Rudeco Play MOUNT EVEREST User manual

Rudeco A/S •Rødvej 6, Bursø • 4930 Maribo • Tlf. [phone]
[email protected] • www.rudeco.dk
|RPK 512 |
|MOUNT EVEREST |
Included instructions Page: Included instructions Page: Included instructions Page:
Steps for mounting 0,1 - 0,2 Digging plan 1,0 Mountainplate 4,3
Slide tubes 5,4 Swing along beam 6,4 Turning log 6,7
Angled net 7,1 Horizontal rope 7,2 Vertical net 7,3
Vertical rope 7,4 Vertical bar 8,2 Climbing plate 8,3
Beam & Handlist 9,2

Rudeco A/S •Rødvej 6, Bursø • 4930 Maribo • Tlf. [phone]
[email protected] • www.rudeco.dk 0,1
| STEPS FOR MOUNTING |
| RPK 512 |
1
2
3
4
5
6
7
8
9
1,0 Digging plan / Floor
2,1 Floor
7,2 Horizontal rope
6,7 Turning log
9,2 Beam and handlist
6,4 Swingalong beam
8,2 Vertical bar—3 pcs.
8,3 Climbing plate
Layout on playground area

Rudeco A/S •Rødvej 6, Bursø • 4930 Maribo • Tlf. [phone]
[email protected] • www.rudeco.dk 0,2
| STEPS FOR MOUNTING |
|RPK 512 |
10
11
12
13
14
15
7,3 Vertical net
7,1 Angled net
4,3 Mountain plate 5,4 Slide tubes
7,4 Vertical rope

Rudeco A/S •Rødvej 6, Bursø • 4930 Maribo • Tlf. [phone]
[email protected] • www.rudeco.dk 1,0
| DIGGING PLAN |
|RPK 512 |
|POSTS: M9ST150 - M9ST210 |
Tip:
Place the floor on the ground at the desired location, and mark where to
dig.
Dig holes ø30cm for the posts, in 70cm depth. Keep in mind that the zero-
mark has to be placed in level with the ground.
For other holes: Take a look at the corresponding instructions.
Place the posts in holes, fill in soil, and stomp thoroughly . Repeat until all
the holes are filled.
If necessary, use concrete in holes.
5CM
1 00:20 23,0 kg
M9GUGA
Tip:
Be precise with the height of the floor. Impetus goal
of zero-point mark to the top side of floor.
(Take a look at the front page of this folder)
Other parts depends on the location of the floor.
Rotate the floor acording to the items to be moun-
ted at it.
1 00:15 21,5 kg
M9GUGAE
Mark Item Pcs. / Floor Item no.
A Fr. screw 8 X 90 8 41055
B Washer 8/24 8 41011
1 00:30 9,4 kg
M9ST150
1 00:30 11,0 kg
M9ST210

Rudeco A/S •Rødvej 6, Bursø • 4930 Maribo • Tlf. [phone]
[email protected] • www.rudeco.dk
|MOUNTAIN PLATE |
|M9BB120 - M9BB240 |
4,3
Tip:
Align the top of the handlist with the top of the floor.
Align the bottom of the mountain plate with the bottom of the
posts.
Use amount of screws according to table.
Mark Item Pcs. Item no.
A Screw 6 x 80 4 41067
B Screw 6 x 60 41066
C Decorative washer 41016
A+C
B+C
180
210
240
Align with the
top of the floor.
Align with
the bottom
of the posts.
A+C
B+C
1 00:30 24,7 kg
M9BB180
1 00:30 28,7 kg
M9BB210
2 00:30 33,5 kg
M9BB240
1 00:25 20,3 kg
M9BB150
1 00:25 16,0 kg
M9BB120
120
10
150
12
180
14
210
16
240
18
120
14
150
16
180
18
210
20
240
22

