RIGHT ANGLE 310CPU User manual

Version Dated: 4/15/16
Read all the instructions before beginning.
K&A Manufacturing
Hardware Pack # 51907 Page1 OF 3Instruction # 52611
6703 Zinser Street
Schofield, WI 54476
Phone: [phone]
Fax: [phone]
www.raproducts.com
310CPU Holder

.
2
4
Left Leg Assembly
5
1
Step 1: Measure the height of your CPU and
determine the height at which you want the bottom
of your CPU.
Step 2: Raise the workstation to its highest level.
Raise the column cover as high as it will go. Tape
it in place if necessary.
Step 3: Insert (2) socket screws 5through the holes
on CPU holder Assembly B 1and thread them into the
holes on a weld nut 4. Do not fully tighten.
Step 4: Slide the weld nut 4into the groove at the
front of the left leg assembly on your workstation.
Slide it to the height you determined in Step 1 and
fully tighten the socket screws 5
Column Cover
5
Page 2 OF 3
K&A Manufacturing
6703 Zinser Street Schofield, WI 54476
Phone: [phone]
Fax: [phone]
www.raproducts.com
Tools Required for Assembly:
Power Driver W/Adjustable Torque
3/16" Hex Head Driver Bit or
Allen Wrench
Tape Measure
Hardware Pack # 51907 Drawn Actual Size
ITEM # PART # DESCRIPTION QTY.
1 8001 310CPU Holder Assembly B 1
2 800224 310CPU Holder Support Bracket 2
3 8001 5 310CPU Holder Assembly A 1
4 529 3 5/1 -18 Weld Nut 4" CL'S 2
5 53 38 5/1 -18 x 3/8 Button Head Socket Screw 4
Instruction # 52611
53638 52963
4

2
www.raproducts.com
Phone: [phone]
.
6703 Zinser Street Schofield, WI 54476
tightly against the side of the
. Slide Assembly A
onto the top of the CPU. Slide the support
bracket
5
Fax: [phone]
Page 3 OF 3
CPU. Fully tighten the socket screws
K&A Manufacturing
Step 5: Place your CPU onto CPU holder
Assembly B 1and slide the support
bracket 2tightly against the side of your
CPU.
Step 6: Repeat Steps 3 and 4 with CPU
Holder Assembly A 3
Note: To mount the CPU holder on the
right leg assembly, reverse the locations
of CPU Holder Assembly A 3and CPU
Holder Assembly B 1.
2
3
4
4
Instruction # 52611