Rubine VULCAN Series User manual

ELECTRIC HOB
VULCAN series
VELOCE series
VALIDO series

2
CONTENTS:
Part 1. Safety Warnings
Part 2. Installation
Part 3. Operation Instructions
Part 4. Cleaning and Maintenance

3
Congratulations on the purchase of your
new hob and thank you for choosing us!
Please read all the safety instructions
carefully before use and keep this
Manual for future reference.
Part 1. Safety Warnings
Safety Warnings
Your safety is important to us. Please
read below information carefully before
installing or using your Hob.
Installation
Electrical Shock Hazard
•Disconnect the appliance from the main
electricity supply before carrying out any work
or maintenance on it.
•Connection to good earth wiring system is
essential and mandatory.
•Alterations to the domestic wiring system
must only be made by a qualified electrician.
•Failure to follow this advice may result in
electrical shock or death.

4
Panel Hazard
•Take care - panel edges are sharp.
•Failure to use cautiously could result in
injury or cuts.
Important safety instructions
•Read these instructions carefully before
installing or using this appliance.
•No combustible material or products should
be placed on this appliance at any time.
•Please make this information available to
the person responsible for installing the hob.
•In order to avoid a hazard, this appliance
must be installed according to these
instructions.
•This appliance is to be properly installed by a
qualified person.
•This appliance should be connected to a
circuit which incorporates an isolating switch
providing full disconnection from the power
supply.
•Failure to install the appliance correctly
could void any warranty or liability claims.

5
Operation and maintenance
Electrical Shock Hazard
•Do not cook on a broken or cracked hob. If
the hob surface should break or crack, switch
the appliance off immediately at the main
power supply (wall switch) and contact a
qualified technician.
•Switch the hob off at the wall switch before
cleaning or maintenance.
•Failure to follow this advice may result in
electrical shock or death.
Health Hazard
•This appliance complies with
electromagnetic safety standards.
•However, person with cardiac pacemakers
or other electrical implants (such as insulin
pumps) must consult with their doctor or
implant manufacturer before using this
appliance to make sure that their implants
will not be affected by the electromagnetic
field.
•Failure to follow this advice may result in
death.

6
Hot Surface Hazard
•During use, accessible parts of this
appliance will become hot enough to cause
burns.
•Do not let your body, clothing or any item
other than suitable cookware contact with
the ceramic glass until the surface is cold.
•Beware: Metallic objects such as knives,
forks, spoons and lids should not be placed
on the hob surface since they can get hot.
•Keep away from children.
•Handles of saucepans may be hot to touch.
Check saucepan handles do not overlap
other cooking zones that are on. Keep
handles out of reach of children.
•Failure to follow this advice could result in
burns and scalds.
Blade Hazard
•The razor-sharp blade of a hob scraper is
exposed when the safety cover is retracted.
Use with extreme care and always store safely
and out of reach of children.
•Failure to use caution could result in injury
or cuts.

7
Important safety instructions
•Never leave the appliance unattended when
in use. Over boiled causes smokes and greasy
spillovers that may ignite.
•Never use your appliance as a work table or
storage surface.
•Never leave any objects or utensils on the
appliance.
•Do not place or leave any magnetisable
objects (e.g. credit cards, memory cards) or
electronic devices (e.g. computers, MP3
players) near the appliance, as they may be
affected by its electromagnetic field.
•Never use your appliance for warming or
heating the room.
•After use, always turn off the cooking zones
as described in this manual. Do not rely on the
pan detection feature to turn off the cooking
zones when you remove the pans.
•Do not allow children to play with the
appliance or sit, stand, or climb on it.
•Do not store items of interest to children in
cabinets above the hob. Children climbing on
the hob could be injured.
•Do not leave children alone or unattended in

