Robert Abbey PEEK User manual

ASSEMBLY INSTRUCTIONS FOR YOUR
PEEK FLOOR LAMP
599
ASSEMBLY INSTRUCTIONS:
NOTE: Do not connect electricity until lamp is fully assembled.
1. Unpack all parts and remove packing materials. Place lamp base on a level
surface.
2. Install one 60W max., type A, medium base bulb into the socket (C).
3. Slide glass (B) over socket (C) until it sits securely inside column (D).
4. Slide shade (A) over glass (B). Please note, shade will t over glass in two
dierent ways. Fig. 1 on the following page illustrates glass shown. Fig. 2
illustrates glass covered, resulting in uplight only. Flip shade to achieve desired
look.
5. Remove protective plastic from plug (E).
6. Insert plug (E) into wall outlet.
7. Control power to lamp by lightly touching column (D).
IMPORTANT SAFETY INSTRUCTIONS:
* This lamp has a polarized plug (one blade is wider than the other) as a feature to
reduce the risk of electric shock. This plug will t in a polarized outlet only one
way. If it does not t fully in the outlet, reverse the plug. If it still does not t,
contact a qualied electrician. Do NOT alter the plug.
* Do not use with an extension cord unless the plug from the lamp can be fully
inserted into the extension cord receptacle.
* Switch power o and remove plug from the wall outlet before replacing the bulb.
* This lamp is UL rated for dry locations.
(A)
(B)
(C)
(D)
(E)
**To clean, use a soft cloth only. Do not use any chemical or abrasive cleaners.** Page 1 of 2

ASSEMBLY INSTRUCTIONS FOR YOUR
PEEK FLOOR LAMP
599Page 2 of 2
Figure 1 Figure 2