700 Duplex
Motorola
MTM700/MTM800
1550280 RiFace G2 MTM800e Simplex
1550290 RiFace G2 MTM800e Duplex
Motorola
MTM800e
RiFace Installation Guide

Riedel Communications GmbH & Co. KG |Uellendahler Str. 353 |42109 Wuppertal |Germany www.riedel.net
21.01.2013 |Rev 0.2
Plug the grounding connector on14.
grounding terminal on the top plate.
Fix the top plate with the 13 screws.15.
Check the TXext Jumper 13.
(closer informations can be found in
the RiFace manual)
... that the radios are placed at the11.
back end.
Fix both antenna cables with a 12.
cable tie.
Fix the radios with screws on the 10.
right and left side in the middle,
upper notch in that way, ...
Plug the antenna cable in the radio9.
(upper cable to left, lower cable to
right).
Plug the power cable in the radio8.
(rear cable to left, front cable to
right).
RiFace Installation Guide