Rovin GH2258 User manual

INSTRUCTION MANUAL
GH2258
30L Portable
Cooler/Warmer

1
IMPORTANT:
Thank you for purchasing the ROVIN Cooler/Warmer. Please read the
Caution section and instructions below carefully and familiarise yourself
with the product before use. As with all electrical items, please exercise
extreme caution during use and take care not to misuse or damage the
product which could result in injury.
CAUTION:
• Before use, check that the cables, plugs and casings are undamaged.
• DO NOT use if any parts are damaged or worn.
• DO NOT use in the rain, or other wet or damp conditions.
• DO NOT handle if your hands are wet.
• DO NOT obstruct the air ow to the unit. The ventilation slots must be kept
clear for the unit to work properly and prevent dangerous overheating.
• DO NOT place the unit in direct sunlight or an enclosed space where
ventilation is restricted, or where there are other heat sources.
• Avoid using in areas where the supply cable may become a trip hazard.
• As with all electrical equipment, keep away from children and animals.
• Only use with a 12V DC (negative earth).
• When using the coolbox with the 12V DC supply, the plug will become
warm during use. Ensure that the vehicle socket is clean and clear of debris,
and the electrical contact is good to avoid the plug/socket overheating.
• Take care when removing the plug from the 12V DC socket and DO
NOT touch the metal contacts which may be hot.
• Unwind the required supply cable fully before use. DO NOT use whilst
this cable is coiled as this can cause overheating of the cable.
• This coolbox is only intended for keeping foodstuffs cool. It is not
recommended or intended for medicines or chemical storage.
• This coolbox is intended for temporary in-vehicle, camping,
caravanning and leisure use. It is not a fridge designed for permanent
installation and should not be used as such.
• NEVER ll the unit with water or ice. DO NOT immerse the unit in water.
• Disconnect the unit whilst the vehicle’s engine is not running to prevent
the vehicle battery becoming excessively drained or at. When the
vehicle is running, the alternator should provide enough power.
• To maximise the cooling effect when the unit is disconnected, keep the lid closed.
• Take care when manoeuvring or lifting the coolbox as it may be heavy
when fully loaded. Only lift if it is within your own physical capabilities.
• NEVER pull the plugs out of sockets using the cable, or pull on the
cables to manoeuvre the coolbox.

2
USE & OPERATION:
CLEANING & STORAGE:
GENERAL ADVICE:
This unit is only suitable for vehicle and leisure use and should not
be used in industrial conditions where dirt may be drawn into the
unit. It must not be used in damp or wet conditions and under no
circumstances must it be exposed to rain. The coolbox can only be
repaired by a qualied electrician.
1. Load the coolbox with your food and drink in suitable containers.
To obtain the best performance from your coolbox, it is
recommended that these items are already cold. The addition of
any substantial amount of food at room temperature will slow the
cooling performance.
2. Select the power supply according to your requirements. 12V DC
(negative earth) plug and power cord for use in a vehicle. Note:
The vehicle ignition may have to be turned on to supply the
coolbox with power.
3. Place the coolbox on a rm, at surface in the desired location
using the fold out handles and wheels to pull along, manoeuvre
and lift.
4. Fully extend the power cable required and plug in.
5. The cooling performance is similar to that of a household fridge
(NOT a freezer). The temperature inside the coolbox will be
lowered to about 18°C below that of the surrounding (ambient) air.
The additional warming temperature is 50-65ºC.
6. After use, disconnect the electrical supply.
1. Disconnect the electrical supply.
2. Carefully wind up the cable and store in the convenient cable
storage compartment provided.
3. The coolbox surfaces can be wiped clean using a cloth with mild
detergent solution.
4. The coolbox should not be cleaned using running water or by
immersing in water. Abrasive cleaning materials should also be
avoided.
5. When not in use the coolbox lid should be left ajar to prevent
mould growth.