8
the area where the appliance is in use.
•Children should have guardian to assist if
they wish to use the appliance (we strongly
recommend not to allow children to use the
appliance for their safety). Besides, for
disabled personnel, he/she must fully
competent to use the appliances at its own
risk & responsibility.
•Do not repair or replace any part of the
appliance unless specifically recommended in
the manual. All other servicing should be done
by a qualified technician.
•Do not use steam cleaner to clean hob.
•Do not place or drop heavy objects on hob.
•Do not stand on your hob.
•Do not use pans with jagged edges or drag
pans across the ceramic glass surface as this
can scratch the glass.
•Do not use scourers or any other harsh
abrasive cleaning agents to clean your hob,
as these can scratch the ceramic glass.
•If the power supply cable is damaged, it
must only be replaced by qualified technician.
•This appliance is intended to be used in
household and similar applications such as:
-staff kitchen areas in shops, offices and

9
other working environments; -farm houses;
-by clients in hotels, motels and other
residential type environments; -bed and
breakfast type environments.
•This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning usage
of the appliance in a safe way and
understand the hazards involved. Children
shall not play with the appliance. Cleaning
and maintenance shall not be made by
children without supervision.
•WARNING: Unattended cooking on a hob
with fat or oil can be dangerous and may
result in fire. NEVER try to extinguish a fire
with water, but switch off the appliance and
then cover flame e.g. with a lid or a fire
blanket.

10
Part 2. Installation
Installation Instructions
The appliance must be installed and connected in
accordance with current regulations.
After unpacking the appliance, ensure there is no
visible damage. If it has been damaged during transit,
DO NOT USE, contact where you buy immediately.
Selection of installation equipment
-Cut out the work surface according to the sizes shown in the drawing.
-For the purpose of installation and use, a minimum of 5 cm space shall
be preserved around the hole.
-Be sure the thickness of the work surface is at least 30mm. Please select
heat-resistant work surface material to avoid larger deformation caused
by the heat radiation from the hotplate. As shown below (measure by
unit: mm):
Model
L
W
H
D
A
B
X
RCE-VULCAN30-BL
288
520
52
48
265+5
-0
495+5
-0
50 min
RIH-VELOCE35-BL
288
520
56
52
265+5
-0
495+5
-0
50 min
RCE-VULCAN52-BL
590
520
52
48
555+5
-0
495+5
-0
50 min

11
RIH-VELOCE58-BL
590
520
56
52
555+5
-0
495+5
-0
50 min
RCE-VULCAN40-BL
RIH-VELOCE44-BL
RCH-VALIDO44-BL
RCE-VULCAN44-BL
730
430
58
54
705+5
-0
405+5
-0
50 min
RCH-VALIDO53-BL
590
520
58
54
555+5
-0
495+5
-0
50 min
Installing the foam gasket
Before inserting the hob into the opening on the kitchen worktop, the supplied
foam gasket (in a plastic bag) must be attached to the lower side of the ceramic
glass.
Do not install the hob without the foam gasket!
The gasket should be attached to the hob in the
following method:
▪Remove the protective film from the gasket.
▪Then attach the gasket to the lower side of the glass, next to the edge.
▪The gasket must be attached along the entire length of the glass edge and
should not overlap at the corners.
▪When installing the gasket, make sure that the glass does not come into contact
with any sharp objects.
Under any circumstances, make sure the electric hob is well ventilated and the air
inlet and outlet are not blocked. Ensure the electric hob is in good work state. As
shown below:
Note: The safety distance between the hotplate and the cupboard above
the hotplate should be at least 760mm.

12
A(mm)
B(mm)
C(mm)
D
E
760mm
50mm minimal
20mm minimal
Air intake
Air exit 5mm
Before locating the fixing brackets
The unit should be placed on a stable, smooth surface (use the packaging). Do not
apply force onto the controls protruding from the hob.
Easy Fit kits
There is one easy fit kits package for each hob, include fixing clips and screws (for
ceramic hob total 2pcs clip and 2pcs screw, for induction hob total 4pcs clip and
4pcs screw). Find the easy fit kit package first.
Fix clips to hob: Insert the fixing clips into fixing holes reserved on 2 sides of
housing, fix clip to housing with screw, then insert hob into cabinet/work surface.
Fix hob to cabinet: Insert the hob into the cabinet/work surface as below
diagrams, the mounted clips on the sides can secure your hob sturdily.

