RightHand RHSTGRK User manual

Tool Storage Rack
MODEL # RHSTGRK
Thank you for purchasing the Right Hand™ Tool Storage Rack. This User Guide is intended to provide you with guidelines to ensure
that operation of this product is safe and does not pose risk to the user. Any use that does not conform to the guidelines described
in this User Guide may void the limited warranty.
Please read all directions before using the product and retain this guide for reference. This product is intended for household use only.
This product is covered by a limited one-year warranty. Coverage is subject to limits and exclusions. See warranty for details.
INSTALLATION INSTRUCTIONS
NOTE: The two racks included may be used together or separately.
1. Locate studs in the wall if applicable, e.g., if installing on drywall.
2. Using a level, mark a horizontal line on the wall. The line you make will
indicate the position of the bottom of the rack.
3. Position the rack with the bottom against the line so
that the top is facing up, as shown (A).
4. Move the rack so that the mounting holes are lined up
with the wall studs, if applicable, and then mark the
location for the screws with a pencil (B).
Top
Level Line
Bottom
24 in.
(60.96 cm)
16 in.
(40.64 cm)
12 in.
(30.48 cm) 12 in. (30.48 cm)
Top
Bottom
A
B

QUESTIONS OR PROBLEMS? CONTACT US!
[e-mail] | 1-833-665-2121
SAFETY PRECAUTIONS
• The fasteners and anchors supplied with this tool rack are intended for use with brick and/or concrete walls only. If you are fastening this rack to a timer or a
plasterboard wall, make sure to use the appropriate fasteners.
• Always use appropriate care when working with mounting hardware and tools.
• Do not overload the rack or else it may damage the product and/or the mounting surface.
REGARDING SELECTION OF FASTENERS
While standard fasteners and anchors intended for use with concrete and/or brick walls are included with this storage rack, it remains the responsibility of the
person installing the storage rack to determine which fastener type should be used for each specific installation and/or type of substrate. Please ensure that
appropriate pullout tests are performed prior to installation.
If you are unsure about what type of mounting hardware you should use, please ask a professional for assistance. In no event shall Right Hand be liable for any
direct, special, punitive, exemplary, indirect, or consequential damages resulting from improper installation, misuse, and/or use of the product beyond its limitations
and/or intended purpose. This includes, without limitations, overloading of the product and/or use of the product under extreme or abnormal conditions, either
intentionally or as a result of user error.
5. Fasten the rack into place using either the included fasteners or the appropriate fastener for the material on which the rack is
being installed.
6. Mount the storage hooks on the rack by sliding them in from either end of the rack (C).
Right Hand is a trademark of C&A IP Holdings, LLC, in the U.S.
All other products, brand names, company names, and logos are trademarks of their respective owners, used
merely to identify their respective products, and are not meant to connote any sponsorship, endorsement, or approval.
Distributed by C&A Marketing, Inc., 114 Tived Lane East, Edison, NJ 08837. Made in China.
© 2019. C&A IP Holdings, LLC. All Rights Reserved.
C