3
TROUBLESHOOTING:
If the unit does not appear to function correctly, unplug the unit and
check the following:
FAULT POSSIBLE CAUSE SUGGESTED REMEDY
The coolbox
doesn’t turn
on (DC plug is
inserted; LED on
the plug does not
glow).
There is no electrical
power from the
12V socket in your
vehicle.
The vehicle ignition might
need to be switched on.
The coolbox
doesn’t turn on
(mains plug is
inserted).
There is no electrical
power from the
mains socket.
Try using another mains
socket and check the fuse
in the plug. Replace fuse if
necessary.
The coolbox
doesn’t cool (plug
is inserted, LED
on the DC plug
glows).
The fan or the
cooling
element may be
defective.
This can only be repaired by
a qualied electrician.
The vehicle ignition
is on and the
coolbox is not
working or keeps
switching off
(DC plug is
inserted, LED
on the plug is
not glowing
or not glowing
continuously)
The 12V socket is
dirty or debris is
present. This results
in a poor electrical
contact.
If the plug of the coolbox
becomes very warm or hot
in the 12V socket, either the
socket is not clean or the
plug has not been inserted
correctly into the socket.
Remove dirt and debris from
the plug and/ or socket
using a non metallic tool.
The plug has not
been inserted
properly into
the socket, poor
electrical contact.
Pull plug out gently from the
socket and re-insert rmly.
Repeat the operation until
the proper position is
found & the plug is aligned
securely in the socket.
The fuse of the 12V
plug has blown.
Replace the fuse (8A) in the
12V plug by unscrewing the
tip.
The vehicle fuse has
blown.
Replace the vehicle’s fuse
that protects the 12V socket
(usually 15A). Please refer to
the owner’s manual for the
vehicle.

4
TROUBLESHOOTING:
TECHNICAL SPECIFICATION:
There is water
inside the coolbox
Moisture in the air,
trapped inside the
cooler, condenses
due to the low
temperature.
This is not a product
fault; the inner of the
cooler is not ventilated.
Dry the condensed water
periodically.
There is ice
formation near the
inner ventilation
slots
Moisture in the air,
trapped inside the
cooler, is condensed
to water and freezes
in contact with the
cooling plate. Ice
formation can block
the ventilator and
damage the unit.
This is not a product fault.
Switch the unit off and let
the
ice melt. Remove gently and
check the unit periodically
for ice formation.
FAULT POSSIBLE CAUSE SUGGESTED REMEDY
Capacity (L) 30 L
Unladen Weight (kg) 6.4Kgs
Exterior Dimensions (cm) Length: 47.2cm
Height: 43.7cm
Width: 32.8cm
Input Voltage Requirement (V) 12 Volt DC
Current Draw (A) With 12V DC supply 3.5A
Power Consumption (W) 42 Watts
Refrigeration system type Thermoelectric with interior and
exterior fan
Insulation Material High quality full foam insulation
of polyurethane, CFC-free
Case Material Polypropylene
Power cord length 12V 2.3 metres (approx.)

5
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF
ELECTRICAL & ELECTRONIC EQUIPMENT:
This mark on a product and/or accompanying documents indicates
that when it is to be disposed of, it must be treated as Waste Electrical
& Electronic Equipment (WEEE).
Any WEEE marked waste products must not be mixed with general
household waste, but kept separate for the treatment, recovery and
recycling of the materials used.
For proper treatment, recovery and recycling; please take all WEEE
marked waste to your Local Authority Civic waste site, where it will be
accepted free of charge.
If all consumers dispose of Waste Electrical & Electronic Equipment
correctly, they will be helping to save valuable resources and
preventing any potential negative effects upon human health and the
environment, of any hazardous materials that the waste may contain.
Please keep these instructions for future reference.

6

Distributed by:
Electus Distribution Pty. Ltd.
320 Victoria Rd, Rydalmere
NSW 2116 Australia
www.electusdistribution.com.au
Made in China