13
Connecting the hob to the mains power supply
The power supply should be connected in compliance with the relevant standard,
or a single-pole circuit breaker. The appliance has a large power rating and
must be connected to electricity by a Qualified Electrician.
Notes:
1. If the cable is damaged or needs replacing, this should be done by technician
using the proper tools, so as to avoid any accidents.
2. If the appliance is being connected directly to the mains supply, an omni polar
circuit breaker must be installed with a minimum gap of 3mm between the
contacts.
3. The installer must ensure that the correct electrical connection has been made
and that it complies with safety regulations.
4. The cable must not be bent or compressed.
5. The cable must be checked regularly and only replaced by qualified technician.
Cautions
1. The hob must be installed by qualified personnel or technicians. Please
never conduct the operation by yourself.
2. The electric hob shall not be mounted to cooling equipment, dishwashers and
rotary dryers.
3. The electric hob shall be installed such that better heat radiation can be ensured
to enhance its reliability.
4. The wall and induced heating zone above the work surface shall withstand heat.
5. To avoid any damage, the in between layer and adhesive must be heat
resistant.
6. Steam cleaner is not to be used for cleaning.
7. This electric hob can be connected only to a supply with system impedance not
more than 0.427 ohm. In case necessary, please consult your supply authority
for system impedance information.

14
The method of connections shown below.

15
Part 3. Operation Instructions
Product Overview
Model: RCE-VULCAN30-BL
Control Panel
1.1800W Cooking Zone
2. 1200W Cooking Zone
3. Glass plate
4. Control panel
1
2
3
4
1. Cooking Zone selection button
2. Timer control button
3. Child Lock control button
4.Stop & Resume control button
5. Heating level/Timer “-” button
6. Heating level/Timer “+” button
7. ON/OFF button
1
2
3
4
5
6
7

16
Model: RCE-VULCAN40-BL
Control Panel
4
5
6
1
3
4
5
2
6
7
2
4
5
2
6
3
7
1.1800W Ceramic Zone
2. 2200/1100W Ceramic Dual Zone
3. Ceramic Glass
4. Control panel of cooking zone#1
5. Timer control
6. Control panel of cooking zone#2
1. Extended zone control button
2. Stop & Resume control button
3.Timer control “-” button
4. Heating level/Timer “-” button
5. Heating level/Timer “+” button
6. Child Lock control button
7. ON/OFF button
1
3

17
Model: RIH-VELOCE44-BL
Control Panel
1. 2000W booster 2200W induction Zone
2. 2000W booster 2200W induction Zone
3. Ceramic Glass
4. Control panel of cooking zone#1
5. Control panel of cooking zone#2
1
2
4
7
3
5
6
1.Booster function control button
2. Stop & Resume control button
3. Timer control button
4. Heating level/Timer “-” button
5. Heating level/Timer “+” button
6. Child Lock control button
7. ON/OFF button
1
3
2
4
5

18
Model: RIH-VELOCE58-BL
Control Panel
1. 1500W Cooking Zone
2. 2000W Cooking Zone
3. 2300W Cooking Zone
4. Glass plate
5. Control panel
1. Cooking zone/timer Icon
2. Stop & Resume control button
3. Heating level/Timer “-”/ “+”button
4. Child Lock control button
5. ON/OFF button
4
3
5
1
2
4
2
5
3
1

19
Model: RCH-VALIDO44-BL
Control Panel
Induction Hob Ceramic Hob
1.Booster/Extend zone control button
2. Stop & Resume control button
3. Timer control button
4. Heating level/Timer “-” button
5. Heating level/Timer “+” button
6. Child Lock control button
7. ON/OFF button
1
3
2
4
5
1
2
4
6
7
3
5
1
2
4
6
7
3
5
1. 2000W booster 2200W induction Zone
2. 2200/1000W Ceramic Dual Zone
3. Ceramic Glass
4. Control panel of cooking zone#1
5. Control panel of cooking zone#2

20
Model: RIH-VELOCE35-BL
Control Panel
1
2
3
4
1. 2000W Cooking Zone
2. 1500W Cooking Zone
3. Glass plate
4. Control panel
1
1. Cooking Zone selection button
2. Heating level/Timer “-” button
3. Heating level/Timer “+” button
4. Child Lock control button
5. ON/OFF button
6. Stop & Resume control button
7. Timer control button
8.
2
3
4
5
6
7