Rudeco A/S •Rødvej 6, Bursø • 4930 Maribo • Tlf. [phone]
[email protected] • www.rudeco.dk 5,4
|SLIDE TUBES |
|M9BSR |
Tip:
Center the Slide tubes between the posts.
Dig 25 x 100cm in required depth for ground lug.
1 01:10 24,5 kg
Mark Item Pcs. Item no.
A Fr. Screw 8 x 90 4 41055
B Washer 8/24 8 41011
C Screw M8 x 50 4 41110
D Secure Nut M8 4 41001
50cm
80-90cm

Rudeco A/S •Rødvej 6, Bursø • 4930 Maribo • Tlf. [phone]
[email protected] • www.rudeco.dk 6,4
|SWING ALONG BEAM |
|M9AG090 - M9AG180 |
Tip:
Distance between posts = 90cm / 180cm.
To be mounted 2,1 to3 meters above the ground.
1 00:15 1,5 kg
M9AG090
Mark Item Pcs. Item no.
A Fr. Screw 8 x 90 4 41055
B Washer 8/24 4 41011
A+B
210—300cm
90 cm /
180 cm
1 00:15 3,0 kg
M9AG180

Rudeco A/S •Rødvej 6, Bursø • 4930 Maribo • Tlf. [phone]
[email protected] • www.rudeco.dk 6,7
|TURNING LOG |
|M9RB270 |
Tip:
Distance between posts = 270cm.
To be mounted in level with the floor.
2 00:30 24,0 kg
M9RB270
Mark Item Pcs. Item no.
A Fr. Screw 8 x 90 16 41055
B Washer 8/24 16 41011
C Screw 6 x 60 8 41066
A+B
75 - 77cm
70 - 75cm
A+B
C
Place the beam inside or outside
the posts, according to other
parts, mounted on the posts.

Rudeco A/S •Rødvej 6, Bursø • 4930 Maribo • Tlf. [phone]
[email protected] • www.rudeco.dk 7,1
|ANGLED NET |
|M9SN120 - M9SN180 |
120cm
150cm
180cm
80-90cm
Mark Item Pcs. Item no.
A Fr. Screw 8 x 90 4 41055
B Washer 8/24 4 41011
C U-Clamp 4 41108
D Screw 4 x 25 20 41134
E Decorative washer 24 41016
F Screw 6 x 80 4 41067
Tip:
Mount the beam, and center the angled net between two posts.
Dig hole for securing the net in 60cm depth.
Mount the U-clamps, fill in some soil, and stomp throughly.
Repeat until the hole is filled.
1 00:45 31,0 kg
M9SN120
1 00:45 39,5 kg
M9SN180
C+D+E
Cut 8 x 50mm at the backside of
the beam for the HPL plate if
necessary.
A+B
E+F
DIST
DIST PART
110 cm M9SN120
160 cm M9SN180

Rudeco A/S •Rødvej 6, Bursø • 4930 Maribo • Tlf. [phone]
[email protected] • www.rudeco.dk 7,2
|HORIZONTAL ROPE |
|M9AGT171 |
|M9AGT270 |
Tip:
Distance between posts = 180cm or 270cm.
Remember to always keep a minimum distance of 23 cm.
Mark Item Pcs. Item no.
A Screw 6 x 60 4 41066
B Cup square neck bolt M6 x 60 4 41117
C Cap nut M6 4 41100
D Washer 6/15 4 41006
80-90cm
30-60cm
M9AGT171
1 00:15 3,0 kg
3cm
40cm
Min. 23cm
B+C+D
A
A
B+C+D
M9AGT270
1 00:15 4,5 kg

Rudeco A/S •Rødvej 6, Bursø • 4930 Maribo • Tlf. [phone]
[email protected] • www.rudeco.dk 7,3
|VERTICAL NET |
|M9N090 - M9N180 |
Mark Item Pcs. Item no.
A Screw 6 x 60 24/30 41066
B Fr. Screw 8 x 90 4 41055
C Washer 8/24 4 41011
Tip:
Mount the beam as shown, and center the vertical net between
posts.
Mount the net with screws 6x60 180cm
A
B+C
198cm
A
1 00:15 33,3 kg
M9N180WB
1 00:20 14,5 kg
M9N090WB
Sample shown is M9N180WB

