Rukket Sock It! Lite User manual

Please use adult supervision and follow the instructions
when setting up and using this net. Regular use or abuse
will eventually strain the netting and may break it. Do not
stand behind the net. This net is not intended for personal
protection. This net deflects fast moving objects, so people
should be at least ten (10) feet away.
Prior to Use: Inspect the netting and frame for damage or
wear. Make sure the frame and net are assembled correctly
and on a flat surface, at least ten (10) feet away from
structures and vehicles. The user should be positioned
directly in front of the net. Failure to follow these precautions
could result in serious injury or damage to property.
7X7 SOCK IT! LITE STAKE-DOWN BASEBALL / SOFTBALL NET
ASSEMBLY INSTRUCTIONS
QUESTIONS? GIVE US A CALL! (1-855)-478-5538
V1
RukketSports
Our video instructions provide the best guidance for setting up your Sock It! Baseball/Softball Net.
They can be viewed online at
1. Lay out net at on the
ground red velcro tab
closest to you.There should
be sleeves on the left and
right. Note: Red velcro tab
used for orientation
purposes only
2. Slide middle bar piece
into the receiving pole
across from the angled pole
insert sections.
3. Set out the two base
pieces so they are in line
with the sleeves of the net.
Stake down the pieces
through the vertical holes.

6. Repear with sleeve pocket
over other black rod.
7. Take black rod and slide into
lower rod’s coupling tube.
8. Hold black rod while pulling
sleeve up. Loop white cord
over rod top.
9. Take the last black rod
and slide into rod coupling
tube.
10. Grip black rod and pull
sleeve up. Loop cord over
pole top.
11. Take lower elastic loops
and place under stud on
both end legs. Wrap velcro
around frame.
QUESTIONS? GIVE US A CALL! (1-855)-478-5538
V1
5. Thread sleeve over black
ride. Make sure logo is not
upside down.
7X7 SOCK IT! LITE STAKE-DOWN BASEBALL / SOFTBALL NET
ASSEMBLY INSTRUCTIONS
4. Install the lower black
rods with coupling tubes
up, into angled pipes.