
FRESCAPURE™3
REPLACING THE FILTER CARTRIDGE
3. Remove the plastic wrap from new Cartridge
and place in Filter Base. Hold Filter Base
securely while inserting Cartridge into Filter
Housing and thread Filter Base clockwise
onto Filter Housing until tight. DO NOT
over-tighten.
4. Lower the Shower Wand into tub, direct at drain,
and turn water “On”. Allow System to flush for
at least 5 minutes or until water runs clear.
5. Inspect System for leaks at connections. If leak is detected, refer to the
Troubleshooting section of this manual.
6. Turn shower “Off” and return Shower Wand to Filter Housing and align.
IMPORTANT
Allow System to flush directly into the
drain until water runs clear. This will remove any fine,
black carbon particles left over from the manufacturing
process, expel trapped air, and condition the Cartridge
for normal use. This procedure should be repeated
each time a new Cartridge is installed.
TROUBLESHOOTING
CONDITION: Water leaks at Collar or Hose connections.
REASON: Filter Housing may not be properly attached or Gasket may
be missing or damaged.
SOLUTION: If leak occurs after initial install, detach connection where leak
is present and inspect Gasket. If Gasket appears normal, make sure it is fully
seated then reconnect. If Gasket is damaged, contact your Independent
Royal Prestige Distributor or the Royal Prestige Customer Service Center.
CONDITION: A noticeable reduction in the water pressure is detected.
REASON: Mineral build-up on rubber nozzles.
SOLUTION: Rub your hand over rubber nozzles to remove mineral build-up.
Alternatively, remove Shower Wand and soak in household vinegar.
CONDITION: System leaks between Filter Housing and Filter Base.
REASON: Missing or damaged O-ring. (There should be two O-rings on the
Filter Base and one O-ring on the Filter Cartridge.)
SOLUTION: Replace O-ring(s).