Rockler 48089 User manual

1
24" x 36" Steel Stand Leg
Set Assembly Instructions
PARTS list - Steel Stand Leg Set Quantity
1 32" Legs 4
2 351⁄2" x 2" Long Stretchers 4
3 231⁄2" x 2" Short Stretchers 4
4 Leveling Feet 4
5 5/16"-18 Bolts 32
6 5/16"-18 Nuts 32
1111
2
2
2
2
3
3
3
3
4
44
4
6
5

2
Install the Levelers
Remove the top hex nut from each of the leveling feet;
insert the levelers through the holes in the square base of
each of the legs. Then replace the hex nut you removed
using a 3/4" wrench.
Stand Assembly
1. Begin assembling your stand by attaching two
351⁄2" x 2" Long Stretchers (2) to two of the 32"
Legs (1). Be sure that the stretchers are oriented
with the lip at the top and are attached to the inside
edge of the legs.
Note: Use just one 5/16"-18 Bolt (5) and one
5/16"-18 Nut (6) to start, using the square hole
closest to the inside corner of the legs. Leave
the adjacent hole open for now.
2. Repeat step 1 with the remaining 351⁄2" x 2" Long
Stretchers (2) and the remaining 32" Legs (1).
48089
Rev 4/14
Distributed by Rockler Companies, Inc.
©2014 Rockler Woodworking and Hardware
3. Lay one of the assemblies you have just completed
 ontheoorandattachallofthe231⁄2" x 2" Short
Stretchers (3) to the 32" Legs (1), still just using
one 5/16"-18 Bolt (5) and one 5/16"-18 Nut (6) with
the square hole closest to the inside corner of the legs.
4. Carefully lay the second assembled side of the stand
on top of the four outstretched side stretchers you just
attached. Again, use one 5/16"-18 Bolt (5) and one
5/16"-18 Nut (6) with the square hole closest to the
inside corner of the legs.
5. Stand your completed steel stand upright and use a
square to check all of your angles. Adjust the angles to
90° where needed. Using a 1/2" socket, install the
remaining bolts and nuts and tighten.
32
3
2
1
1
1
2
1
2
3
3
4
44
4