Rudeco A/S •Rødvej 6, Bursø • 4930 Maribo • Tlf. [phone]
[email protected] • www.rudeco.dk 7,4
|VERTICAL ROPE |
|M9RS - M9KNT - M9KTR |
Mark Item Pcs. Item no.
A Screw 4 X 25 5 41134
B Decorative washer 5 41016
C Screw 6x60 4 41066
D Screw 6x100 1/2 41068
Tip:
Align the ropes for M9KNT and M9KTR
with equal distance between each other.
Fasten to the beam with screws (A+B)
1 00:30 7,9 kg
M9RS
1 00:30 3,0 kg
M9KNT
A+B
A+B
½
1 00:30 3,5 kg
M9KTR
½
Tip: Center the rope ladder between two posts.
C
Tip:
Dig 25 x 50 cm in required depth for ground
lug, and secure the rope with screw (D).

Rudeco A/S •Rødvej 6, Bursø • 4930 Maribo • Tlf. [phone]
[email protected] • www.rudeco.dk 8,2
|VERTICAL BAR |
|M9RL120 - M9RL150 - M9RL180 |
Tip:
Center the screws in the
middle of the posts.
120cm
150cm
180cm
1 00:15 5,1 kg
M9RL120
1 00:20 7,6 kg
M9RL180
Mark Item Pcs. Item no.
A Fr. Screw 8 x 90 4 / 6 41055
B Washer 8/24 4 / 6 41011
C Screw 6 x 80 4 41067
D Decorative washer 4 41016
A+B
80-90cm
C+D
1 00:18 6,3 kg
M9RL150
Min 23cm

Rudeco A/S •Rødvej 6, Bursø • 4930 Maribo • Tlf. [phone]
[email protected] • www.rudeco.dk 8,3
|CLIMBING PLATE |
|M9K120 - M9K210 |
Mark Item Pcs. Item no.
A Fr. Screw 8 x 90 6 41055
B Washer 8/24 6 41011
C Fr. Screw 8 x 40 6 41052
1 01:00 24,5 kg
M9K090
1 01:00 28,5 kg
M9K120
1 01:00 34,0 kg
M9K150
1 01:00 37,6 kg
M9K180
1 01:00 42,8 kg
M9K210 120cm
80-90cm
DIST
81cm
A+B
C+B
DIST PART
32 cm M9K090
43 cm M9K120
53 cm M9K150
65 cm M9K180
75 cm M9K210
Tip:
Align the top of climb-up plate with over side of
the floor.
Dig ø30 in 65cm depth for support steels. Use the
correct ”DIST” as described.
Fill in soil, and stomp thoroughly when the positi-
on is correct.

Rudeco A/S •Rødvej 6, Bursø • 4930 Maribo • Tlf. [phone]
[email protected] • www.rudeco.dk
| BEAM & HANDLIST|
| M9VA090 - M9VA270 - M9STT090 |
9,2
Mark Item Pcs. Item no.
A Screw 8 X 90 4/6 41055
B Washer 8/24 4/6 41011
1 00:08 1,5 kg
M9VA090
1 00:08 2,9 kg
M9VA180
1 00:12 4,3 kg
M9VA270
Mark Item Pcs. Item no.
C Screw 6 x 80 4 41067
D Decorative washer 4 41016
1 00:08 1,0 kg
M9STT090
Tip:
Use hand list where no activities are mounted.
Where slide bars, ropes e.g. are mounted, you
have to use beams.
Keep in mind that the minimum distance between
two beams are 23cm. Else you have to mount the
beams with less than 8,5cm between each other.
M9VA090
M9STT090
C+D
A+B
80-90cm
80-90cm