Robit V7S Pro User guide

Quick Operation Guide
Robit V7S Pro
Robot Vacuum Cleaner
Attention Before Use
Please neatly arrange desks, chairs and household appliances to prevent the robot
getting stuck during cleaning.
Please do not stand in such narrow areas as doorways and aisles in case the robot
fails to clean these areas.
The messy power cords, toys and other objects on the floor may entangle the robot,
please kindly organize them.
Remove the white protective strip and the transparent protective film on the infrared
front bumper before using. Otherwise, the robot may not work properly.
Charging the Robot
Preparation before charging
Before installing the charging base, remove the protective film on the charging
Base, and wipe the installation ground till clean.
1
English

Place the charging base on a hard, level surface and against the wall. Remove objects
within 3ft/ 1m of the left and right side and within 6ft/ 2m of the front charging base.
Please do not place objects with strong reflecting surfaces around the charging base,
such as mirrors.
1. Charge the robot directly with a power adapter.
2. Ensure the charging base is plugged in, and the robot in standby state, press the
recharge button on the remote control or press the start-stop button of the robot for 3-5
seconds, the robot will return to charge automatically.
Charging mode
*Turn on the side power switch on the robot (1 for power on, 0 for power off)
*The green light turns on, the robot is activate.
*When the orange light is breathing, the robot is charging.
*When the green light is solid, the charging is completed.
*You can charge your robot in the following ways:
Install the side brushes properly.
2

Start-cleaning
Press the start-stop button on the robot or on the remote control to start auto
cleaning mode. During the auto cleaning process, the robot automatically
perceives the missing area and then makes up intelligently.
During the working process, the robot will carry out route planning independently.
Moved by human or remote control, the robot will redesign the route and clean up the
area that have been cleaned.
In order to ensure efficiency, please do not move the robot at will.
The robot will stop for a short time in the process of working(calculating and planning
the areas that need to be made up for cleaning or the path planning).
Please wait patiently, and the time of pauses depends on the complexity of the indoor
environment.
Turn on/ Turn off
When the robot is working, press the start-stop button or button on remote control,
and then the robot will stop working.
If the robot in standby mode for more than 2 minutes, it will go into the inactive state. If
you want to activate it again, press the start-stop button of the robot. It can also be
activated by remote control.
AUTO
AUTO
3
AUTO

After finished cleaning, turn the power switch in the side of the robot to “0”. The
indicator goes off and robot is power off.
【This guide is not a substitute for instructions. Please refer to
instructions if you need to learn further details and guidelines.】
4