Rukket 10X6 PORTABLE GOLF NET User manual

WHAT’S INCLUDED
A: Carry Bag
B: Fiberglass Pole
C: Metal Stakes
D: Golf Net
E: HittingTarget
10X6 PORTABLE GOLF NET
QUESTIONS? GIVE US A CALL! (1-855)-478-5538
V1
Please call us if you have any questions or concerns at 1-855-4RUKKET
Please read our product safety warnings before setup
Our video instructions provide the best guidance for setting up your 10X6 Portable Golf Net.
They can be viewed online at
A
B
C
D
E

10X6 PORTABLE GOLF NET
ASSEMBLY INSTRUCTIONS
QUESTIONS? GIVE US A CALL! (1-855)-478-5538
V1
Prior to each use
• Please use adult supervision and follow the instructions when setting up and using the net.
• Regular use or abuse will eventually strain the netting and may break it, as well as extended
exposure to outdoor elements will eect the lifetime of the net.
• Do not stand behind the net.
• This net is not intended for personal protection.
• Target must be used, as the netting will break without it.
• Inspect the netting and frame for damage or wear. If damage or wear is found, do not use net until new
netting can be used so the balls do not break through the net. Replacement nets can be purchased at
Rukket.com
• Make sure the frame and net are assembled correctly and on a at surface, at least ten (10) feet from
structures and vehicles.
• The user should be positioned directly in front of the net(at least 10-12 feet to avoid injury of ball rebound).
• Failure to follow these precautions could result in serious injury or damage to property.
• Important to use in grass and important to stake it down. Do not allow product to blow around or scrape on
hard ground or rough surfaces as it could damage the product.
1. Remove all products from carry bag and lay
out on at, clean, smooth surface. NOTE: Do
not lay on rough or cluttered surface or the golf
tent could be damaged.
2. Lay tent out on lawn with the solid green
fabric surface directly on the lawn and the
white webbing on top. Slide rst piece of
berglass pole into corner sleeve and continue
to push through the sleeve, assembling the
berglass pole as you push it through the
sleeve. The pole should exit the sleeve near
the top center of the tent. Feed the pole into
the sleeve diagonally across from the sleeve
the pole has just exited and continue to feed
the pole through the sleeve until it comes out
at the opposite corner that you started at.
Repeat for the second pole.
Product Safety Warning

10X6 PORTABLE GOLF NET
ASSEMBLY INSTRUCTIONS
QUESTIONS? GIVE US A CALL! (1-855)-478-5538 V1
4. Put the little pins in the corner of the tent
into the berglass poles. This will cause the
golf tent to stand up and take shape. Be careful
when you put the pins into the holes as this
will require some exing of the poles. Letting
go of the pole before the pin is inserted could
cause the pole to suddenly straighten. Be
careful as you insert the pin into the hole as
your nger could be pinched between the pin
and pole.
3. If outdoors, take metal stakes and fasten
them to the net by inserting one prong through
the metal ring. Repeat for the 4 corners of the
net and insert each corner into the ground.
Note: Net can be used without stakes indoors
and outdoors if not windy.
5. Once the tent has been set up and staked in
the 4 corners through the small metal loop,
(not shown in instructions), hang the target
inside the tent by placing the toggle button
through the loops in the four corners.
6. Complete!